| 1. |
|
|
| 2. |
|
|
| 3. |
|
|
| 4. |
|
|
| 5. |
- Aad, G., et al.
(författare)
-
Commissioning of the ATLAS Muon Spectrometer with cosmic rays
- 2010
-
Ingår i: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044 .- 1434-6052. ; 70:3, s. 875-916
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS detector at the Large Hadron Collider has collected several hundred million cosmic ray events during 2008 and 2009. These data were used to commission the Muon Spectrometer and to study the performance of the trigger and tracking chambers, their alignment, the detector control system, the data acquisition and the analysis programs. We present the performance in the relevant parameters that determine the quality of the muon measurement. We discuss the single element efficiency, resolution and noise rates, the calibration method of the detector response and of the alignment system, the track reconstruction efficiency and the momentum measurement. The results show that the detector is close to the design performance and that the Muon Spectrometer is ready to detect muons produced in high energy proton-proton collisions.
|
|
| 6. |
|
|
| 7. |
|
|
| 8. |
|
|
| 9. |
|
|
| 10. |
|
|
| 11. |
|
|
| 12. |
|
|
| 13. |
- Aad, G., et al.
(författare)
-
Readiness of the ATLAS Tile Calorimeter for LHC collisions
- 2010
-
Ingår i: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044 .- 1434-6052. ; 70:4, s. 1193-1236
-
Tidskriftsartikel (refereegranskat)abstract
- The Tile hadronic calorimeter of the ATLAS detector has undergone extensive testing in the experimental hall since its installation in late 2005. The readout, control and calibration systems have been fully operational since 2007 and the detector has successfully collected data from the LHC single beams in 2008 and first collisions in 2009. This paper gives an overview of the Tile Calorimeter performance as measured using random triggers, calibration data, data from cosmic ray muons and single beam data. The detector operation status, noise characteristics and performance of the calibration systems are presented, as well as the validation of the timing and energy calibration carried out with minimum ionising cosmic ray muons data. The calibration systems' precision is well below the design value of 1%. The determination of the global energy scale was performed with an uncertainty of 4%.
|
|
| 14. |
|
|
| 15. |
|
|
| 16. |
|
|
| 17. |
|
|
| 18. |
|
|
| 19. |
- Aad, G., et al.
(författare)
-
Studies of the performance of the ATLAS detector using cosmic-ray muons
- 2011
-
Ingår i: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044 .- 1434-6052. ; 71:3
-
Tidskriftsartikel (refereegranskat)abstract
- Muons from cosmic-ray interactions in the atmosphere provide a high-statistics source of particles that can be used to study the performance and calibration of the ATLAS detector. Cosmic-ray muons can penetrate to the cavern and deposit energy in all detector subsystems. Such events have played an important role in the commissioning of the detector since the start of the installation phase in 2005 and were particularly important for understanding the detector performance in the time prior to the arrival of the first LHC beams. Global cosmic-ray runs were undertaken in both 2008 and 2009 and these data have been used through to the early phases of collision data-taking as a tool for calibration, alignment and detector monitoring. These large datasets have also been used for detector performance studies, including investigations that rely on the combined performance of different subsystems. This paper presents the results of performance studies related to combined tracking, lepton identification and the reconstruction of jets and missing transverse energy. Results are compared to expectations based on a cosmic-ray event generator and a full simulation of the detector response.
|
|
| 20. |
- Aad, G., et al.
(författare)
-
The ATLAS Inner Detector commissioning and calibration
- 2010
-
Ingår i: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044 .- 1434-6052. ; 70:3, s. 787-821
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS Inner Detector is a composite tracking system consisting of silicon pixels, silicon strips and straw tubes in a 2 T magnetic field. Its installation was completed in August 2008 and the detector took part in data-taking with single LHC beams and cosmic rays. The initial detector operation, hardware commissioning and in-situ calibrations are described. Tracking performance has been measured with 7.6 million cosmic-ray events, collected using a tracking trigger and reconstructed with modular pattern-recognition and fitting software. The intrinsic hit efficiency and tracking trigger efficiencies are close to 100%. Lorentz angle measurements for both electrons and holes, specific energy-loss calibration and transition radiation turn-on measurements have been performed. Different alignment techniques have been used to reconstruct the detector geometry. After the initial alignment, a transverse impact parameter resolution of 22.1 +/- 0.9 mu m and a relative momentum resolution sigma (p) /p=(4.83 +/- 0.16)x10(-4) GeV(-1)xp (T) have been measured for high momentum tracks.
|
|
| 21. |
- Aad, G., et al.
(författare)
-
The ATLAS Simulation Infrastructure
- 2010
-
Ingår i: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044 .- 1434-6052. ; 70:3, s. 823-874
-
Tidskriftsartikel (refereegranskat)abstract
- The simulation software for the ATLAS Experiment at the Large Hadron Collider is being used for large-scale production of events on the LHC Computing Grid. This simulation requires many components, from the generators that simulate particle collisions, through packages simulating the response of the various detectors and triggers. All of these components come together under the ATLAS simulation infrastructure. In this paper, that infrastructure is discussed, including that supporting the detector description, interfacing the event generation, and combining the GEANT4 simulation of the response of the individual detectors. Also described are the tools allowing the software validation, performance testing, and the validation of the simulated output against known physics processes.
|
|
| 22. |
- Abata, E., et al.
