| 1. |
- Mao, Xufeng, et al.
(författare)
-
Polyethylene separator activated by hybrid coating improving Li+ ion transference number and ionic conductivity for Li-metal battery
- 2017
-
Ingår i: Journal of Power Sources. - : Elsevier. - 0378-7753 .- 1873-2755. ; 342, s. 816-824
-
Tidskriftsartikel (refereegranskat)abstract
- Low Li+ ion transference number is one fatal defect of the liquid LiPF6 electrolyte for Li-metal anode based batteries. This work aims to improve Li+ ion transference number and ionic conductivity polyethylene (PE) separators. By a simple dip-coating method, the water-borne nanosized molecular sieve with 3D porous structure (ZSM-5) can be coated on PE separators. Especially, the Li+ ion transference number is greatly enhanced from 0.28 to 0.44, which should be attributed to the specific pore structure and channel environment of ZSM-5 as well as the interaction between ZSM-5 and electrolyte. Compared with the pristine PE separator, the ionic conductivity of modified separators is remarkably improved from 0.30 to 0.54 mS cm(-1). As results, the C-rate capability and cycling stability are both improved. The Li-metal battery using the ZSM-5-modified PE separator keeps 94.2% capacity after 100 cycles. In contrast, the discharge capacity retention of the battery using pristine PE is only 74.7%.
|
|
| 2. |
- Ding, Bangfu, et al.
(författare)
-
Oxygen Vacancy Effect on Photoluminescence Properties of Self-Activated Yttrium Tungstate
- 2014
-
Ingår i: The Journal of Physical Chemistry C. - : American Chemical Society (ACS). - 1932-7447 .- 1932-7455. ; 118:44, s. 25633-25642
-
Tidskriftsartikel (refereegranskat)abstract
- A series of single-phase yttrium tungstate powders were synthesized through solid-state reaction under air or argon atmosphere. All powders showed broad band emission in the visible light region, and the argon-calcined samples presented strong near-infrared luminescence. Moreover, the long-wave excitation bands peaking at 340, 378, 380, 490, and 523 nm depended critically on the calcination atmosphere and temperature. The emergence of these new excitation bands was ascribed to different oxygen vacancy concentrations with the analysis of the first-principle calculation, Raman and X-ray absorption fine structure spectra. The oxygen vacancies caused the reduction of the average coordination number of tungsten, and the position of the localized energy band changed with the oxygen vacancy concentration. Finally, a schematic photoluminescence excitation model was proposed via anion and cation charge transfer. The obtained results promise to be very useful in interpreting self-activated tungstate luminescence mechanism. They can also serve as guide line for tuning the luminescence performance of yttrium tungstate and related materials.
|
|
| 3. |
- Kozhevnikov, Evgeny, et al.
(författare)
-
A dual-transduction-integrated biosensing system to examine the 3D cell-culture for bone regeneration
- 2019
-
Ingår i: Biosensors & bioelectronics. - : ELSEVIER ADVANCED TECHNOLOGY. - 0956-5663 .- 1873-4235. ; 141
-
Tidskriftsartikel (refereegranskat)abstract
- Three-dimensional (3D) cell cultures developed with living cells and scaffolds have demonstrated outstanding potential for tissue engineering and regenerative medicine applications. However, no suitable tools are available to monitor dynamically variable cell behavior in such a complex microenvironment. In particular, simultaneously assessing cell behavior, cell secretion, and the general state of a 3D culture system is of a really challenging task. This paper presents our development of a dual-transduction-integrated biosensing system that assesses electrical impedance in conjunction with imaging techniques to simultaneously investigate the 3D cell-culture for bone regeneration. First, we created models to mimic the dynamic deposition of the extracellular matrix (ECM) in 3D culture, which underwent osteogenesis by incorporating different amounts of bone-ECM components (collagen, hydroxyapatite [HAp], and hyaluronic acid [HA]) into alginate-based hydrogels. The formed models were investigated by means of electrical impedance spectroscopy (EIS), with the results showing that the impedances increased linearly with collagen and hyaluronan, but changed in a more complex manner with HAp. Thereafter, we created two models that consisted of primary osteoblast cells (OBs), which expressed the enhanced green fluorescent protein (EGFP), and 4T1 cells, which secreted the EGFP-HA, in the alginate hydrogel. We found the capacitance (associated with impedance and measured by EIS) increased with the increases in initial embedded OBs, and also confirmed the cell proliferation over 3 days with the EGFP signal as monitored by the fluorescent imaging component in our system. Interestingly, the change in capacitance is found to be associated with OB migration following stimulation. Also, we show higher capacitance in 4T1 cells that secret HA when compared to control 4T1 cells after a 3-day culture. Taken together, we demonstrate that our biosensing system is able to investigate the dynamic process of 3D culture in a non-invasive and real-time manner.
|
|
| 4. |
- Maimaiti, Nazhakaiti, et al.
(författare)
-
Cervical musculoskeletal disorders and their relationships with personal and work-related factors among electronic assembly workers
- 2019
-
Ingår i: Journal of Safety Research. - : PERGAMON-ELSEVIER SCIENCE LTD. - 0022-4375 .- 1879-1247. ; 71, s. 79-85
-
Tidskriftsartikel (refereegranskat)abstract
- Introduction: Electronics assembly workers are reported to have a high prevalence of musculoskeletal disorders (MSDs). This study investigated the prevalence of cervical MSDs and the complex relationships between cervical MSDs and individual, physical, psychosocial factors among electronics assembly workers. Methods: In this cross-sectional survey, self-administered questionnaires from 700 workers in electronics manufacturing workshops were analysed. Information concerning musculoskeletal symptoms, personal and work-related factors was collected. Finally, the prevalence of cervical MSDs was computed for different subgroups, and the relationships with different factors were analyzed using logistic regression and structural equation modeling (SEM). Results: The total 12 month prevalence of cervical MSDs among the survey population was 29.4%. Variables of gender, job tenure, twisting head frequently, neck flexion/extension for long time and work required to be done quickly showed significant associations with MSDs in a multivariate logistic regression (P < 0.05). The SEM analysis showed moderate and significant correlations between postural load (gamma = 0.279), gender (gamma = 0.233) and cervical MSDs, while there were weak but significant correlations between vibration (gamma = 0.024), work stress (gamma = 0.126), job tenure (gamma = 0.024) and cervical MSDs. Both work stress and vibration affected the MSDs indirectly through postural load. Conclusions: The logistic regression results support previous general epidemiological MSD studies, and indicates that individual, physical, and psychosocial factors are related to cervical MSDs. The SEM provides a better approximation of the complexity of the relationship between risk factors and cervical MSDs. Improving awkward postures may be effective ways to control the influence of occupational stressors or vibration on MSDs. Practical Applications: The study is to improve prevention of MSDs among electronics assembly workers and promote their occupational health.
|
|
