| 1. |
|
|
| 2. |
|
|
| 3. |
|
|
| 4. |
- Farnocchia, Davide, et al.
(författare)
-
International Asteroid Warning Network Timing Campaign: 2019 XS
- 2022
-
Ingår i: The Planetary Science Journal. - : Institute of Physics Publishing (IOPP). - 2632-3338. ; 3:7
-
Tidskriftsartikel (refereegranskat)abstract
- As part of the International Asteroid Warning Network's observational exercises, we conducted a campaign to observe near-Earth asteroid 2019 XS around its close approach to Earth on 2021 November 9. The goal of the campaign was to characterize errors in the observation times reported to the Minor Planet Center, which become an increasingly important consideration as astrometric accuracy improves and more fast-moving asteroids are observed. As part of the exercise, a total of 957 astrometric observations of 2019 XS during the encounter were reported and subsequently were analyzed to obtain the corresponding residuals. While the timing errors are typically smaller than 1 s, the reported times appear to be negatively biased, i.e., they are generally earlier than they should be. We also compared the observer-provided position uncertainty with the cross-track residuals, which are independent of timing errors. A large fraction of the estimated uncertainties appear to be optimistic, especially when <0 2. We compiled individual reports for each observer to help identify and remove the root cause of any possible timing error and improve the uncertainty quantification process. We suggest possible sources of timing errors and describe a simple procedure to derive reliable, conservative position uncertainties.
|
|
| 5. |
- Van Den Berg, F. D., et al.
(författare)
-
In-line Characterisation of Microstructure and Mechanical Properties in the Manufacturing of Steel Strip for the Purpose of Product Uniformity Control
- 2016
-
Ingår i: DGZfP-Proceedings BB 158. - 9783940283788
-
Konferensbidrag (refereegranskat)abstract
- The uniformity of the microstructure of steel strip over the entire coil length and between different coils of the same grade is key to stable and consistent material behaviour in steel manufacturers’ proprietary processes, like rolling and levelling, and customers’ processes, like pressing and deep-drawing. In particular for high-strength steels, like dual phase and complex phase steels, the microstructure is very sensitive to processing variations resulting in a potentially larger spread in the mechanical properties of the product. In July 2013, a large European consortium consisting of 15 institutes started an RFCS [1] – funded project called “Product Uniformity Control” (PUC) with the primary objective to achieve enhanced and sustained product uniformity of steel strip by improved interpretation of data from inline measurement methods that aim 2 for real-time and non-destructive characterisation of microstructure and technomechanical parameters. Commonly, these techniques are based on electromagnetic (EM) or ultrasonic (US) measurement principles, which are favoured because of their non-destructive and potentially contact-free nature. To improve the techniques for inline materials characterisation, the PUC consortium takes a systematic approach to investigate the interrelations between mechanical properties -- microstructural parameters -- EM & US properties -- inline measurement thereof. The studies involve dedicated laboratory experiments, modelling of the EM and US properties of steel, modelling of inline measurement setups and statistical analysis of data from inline measurement systems. The synthesis of these activities should result in improved, model-based, calibrations and finally in a broader deployment and integration of the inline material characterisation techniques in steel manufacturing, adding value to the product and enhancing the process efficiency throughout the production chain from hot-rolling to finishing. This paper outlines the project approach, highlights interconnecting modelling and experimental research work, and demonstrates first results. Various contributions being presented at this WCNDT conference originate from the collaborative activities of this PUC project.
|
|
| 6. |
- Farnocchia, Davide, et al.
(författare)
-
The Second International Asteroid Warning Network Timing Campaign: 2005 LW3
- 2023
-
Ingår i: The Planetary Science Journal. - : Institute of Physics (IOP). - 2632-3338. ; 4:11
-
Tidskriftsartikel (refereegranskat)abstract
- The Earth close approach of near-Earth asteroid 2005 LW3 on 2022 November 23 represented a good opportunity for a second observing campaign to test the timing accuracy of astrometric observation. With 82 participating stations, the International Asteroid Warning Network collected 1046 observations of 2005 LW3 around the time of the close approach. Compared to the previous timing campaign targeting 2019 XS, some individual observers were able to significantly improve the accuracy of their reported observation times. In particular, U.S. surveys achieved good timing performance. However, no broad, systematic improvement was achieved compared to the previous campaign, with an overall negative bias persisting among the different observers. The calibration of observing times and the mitigation of timing errors should be important future considerations for observers and orbit computers, respectively.
|
|
| 7. |
|
|
| 8. |
|
|
| 9. |
- Engstrom, C, et al.
(författare)
-
High-temperature stability of epitaxial, non-isostructural Mo/NbN superlattices
- 2000
-
Ingår i: Journal of Materials Research. - 0884-2914 .- 2044-5326. ; 15:2, s. 554-559
-
Tidskriftsartikel (refereegranskat)abstract
- The effect of 1000 degrees C vacuum annealing on the structure and hardness of epitaxial Mo/NbN superlattice thin films was studied. The intensity of superlattice satellite peaks, measured by x-ray diffraction, decreased during annealing while new peaks corresponding to a MoNbN ternary phase appeared. The results are consistent with the Mo-Nb-N phase diagram, which shows no mutual solubility between Mo, NbN, and MoNbN. Even after 3-h anneals and a loss of most of the superlattice peak intensity, the room-temperature hardness was the same as for as-deposited superlattices, The retained hardness suggests that a residual nanocomposite structure is retained even after the formation of the ternary structure.
|
|
| 10. |
- Fredholm, Simon, et al.
