| 1. |
- Hajiannia, I., et al.
(författare)
-
Development of Ultrahigh Strength TRIP Steel Containing High Volume Fraction of Martensite and Study of the Microstructure and Tensile Behavior
- 2018
-
Ingår i: Transactions of the Indian Institute of Metals. - : Springer. - 0972-2815 .- 0975-1645. ; 71:6, s. 1360-1367
-
Tidskriftsartikel (refereegranskat)abstract
- A new transformation induced plasticity (TRIP) steel containing high volume fraction of martensite was produced by austempering heat treatment cycle. Microstructure and tensile properties of this TRIP steel were investigated and compared to those of a dual phase (DP) steel with high martensite volume fraction. Microstructural analysis showed a mixture of ferrite, bainite, retained austenite and about 25–30 vol% of martensite in the TRIP steel. As a result of the strain induced transformation of retained austenite to martensite, the TRIP steel showed a strength elongation balance of 86% higher than that for the DP steel. In comparison to the commercial TRIP780 steel, the current TRIP steel showed a 15% higher ultimate tensile strength value while maintaining the same level of ductility. TRIP steel also had a larger work hardening exponent than DP steel at all strains.
|
|
| 2. |
- Atapour, Masoud, et al.
(författare)
-
Corrosion of Binder Jetting Additively Manufactured 316L Stainless Steel of Different Surface Finish
- 2020
-
Ingår i: Journal of the Electrochemical Society. - : The Electrochemical Society. - 0013-4651 .- 1945-7111. ; 167:13
-
Tidskriftsartikel (refereegranskat)abstract
- One technique of additive manufacturing is the binder-jetting technique that has the advantages of low costs, printing at room temperature and in air, and no need of a support structure. The aim of this study was to investigate the corrosion behavior of printed 316L surfaces with and without different post surface treatments of blasting and superfinishing. Comparative studies were performed on abraded wrought 316L. Surface topography, porosity, surface oxide composition, and electrochemical characteristics, including pitting corrosion, were investigated at room temperature as a function of post surface treatments in diluted hydrochloric acid at pH 1.5. The blasting and superfinishing treatment significantly reduced the surface roughness and level of surface porosity. Blasting detrimentally affected on the pitting corrosion resistance. The superfinishing process induced an enrichment of chromium in the surface oxide and improved the pitting corrosion resistance. All surfaces revealed slightly reduced susceptibility to pit initiation and metastable pitting as compared to wrought 316L, possibly explained by the absence of inclusions. Once pitting propagation was induced, repassivation was hindered for all surfaces compared with the wrought surface. The pitting corrosion resistance of the as-superfinished 316L was improved compared with wrought 316L.
|
|
| 3. |
|
|