(författare)
-
Study of energy response and resolution of the ATLAS barrel calorimeter to hadrons of energies from 20 to 350 GeV
- 2010
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier. - 0168-9002 .- 1872-9576 .- 0167-5087. ; 621:1-3, s. 134-150
-
Tidskriftsartikel (refereegranskat)abstract
- A fully instrumented slice of the ATLAS detector was exposed to test beams from the SPS (Super Proton Synchrotron) at CERN in 2004. In this paper, the results of the measurements of the response of the barrel calorimeter to hadrons with energies in the range 20-350 GeV and beam impact points and angles corresponding to pseudo-rapidity values in the range 0.2-0.65 are reported. The results are compared to the predictions of a simulation program using the Geant 4 toolkit. (C) 2010 Published by Elsevier B.V.
|
|
| 23. |
- Abramsson, Mia L, et al.
(författare)
-
Charge engineering reveals the roles of ionizable side chains in electrospray ionization mass spectrometry
-
Annan publikation (övrigt vetenskapligt/konstnärligt)abstract
- The role of ionizable side chains in the electrospray ionization mass spectrometry of intact proteins remains hotly debated but has not been conclusively addressed because multiple chargeable sites are present in virtually all proteins. Using engineered soluble proteins, we show that ionizable side chains are completely dispensable for charging under native conditions, but if present, they are preferential protonation sites. The absence of ionizable side chains results in identical charge state distributions under native-like and denaturing conditions, whilst co-existing conformers can be distinguished using ion mobility separation. An excess of ionizable side chains, on the other hand, effectively modulates protein ion stability. We conclude that the sum of charges is governed solely by Coulombic terms, while their locations affect the stability of the protein in the gas phase.
|
|
| 24. |
- Abramsson, Mia L., et al.
(författare)
-
Charge Engineering Reveals the Roles of Ionizable Side Chains in Electrospray Ionization Mass Spectrometry
- 2021
-
Ingår i: JACS Au. - : American Chemical Society (ACS). - 2691-3704. ; 1:12, s. 2385-2393
-
Tidskriftsartikel (refereegranskat)abstract
- In solution, the charge of a protein is intricately linked to its stability, but electrospray ionization distorts this connection, potentially limiting the ability of native mass spectrometry to inform about protein structure and dynamics. How the behavior of intact proteins in the gas phase depends on the presence and distribution of ionizable surface residues has been difficult to answer because multiple chargeable sites are present in virtually all proteins. Turning to protein engineering, we show that ionizable side chains are completely dispensable for charging under native conditions, but if present, they are preferential protonation sites. The absence of ionizable side chains results in identical charge state distributions under native-like and denaturing conditions, while coexisting conformers can be distinguished using ion mobility separation. An excess of ionizable side chains, on the other hand, effectively modulates protein ion stability. In fact, moving a single ionizable group can dramatically alter the gas-phase conformation of a protein ion. We conclude that although the sum of the charges is governed solely by Coulombic terms, their locations affect the stability of the protein in the gas phase.
|
|
| 25. |
- Allard, Erik, et al.
(författare)
-
Comparing capillary electrophoresis : mass spectrometry fingerprints of urine samples obtained after intake of coffee, tea, or water.
- 2008
-
Ingår i: Analytical Chemistry. - : American Chemical Society (ACS). - 0003-2700 .- 1520-6882. ; 80:23, s. 8946-8955
-
Tidskriftsartikel (refereegranskat)abstract
- Metabolomic fingerprinting is a growing strategy for characterizing complex biological samples without detailed prior knowledge about the metabolic system. A two-way analysis system with liquid separation and mass spectrometric detection provides detail-rich data suitable for such fingerprints. As a model study, human urine samples, obtained after intake of coffee, tea, or water, were analyzed with capillary electrophoresis electrospray ionization time-of-flight mass spectrometry (CE−ESI-TOF-MS). In-house-developed software (in Matlab) was utilized to manage and explore the large amount of data acquired (230 CE−MS runs, each with 50−100 million nonzero data points). After baseline and noise reduction, followed by suitable binning in time and m/z, the data sets comprised 9 and 14 million data points in negative and positive ESI mode, respectively. Finally, a signal threshold was applied, further reducing the number to about 100 000 data points per data set. A set of interactive exploratory tools, utilizing principal component analysis (PCA) and analysis of variance (ANOVA) results based on a general linear model, facilitated visual interpretation with score plots (for group assessment) and differential fingerprints (for “hot spot” detection). In the model study highly significant differences due to beverage intake were obtained among the 10 first principal components (p < 10−6 for two of the components in both ESI modes). Especially, the contrasts between “coffee” and “tea or water” indicated several “hot spots” with highly elevated intensities (e.g., for uncharged masses 93, 94, 109, 119, 123, 132, 148, 169, 178, 187, 190, and 193) suitable for further analysis, for example, with tandem MS.
|
|