(författare)
-
SATB1 in Malignant T Cells
- 2018
-
Ingår i: Journal of Investigative Dermatology. - : Elsevier. - 0022-202X .- 1523-1747. ; 138:8, s. 1805-1815
-
Tidskriftsartikel (refereegranskat)abstract
- Deficient expression of SATB1 hampers thymocyte development and results in inept T-cell lineages. Recent data implicate dysregulated SATB1 expression in the pathogenesis of mycosis fungoides, the most frequent variant of cutaneous T-cell lymphoma. Here, we report on a disease stage-associated decrease of SATB1 expression and an inverse expression of STAT5 and SATB1 in situ. STAT5 inhibited SATB1 expression through induction of microRNA-155. Decreased SATB1 expression triggered enhanced expression of IL-5 and IL-9 (but not IL-6 and IL-32), whereas increased SATB1 expression had the opposite effect, indicating that the microRNA-155 target SATB1 is a repressor of IL-5 and IL-9 in malignant T cells. In accordance, inhibition of STAT5 and its upstream activator JAK3 triggered increased SATB1 expression and a concomitant suppression of IL-5 and IL-9 expression in malignant T cells. In conclusion, we provide a mechanistic link between the proto-oncogenic JAK3/STAT5/microRNA-155 pathway, SATB1, and cytokines linked to CTCL severity and progression, indicating that SATB1 dysregulation is involved in cutaneous T-cell lymphoma pathogenesis.
|
|
| 11. |
- Lindahl, Lise M., et al.
(författare)
-
STAT5 induces miR-21 expression in cutaneous T cell lymphoma
- 2016
-
Ingår i: Oncotarget. - : Impact Journals, LLC. - 1949-2553. ; 7:29, s. 45730-45744
-
Tidskriftsartikel (refereegranskat)abstract
- In cutaneous T cell lymphomas (CTCL), miR-21 is aberrantly expressed in skin and peripheral blood and displays anti-apoptotic properties in malignant T cells. It is, however, unclear exactly which cells express miR-21 and what mechanisms regulate miR-21. Here, we demonstrate miR-21 expression in situ in both malignant and reactive lymphocytes as well as stromal cells. qRT-PCR analysis of 47 patients with mycosis fungoides (MF) and Sezary Syndrome (SS) confirmed an increased miR- 21 expression that correlated with progressive disease. In cultured malignant T cells miR-21 expression was inhibited by Tofacitinib (CP-690550), a clinical-grade JAK3 inhibitor. Chromatin immunoprecipitation (ChIP) analysis showed direct binding of STAT5 to the miR-21 promoter. Cytokine starvation ex vivo triggered a decrease in miR-21 expression, whereas IL-2 induced an increased miR-21 expression in primary SS T cells and cultured cytokine-dependent SS cells (SeAx). siRNA-mediated depletion of STAT5 inhibited constitutive- and IL-2- induced miR-21 expression in cytokine- independent and dependent T cell lines, respectively. IL-15 and IL-2 were more potent than IL-21 in inducing miR-21 expression in the cytokine-dependent T cells. In conclusion, we provide first evidence that miR-21 is expressed in situ in CTCL skin lesions, induced by IL-2 and IL-15 cytokines, and is regulated by STAT5 in malignant T cells. Thus, our data provide novel evidence for a pathological role of IL-2Rg cytokines in promoting expression of the oncogenic miR-21 in CTCL.
|
|
| 12. |
- Zanini, A, et al.
(författare)
-
Monte Carlo simulation of the photoneutron field in linac radiotherapy treatments with different collimation systems
- 2004
-
Ingår i: Physics in Medicine and Biology. - : IOP Publishing. - 1361-6560 .- 0031-9155. ; 49:4, s. 571-582
-
Tidskriftsartikel (refereegranskat)abstract
- Bremsstrahlung photon beams produced by linac accelerators are currently the most commonly used method of radiotherapy for tumour treatments. When the photon energy exceeds 10 MeV the patient receives an undesired dose due to photoneutron production in the accelerator head. In the last few decades, new sophisticated techniques such as multileaf collimators have been used for a better definition of the target volume. In this case it is crucial to evaluate the photoneutron dose produced after giant dipole resonance (GDR) excitation of the high Z materials (mainly tungsten and lead) constituting the collimator leaves in view of the optimization of the radiotherapy treatment. A Monte Carlo approach has been used to calculate,the photoneutron dose arising from the GDR reaction during radiotherapy with energetic photon beams. The simulation has been performed using the code MCNP4B-GN which is based on MCNP4B, but includes a new routine GAMMAN to model photoneutron production. Results for the facility at IRCC (Istituto per la Ricerca e la Cura del Cancro) Candiolo (Turin), which is based on 18 MV x-rays from a Varian Clinac 2300 C/D, are presented for a variety of different collimator configurations.
|
|
