SwePub
Sök i SwePub databas

  Utökad sökning

Träfflista för sökning "WFRF:(Bissai A.) "

Sökning: WFRF:(Bissai A.)

  • Resultat 1-2 av 2
Sortera/gruppera träfflistan
   
NumreringReferensOmslagsbildHitta
1.
  • Doddapaneni, Venkatesh, et al. (författare)
  • Spectroscopic investigations of the ablated species from the polymers exposed to electric arcs in air
  • 2015
  • Ingår i: 2015 3rd International Conference on Electric Power Equipment - Switching Technology, ICEPE-ST 2015. - : Institute of Electrical and Electronics Engineers (IEEE). - 9781467374149 ; , s. 337-340
  • Konferensbidrag (refereegranskat)abstract
    • Polymeric walls have been widely used in the last decades to improve the arc interruption process in electrical switching applications. This improvement is achieved by the evaporation (ablation) of the polymeric walls due to the highly energetic radiation generated by the electrical arcs. This experimental study deals with polymeric walls that are exposed to the electrical arcs generated between a 5 mm air gap with prospective current of 1.4 kA. In this paper, two different techniques are discussed aiming at the identification of the dominant ablated species produced during the arc interruption process, namely Fourier transform infrared spectroscopy (FTIR) and Thermogravimetric analysis coupled with Fourier transform infrared analysis of evolved gases (EGA). In addition, the morphological and chemical changes on the surface of the exposed polymeric walls are analyzed by microscopical techniques.
  •  
2.
  • Magnusson, Jesper, et al. (författare)
  • Experimental study of the current commutation in hybrid DC-breakers
  • 2015
  • Ingår i: 2015 3rd International Conference on Electric Power Equipment - Switching Technology, ICEPE-ST 2015. - : Institute of Electrical and Electronics Engineers (IEEE). - 9781467374149 ; , s. 506-511
  • Konferensbidrag (refereegranskat)abstract
    • To interrupt a current in a DC system where the feeding voltage is higher than a few kilovolt is a challenge. One popular solution today is the hybrid DC-breaker where a semiconductor is bypassed by a mechanical switch in normal operation to decrease the on-state losses. This paper presents an experimental study of the commutation from the mechanical switch to a parallel diode and IGBT. Three sets of tests were performed with six different current levels between 50 and 450 A. The test circuit consists of a capacitor bank as an energy source, a current limiting inductor, and the breaker. As the pre-charged capacitor bank is discharged through the current limiting inductor, the current will rise linearly, similar to the fault current in a stiff DC system. It was seen that with a very low stray inductance in the commutation loop, the commutation occurs in some ten microseconds just after the contact separation. Due to the small contact separation, the contacts might regain metallic contact again, causing the commutation to stop until the contacts separate again and the arc reignites. Longer arcing times were studied by introducing a larger inductance in the commutation loop. For currents of some hundred amperes, the arc voltage is fairly independent of the current level, but increases with increasing contact separation resulting in an increasing current derivative and a faster commutation. Finally the commutation and interruption of a current in a hybrid DC-breaker with an IGBT was demonstrated.
  •  
Skapa referenser, mejla, bekava och länka
  • Resultat 1-2 av 2
Typ av publikation
konferensbidrag (2)
Typ av innehåll
refereegranskat (2)
Författare/redaktör
Magnusson, Jesper (2)
Toprak, Muhammet S. (1)
Engdahl, Göran (1)
Gati, R. (1)
Edin, Hans (1)
Doddapaneni, Venkate ... (1)
visa fler...
Bissai, A. (1)
Bissai, Ara (1)
Martinez, J. A. (1)
Liljestrand, L. (1)
visa färre...
Lärosäte
Kungliga Tekniska Högskolan (2)
Språk
Engelska (2)
Forskningsämne (UKÄ/SCB)
Teknik (2)
År

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy