SwePub
Sök i SwePub databas

  Utökad sökning

Träfflista för sökning "WFRF:(Winkelmann Horst) "

Sökning: WFRF:(Winkelmann Horst)

  • Resultat 1-4 av 4
Sortera/gruppera träfflistan
   
NumreringReferensOmslagsbildHitta
1.
  •  
2.
  • Hernandez, Sinuhe, et al. (författare)
  • Influence of temperature on abrasive wear of boron steel and hot forming tool steels
  • 2015
  • Ingår i: Wear. - : Elsevier BV. - 0043-1648 .- 1873-2577. ; 338-339, s. 27-35
  • Tidskriftsartikel (refereegranskat)abstract
    • In many industrial applications the occurrence of abrasive wear results in failure and replacement of components. Examples of these applications are found in mining, mineral handling, agriculture, forestry, process and metalworking industry. Some of these applications also involve operation of relatively moving surfaces at elevated temperatures which increases the severity of wear. A typical example of high temperature wear phenomena is that of tool steels during interaction with boron steel in hot forming. Some studies have been carried out regarding the high temperature tribological behaviour of these materials but results pertaining to their high temperature three body abrasive behaviour have not been published in the open literature. In this work, the high-temperature three body abrasive wear behaviour of boron steel and two different prehardened tool steels (Toolox33 and Toolox44) was investigated using a high temperature continuous abrasion machine (HT-CAT) at different temperatures ranging from 20 °C to 800 °C using a load of 45 N and a sliding speed of 1 ms-1. The wear results were correlated to the hot hardness of the different materials measured by means of a hot hardness tester (HHT) at a load of 10 kgf. Scanning electron microscopy and energy dispersive spectroscopy (SEM/EDS) techniques were used to characterise the worn surfaces. The hot hardness measurements of the three different materials showed a slight but continuous decrease of hardness from room temperature to 600 °C. At temperatures above 600 °C the hardness showed a sharp decrease. The wear rate of Toolox 44 was constant from 20 °C to 400 °C. On the other hand, Toolox33 and boron steel, showed a reduced wear rate from 20 °C to 400 °C attributed to an increased toughness and the formation of wear-protective tribolayers respectively. At higher temperatures (from 400 °C to 800 °C), the wear rate for these materials increased mainly due to a decrease in hardness and the occurrence of recrystallization processes.
  •  
3.
  •  
4.
  •  
Skapa referenser, mejla, bekava och länka
  • Resultat 1-4 av 4

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy