| 1. |
- Darvishi, Mehdi, et al.
(author)
-
Performance evaluation of phase and weather-based models in atmospheric correction with Sentinel-1data: Corvara landslide in the Alps
- 2020
-
In: IEEE Journal of Selected Topics in Applied Earth Observations and Remote Sensing. - : IEEE. - 1939-1404 .- 2151-1535. ; 13, s. 1332-1346
-
Journal article (peer-reviewed)abstract
- Phase delay caused by atmospheric effects due to spatial and temporal variations of pressure, temperature, and water vapor content is one of the major errors ources in estimation of ground deformation by interferometric synthetic aperture radar (InSAR). Therefore, accuracy of ground deformation measurement is highly contingent on the robustness of the atmospheric correction techniques. These techniques rely eitheron auxiliary data such as numerical weather models or on the analysis of the interferometric phase itself. The accuracyin phase delays estimation of mixing effectsof turbulent delay in atmosphere and stratified delay in lower troposphere is a key factor in determination of performanceof each technique. Hence, the performance evaluation of the techniques is required in order toassess their potentials, robustness and limitations. This paper analyzes and evaluates the performance of four numerical weather models (i.e., ERA-Interim, ERA5, MERRA2 and WRF) and two phase-based techniques (i.e., linear and power law) to estimate phase delay using Sentinel-1A/B data over the Corvara landslide located in the Alps. The GPS data and GACOS product were used to validate the results. We generally found that ERA5 outperformed among other weather models with a phase standard deviation reduction of 77.7%(with respect to the InSAR phase), a correlation coefficient of 0.86 (between InSAR phase and estimated tropospheric delay) and a less significant error in the velocity estimation of the landslide.
|
|
| 2. |
- Fletcher, Leigh N., et al.
(author)
-
Jupiter Science Enabled by ESA's Jupiter Icy Moons Explorer
- 2023
-
In: Space Science Reviews. - : Springer Nature. - 0038-6308 .- 1572-9672. ; 219:7
-
Research review (peer-reviewed)abstract
- ESA's Jupiter Icy Moons Explorer (JUICE) will provide a detailed investigation of the Jovian system in the 2030s, combining a suite of state-of-the-art instruments with an orbital tour tailored to maximise observing opportunities. We review the Jupiter science enabled by the JUICE mission, building on the legacy of discoveries from the Galileo, Cassini, and Juno missions, alongside ground- and space-based observatories. We focus on remote sensing of the climate, meteorology, and chemistry of the atmosphere and auroras from the cloud-forming weather layer, through the upper troposphere, into the stratosphere and ionosphere. The Jupiter orbital tour provides a wealth of opportunities for atmospheric and auroral science: global perspectives with its near-equatorial and inclined phases, sampling all phase angles from dayside to nightside, and investigating phenomena evolving on timescales from minutes to months. The remote sensing payload spans far-UV spectroscopy (50-210 nm), visible imaging (340-1080 nm), visible/near-infrared spectroscopy (0.49-5.56 & mu;m), and sub-millimetre sounding (near 530-625 GHz and 1067-1275 GHz). This is coupled to radio, stellar, and solar occultation opportunities to explore the atmosphere at high vertical resolution; and radio and plasma wave measurements of electric discharges in the Jovian atmosphere and auroras. Cross-disciplinary scientific investigations enable JUICE to explore coupling processes in giant planet atmospheres, to show how the atmosphere is connected to (i) the deep circulation and composition of the hydrogen-dominated interior; and (ii) to the currents and charged particle environments of the external magnetosphere. JUICE will provide a comprehensive characterisation of the atmosphere and auroras of this archetypal giant planet.
|
|
| 3. |
- Hagos, Desta Haileselassie, et al.
(author)
-
ExtremeEarth Meets Satellite Data From Space
- 2021
-
In: IEEE Journal of Selected Topics in Applied Earth Observations and Remote Sensing. - : Institute of Electrical and Electronics Engineers (IEEE). - 1939-1404 .- 2151-1535. ; 14, s. 9038-9063
-
Journal article (peer-reviewed)abstract
- Bringing together a number of cutting-edge technologies that range from storing extremely large volumes of data all the way to developing scalable machine learning and deep learning algorithms in a distributed manner and having them operate over the same infrastructure poses unprecedented challenges. One of these challenges is the integration of European Space Agency (ESA)'s Thematic Exploitation Platforms (TEPs) and data information access service platforms with a data platform, namely Hopsworks, which enables scalable data processing, machine learning, and deep learning on Copernicus data, and development of very large training datasets for deep learning architectures targeting the classification of Sentinel images. In this article, we present the software architecture of ExtremeEarth that aims at the development of scalable deep learning and geospatial analytics techniques for processing and analyzing petabytes of Copernicus data. The ExtremeEarth software infrastructure seamlessly integrates existing and novel software platforms and tools for storing, accessing, processing, analyzing, and visualizing large amounts of Copernicus data. New techniques in the areas of remote sensing and artificial intelligence with an emphasis on deep learning are developed. These techniques and corresponding software presented in this article are to be integrated with and used in two ESA TEPs, namely Polar and Food Security TEPs. Furthermore, we present the integration of Hopsworks with the Polar and Food Security use cases and the flow of events for the products offered through the TEPs.
|
|
| 4. |
- Yousif, Osama, 1972-
(author)
-
Urban Change Detection Using Multitemporal SAR Images
- 2015
-
Doctoral thesis (other academic/artistic)abstract
- Multitemporal SAR images have been increasingly used for the detection of different types of environmental changes. The detection of urban changes using SAR images is complicated due to the complex mixture of the urban environment and the special characteristics of SAR images, for example, the existence of speckle. This thesis investigates urban change detection using multitemporal SAR images with the following specific objectives: (1) to investigate unsupervised change detection, (2) to investigate effective methods for reduction of the speckle effect in change detection, (3) to investigate spatio-contextual change detection, (4) to investigate object-based unsupervised change detection, and (5) to investigate a new technique for object-based change image generation. Beijing and Shanghai, the largest cities in China, were selected as study areas. Multitemporal SAR images acquired by ERS-2 SAR and ENVISAT ASAR sensors were used for pixel-based change detection. For the object-based approaches, TerraSAR-X images were used.In Paper I, the unsupervised detection of urban change was investigated using the Kittler-Illingworth algorithm. A modified ratio operator that combines positive and negative changes was used to construct the change image. Four density function models were tested and compared. Among them, the log-normal and Nakagami ratio models achieved the best results. Despite the good performance of the algorithm, the obtained results suffer from the loss of fine geometric detail in general. This was a consequence of the use of local adaptive filters for speckle suppression. Paper II addresses this problem using the nonlocal means (NLM) denoising algorithm for speckle suppression and detail preservation. In this algorithm, denoising was achieved through a moving weighted average. The weights are a function of the similarity of small image patches defined around each pixel in the image. To decrease the computational complexity, principle component analysis (PCA) was used to reduce the dimensionality of the neighbourhood feature vectors. Simple methods to estimate the number of significant PCA components to be retained for weights computation and the required noise variance were proposed. The experimental results showed that the NLM algorithm successfully suppressed speckle effects, while preserving fine geometric detail in the scene. The analysis also indicates that filtering the change image instead of the individual SAR images was effective in terms of the quality of the results and the time needed to carry out the computation.The Markov random field (MRF) change detection algorithm showed limited capacity to simultaneously maintain fine geometric detail in urban areas and combat the effect of speckle. To overcome this problem, Paper III utilizes the NLM theory to define a nonlocal constraint on pixels class-labels. The iterated conditional mode (ICM) scheme for the optimization of the MRF criterion function is extended to include a new step that maximizes the nonlocal probability model. Compared with the traditional MRF algorithm, the experimental results showed that the proposed algorithm was superior in preserving fine structural detail, effective in reducing the effect of speckle, less sensitive to the value of the contextual parameter, and less affected by the quality of the initial change map.Paper IV investigates object-based unsupervised change detection using very high resolution TerraSAR-X images over urban areas. Three algorithms, i.e., Kittler-Illingworth, Otsu, and outlier detection, were tested and compared. The multitemporal images were segmented using multidate segmentation strategy. The analysis reveals that the three algorithms achieved similar accuracies. The achieved accuracies were very close to the maximum possible, given the modified ratio image as an input. This maximum, however, was not very high. This was attributed, partially, to the low capacity of the modified ratio image to accentuate the difference between changed and unchanged areas. Consequently, Paper V proposes a new object-based change image generation technique. The strong intensity variations associated with high resolution and speckle effects render object mean intensity unreliable feature. The modified ratio image is, therefore, less efficient in emphasizing the contrast between the classes. An alternative representation of the change data was proposed. To measure the intensity of change at the object in isolation of disturbances caused by strong intensity variations and speckle effects, two techniques based on the Fourier transform and the Wavelet transform of the change signal were developed. Qualitative and quantitative analyses of the result show that improved change detection accuracies can be obtained by classifying the proposed change variables.
|
|
