SwePub
Sök i SwePub databas

  Utökad sökning

Träfflista för sökning "WFRF:(Fikar J.) "

Sökning: WFRF:(Fikar J.)

  • Resultat 1-2 av 2
Sortera/gruppera träfflistan
   
NumreringReferensOmslagsbildHitta
1.
  • Rieth, M., et al. (författare)
  • Review on the EFDA programme on tungsten materials technology and science
  • 2011
  • Ingår i: Journal of Nuclear Materials. - : Elsevier BV. - 0022-3115 .- 1873-4820. ; 417:1-3, s. 463-467
  • Tidskriftsartikel (refereegranskat)abstract
    • All the recent DEMO design studies for helium cooled divertors utilize tungsten materials and alloys, mainly due to their high temperature strength, good thermal conductivity, low erosion, and comparably low activation under neutron irradiation. The long-term objective of the EFDA fusion materials programme is to develop structural as well as armor materials in combination with the necessary production and fabrication technologies for future divertor concepts. The programmatic roadmap is structured into four engineering research lines which comprise fabrication process development, structural material development, armor material optimization, and irradiation performance testing, which are complemented by a fundamental research programme on "Materials Science and Modeling". This paper presents the current research status of the EFDA experimental and testing investigations, and gives a detailed overview of the latest results on fabrication, joining, high heat flux testing, plasticity, modeling, and validation experiments.
  •  
2.
  • El-Ghoul, Zoel-Fikar, et al. (författare)
  • Wear analysis of pin and roller surfaces
  • 2019
  • Ingår i: 16th International Conference on Metrology and Properties of Engineering Surfaces (Met and Props 2017). - Bristol, UK : Institute of Physics (IOP).
  • Konferensbidrag (refereegranskat)abstract
    • In this paper three different combinations were evaluated: (i) steel pin vs steel roller, (ii) steel pin vs tungsten disulfide (WS2) coated roller and (iii) PVD pin vs steel roller. The aim of this paper is to properly quantify the topographical variations of the pin/roller surfaces and asses the appropriateness of the measuring technique before and after the tribological tests primarily performed for friction reduction. In-house tribometer was used to test the friction/wear performance of the three different combinations. Surface topographies were measured by white light interferometer (3D) and mechanical stylus (2D). To enable fast relocation on the stylus and interferometer, a 3D printed mask was used. Regarding the pins, Sa, Sk and Svk have been found to follow the wear changes: the lowest wear change for the combination (ii) and highest for the combination (i) but less for the combination (iii). Regarding the changes of Ra on the pin locations where edge contact occurs, the largest changes were found to be for combination (i), followed by combination (ii) and (iii). Ra and Rk change less significantly for the roller surfaces. Good correlations among the friction, initial/final roughness and radial displacements were also found.
  •  
Skapa referenser, mejla, bekava och länka
  • Resultat 1-2 av 2

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy