| 1. |
|
|
| 2. |
- Bayrak Pehlivan, Ilknur, et al.
(författare)
-
The climatic response of thermally integrated photovoltaic-electrolysis water splitting using Si and CIGS combined with acidic and alkaline electrolysis
- 2020
-
Ingår i: Sustainable Energy & Fuels. - : ROYAL SOC CHEMISTRY. - 2398-4902. ; 4:12, s. 6011-6022
-
Tidskriftsartikel (refereegranskat)abstract
- The Horizon 2020 project PECSYS aims to build a large area demonstrator for hydrogen production from solar energy via integrated photovoltaic (PV) and electrolysis systems of different types. In this study, Si- and CIGS-based photovoltaics are developed together with three different electrolyzer systems for use in the corresponding integrated devices. The systems are experimentally evaluated and a general model is developed to investigate the hydrogen yield under real climatic conditions for various thin film and silicon PV technologies and electrolyser combinations. PV characteristics using a Si heterojunction (SHJ), thin film CuInxGa1-xSe2, crystalline Si with passivated emitter rear totally diffused and thin film Si are used together with temperature dependent catalyst load curves from both acidic and alkaline approaches. Electrolysis data were collected from (i) a Pt-IrO2-based acidic electrolysis system, and (ii) NiMoW-NiO-based and (iii) Pt-Ni foam-based alkaline electrolysis systems. The calculations were performed for mid-European climate data from Julich, Germany, which will be the installation site. The best systems show an electricity-to-hydrogen conversion efficiency of 74% and over 12% solar-to-hydrogen (STH) efficiencies using both acidic and alkaline approaches and are validated with a smaller lab scale prototype. The results show that the lower power delivered by all the PV technologies under low irradiation is balanced by the lower demand for overpotentials for all the electrolysis approaches at these currents, with more or less retained STH efficiency over the full year if the catalyst area is the same as the PV area for the alkaline approach. The total yield of hydrogen, however, follows the irradiance, where a yearly hydrogen production of over 35 kg can be achieved for a 10 m(2) integrated PV-electrolysis system for several of the PV and electrolyser combinations that also allow a significant (100-fold) reduction in necessary electrolyser area for the acidic approach. Measuring the catalyst systems under intermittent and ramping conditions with different temperatures, a 5% lowering of the yearly hydrogen yield is extracted for some of the catalyst systems while the Pt-Ni foam-based alkaline system showed unaffected or even slightly increased yearly yield under the same conditions.
|
|
| 3. |
|
|
| 4. |
|
|
| 5. |
|
|
| 6. |
|
|
| 7. |
- Pell, J., et al.
(författare)
-
Scaling metagenome sequence assembly with probabilistic de Bruijn graphs
- 2012
-
Ingår i: Proceedings of the National Academy of Sciences of the United States of America. - : Proceedings of the National Academy of Sciences. - 0027-8424 .- 1091-6490. ; 109:33, s. 13272-13277
-
Tidskriftsartikel (refereegranskat)abstract
- Deep sequencing has enabled the investigation of a wide range of environmental microbial ecosystems, but the high memory requirements for de novo assembly of short-read shotgun sequencing data from these complex populations are an increasingly large practical barrier. Here we introduce a memory-efficient graph representation with which we can analyze the k-mer connectivity of metagenomic samples. The graph representation is based on a probabilistic data structure, a Bloom filter, that allows us to efficiently store assembly graphs in as little as 4 bits per k-mer, albeit inexactly. We show that this data structure accurately represents DNA assembly graphs in low memory.We apply this data structure to the problem of partitioning assembly graphs into components as a prelude to assembly, and show that this reduces the overall memory requirements for de novo assembly of metagenomes. On one soil metagenome assembly, this approach achieves a nearly 40-fold decrease in the maximum memory requirements for assembly. This probabilistic graph representation is a significant theoretical advance in storing assembly graphs and also yields immediate leverage on metagenomic assembly.
|
|
| 8. |
- Pell, J., et al.
(författare)
-
Workshop : Graph compression approaches in assembly
- 2012
-
Ingår i: 2012 IEEE 2nd International Conference on Computational Advances in Bio and Medical Sciences, ICCABS 2012. - 9781467313216
-
Konferensbidrag (refereegranskat)abstract
- Using a probabilistic data structure to store DNA assembly graphs results in a significant memory savings over other methods. As long as the Bloom filter remains below a specific false positive rate, it remains possible to traverse the graph. Using a Bloom filter has many applications in metagenomics, mRNAseq, read filtering, and error correction. We are currently exploring these possibilities and more. © 2012 IEEE.
|
|
| 9. |
- Schnabel, M., et al.
(författare)
-
Absorption and emission of silicon nanocrystals embedded in SiC : Eliminating Fabry-Perot interference
- 2015
-
Ingår i: Journal of Applied Physics. - : AIP Publishing. - 0021-8979 .- 1089-7550. ; 117:4
-
Tidskriftsartikel (refereegranskat)abstract
- Silicon nanocrystals embedded in SiC are studied by spectrophotometry and photoluminescence (PL) spectroscopy. Absorptivities are found to be affected by residual Fabry-Perot interference arising from measurements of reflection and transmission at locations of different film thickness. Multiple computational and experimental methods to avoid these errors in thin film measurements, in general, are discussed. Corrected absorptivity depends on the quantity of Si embedded in the SiC but is independent of the Si crystallinity, indicating a relaxation of the k-conservation criterion for optical transitions in the nanocrystals. Tauc gaps of 1.8-2.0 and 2.12 eV are determined for Si nanoclusters and SiC, respectively. PL spectra exhibit a red-shift of similar to 100 nm per nm nominal Si nanocluster diameter, which is in agreement with quantum confinement but revealed to be an artifact entirely due to Fabry-Perot interference. Several simple experimental methods to diagnose or avoid interference in PL measurements are developed that are applicable to all thin films. Corrected PL is rather weak and invariant with passivation, indicating that non-paramagnetic defects are responsible for rapid non-radiative recombination. They are also responsible for the broad, sub-gap PL of the SiC, and can wholly account for the form of the PL of samples with Si nanoclusters. The PL intensity of samples with Si nanoclusters, however, can only be explained with an increased density of luminescent defects in the SiC due to Si nanoclusters, efficient tunneling of photogenerated carriers from Si nanoclusters to SiC defects, or with emission from a-Si nanoclusters. Films prepared on Si exhibit much weaker PL than the same films prepared on quartz substrates.
|
|
| 10. |
- Schnabel, M., et al.
(författare)
-
Electrical and optical characterisation of silicon nanocrystals embedded in SiC
- 2014
-
Ingår i: Gettering and Defect Engineering in Semiconductor Technology XV. - : Scitec Publications Ltd. - 9783037858240 ; , s. 480-485
-
Konferensbidrag (refereegranskat)abstract
- Silicon nanocrystals (Si NCs) are a promising candidate for the top cell of an all-Si tandem solar cell with a band gap from 1.3-1.7 eV, tuneable by adjusting NC size. They are readily produced within a Si-based dielectric matrix by precipitation from the Si excess in multilayers of alternating stoichiometric and silicon-rich layers. Here we examined the luminescence and transport of Si NCs embedded in SiC. We observed luminescence that redshifts from 2.0 to 1.5 eV with increasing nominal NC size. Upon further investigation, we found that this redshift is to a large extent due to Fabry-Pérot interference. Correction for this effect allows an analysis of the spectrum emitted from within the sample. We also produced p-i-n solar cells and found that the observed I-V curves under illumination could be well-fitted by typical thin-film solar cell models including finite series and parallel resistances, and a voltage-dependent current collection function. A minority carrier mobility-lifetime product on the order of 10-10 cm2/V was deduced, and a maximum open-circuit voltage of 370 mV achieved.
|
|
