| 1. |
-
- 2017
-
Ingår i: Physical Review D. - 2470-0010 .- 2470-0029. ; 96:2
-
Tidskriftsartikel (refereegranskat)
|
|
| 2. |
|
|
| 3. |
|
|
| 4. |
- Ponnath, L., et al.
(författare)
-
Measurement of nuclear interaction cross sections towards neutron-skin thickness determination
- 2024
-
Ingår i: Physics Letters, Section B: Nuclear, Elementary Particle and High-Energy Physics. - 0370-2693. ; 855
-
Tidskriftsartikel (refereegranskat)abstract
- The accuracy of reaction theories used to extract properties of exotic nuclei from scattering experiments is often unknown or not quantified, but of utmost importance when, e.g., constraining the equation of state of asymmetric nuclear matter from observables as the neutron-skin thickness. In order to test the Glauber multiple-scattering model, the total interaction cross section of [Formula presented] on carbon targets was measured at initial beam energies of 400, 550, 650, 800, and 1000 MeV/nucleon. The measurements were performed during the first experiment of the newly constructed R3B (Reaction with Relativistic Radioactive Beams) experiment after the start of FAIR Phase-0 at the GSI/FAIR facility with beam energies of 400, 550, 650, 800, and 1000 MeV/nucleon. The combination of the large-acceptance dipole magnet GLAD and a newly designed and highly efficient Time-of-Flight detector enabled a precise transmission measurement with several target thicknesses for each initial beam energy with an experimental uncertainty of ±0.4%. A comparison with the Glauber model revealed a discrepancy of around 3.1% at higher beam energies, which will serve as a crucial baseline for the model-dependent uncertainty in future fragmentation experiments.
|
|
| 5. |
- Cabanelas, P., et al.
(författare)
-
Commissioning of the CALIFA Barrel Calorimeter of the R 3 B Experiment at FAIR
- 2020
-
Ingår i: Journal of Physics: Conference Series. - : IOP Publishing. - 1742-6588 .- 1742-6596. ; 1667:1
-
Konferensbidrag (refereegranskat)abstract
- CALIFA is the high efficiency and energy resolution calorimeter for the R3B experiment at FAIR, intended for detecting high energy charged particles and γ-rays in inverse kinematics direct reactions. It surrounds the reaction target in a segmented configuration of Barrel and Forward End-Cap pieces. The CALIFA Barrel consists of 1952 detection units made of CsI(Tl) long-shaped scintillator crystals, and it is being commissioned during the Phase0 experiments at FAIR. The first setup for the CALIFA Barrel commissioning is presented here. Results of detector performance with γ-rays are obtained, and show that the system fulfills the design requirements.
|
|
| 6. |
- Cabanelas, P., et al.
(författare)
-
Performance recovery of long CsI(Tl) scintillator crystals with APD-based readout
- 2020
-
Ingår i: Nuclear Instruments and Methods in Physics Research, Section A: Accelerators, Spectrometers, Detectors and Associated Equipment. - : Elsevier BV. - 0168-9002. ; 965
-
Tidskriftsartikel (refereegranskat)abstract
- CALIFA is the high efficiency and energy resolution calorimeter for the R3B experiment at FAIR, intended for detecting high energy light charged particles and gamma rays in scattering experiments, and is being commissioned during the Phase-0 experiments at FAIR, between 2018 and 2020. It surrounds the reaction target in a segmented configuration with 2432 detection units made of long CsI(Tl) finger-shaped scintillator crystals. CALIFA has a 10 year intended operational lifetime as the R3B calorimeter, necessitating measures to be taken to ensure enduring performance. In this paper we present a systematic study of two groups of 6 different detection units of the CALIFA detector after more than four years of operation. The energy resolution and light output yield are evaluated under different conditions. Tests cover the aging of the first detector units assembled and investigates recovery procedures for degraded detection units. A possible reason for the observed degradation is given, pointing to the crystal-APD coupling.
|
|
| 7. |
- Knyazev, Alexander, et al.
(författare)
-
Properties of the CsI(Tl) detector elements of the CALIFA detector
- 2019
-
Ingår i: Nuclear Instruments and Methods in Physics Research, Section A: Accelerators, Spectrometers, Detectors and Associated Equipment. - : Elsevier BV. - 0168-9002. ; 940, s. 393-404
-
Tidskriftsartikel (refereegranskat)abstract
- In the R3B experiment at FAIR, charged particles with energies up to 600 MeV and forward boosted γ-rays with energies up to 20 MeV need to be detected in scattering experiments. Calorimeters for nuclear physics experiments of this kind, using relativistic radioactive ion beams, require high energy resolution and high efficiency for simultaneous detection of strongly Doppler shifted γ-rays and high-energy charged particles. A calorimeter design that can meet these requirements, using CsI(Tl) scintillators, results in detector elements that may exhibit light output variations with crystal depth, which can limit the attainable resolution. In this paper we present results from a systematic study of 478 detector modules of CALIFA, the R3B calorimeter, in order to determine and minimize such variations. To facilitate further systematic studies we also present results for the total absorption length of the scintillation light, using spectrophotometry, light crosstalk between adjacent detector modules, and surface topography of the CsI(Tl) crystals from atomic force microscopy.
|
|
| 8. |
- Knyazev, A., et al.
(författare)
-
Simulations of light collection in long tapered CsI(Tl) scintillators using real crystal surface data and comparisons to measurement
- 2021
-
Ingår i: Nuclear Instruments and Methods in Physics Research, Section A: Accelerators, Spectrometers, Detectors and Associated Equipment. - : Elsevier BV. - 0168-9002. ; 1003
-
Tidskriftsartikel (refereegranskat)abstract
- Simulation results for light transport in long tapered CsI(Tl) crystals using look-up tables (LUTs) are presented. The LUTs were derived from the topography of a polished and a lapped surface of a CsI(Tl) crystal measured with atomic force microscopy. Simulations with different combinations of polished and lapped surfaces were performed, to extract the non-uniformity of light collection depending on the interaction point, and compared to experimental results. The simulations reproduce the general trend given by the measurements, and show that more homogeneous light collection is attained when all lateral sides of the crystal are lapped. For the lapped crystal the simulation model is most sensitive to the reflectivity of the enhanced specular reflector (ESR) foil surrounding the crystal, which is one of several properties influencing the light transport examined in this study. The sensitivity of the light-output non-uniformity to variations in the absorption length observed in a batch of CsI(Tl) crystals in a previous study is also discussed. Residual differences between the simulation and the measurements can potentially be attributed to the scattering of scintillation photons inside the materials used. Additional measurements to further advance the construction of the simulation model are suggested.
|
|
| 9. |
- Knyazev, A., et al.
(författare)
-
Tl concentration and its variation in a CsI(Tl) crystal for the CALIFA detector
- 2020
-
Ingår i: Nuclear Instruments and Methods in Physics Research, Section A: Accelerators, Spectrometers, Detectors and Associated Equipment. - : Elsevier BV. - 0168-9002. ; 975
-
Tidskriftsartikel (refereegranskat)abstract
- One of the factors that can contribute to the resolution of long, doped inorganic scintillators used for nuclear spectroscopy is the variation of the dopant concentration over the length the detector crystal. In this work an investigation of such potential variations in one of the CsI(Tl) scintillators used in the calorimeter, CALIFA, of the R3B experiment at FAIR, has been performed using particle induced X-ray emission. No statistically significant gradient in doping level was found along the long axis of the investigated sample crystal and the mean value of the Tl concentration was measured to be 0.0839(38)% by weight. This corresponds to a light output of 97.3−1.7 +1.3% relative to the maximum attainable light output according to previously published work. By taking the ±1σ bounds, the 3% statistical spread in the relative light output provides a good reference value of the minimum light-output non-uniformity observed for the CALIFA crystals. If the relative light output is estimated pointwise from a set of Tl concentration measurements a light-output non-uniformity of 4.6(2.4)% results. For a γ-ray energy of 662 keV the deduced variation in Tl concentration contributes with 0.48(6)% to the typical resolution of 7.74(6)% measured with a collimated source along the crystal main axis. The result is of interest for the characterization of the detector system performance and for realistic simulations of the light collection process in detector systems that are used for nuclear spectroscopy and calorimetry.
|
|
| 10. |
- Mantovani, G., et al.
(författare)
-
Study of High-Energy Fission in Inverse Kinematics
- 2019
-
Ingår i: IV INTERNATIONAL CONFERENCE ON NUCLEAR STRUCTURE AND DYNAMICS (NSD2019). - : EDP Sciences. - 2100-014X. - 9782759890842 ; 223
-
Konferensbidrag (refereegranskat)abstract
- Fission at low excitation energy, is a process in which both macroscopic and microscopic aspects are involved. Some features in the total kinetic energy and in the N/Z distributions of the fragments, commonly associated with shell effects, came out in a series of recent experiments with high excitation energy fusion fission reactions in inverse kinematics. In the latest experiment of this campaign, a study of high-energy fission and quasi-fission between a U-238 beam and a series of light targets was carried out by using the aforementioned technique, in order to probe the role of the shell structure in these processes.
|
|
| 11. |
- Ramos, D., et al.
(författare)
-
First Direct Measurement of Isotopic Fission-Fragment Yields of 239U
- 2019
-
Ingår i: Physical Review Letters. - 1079-7114 .- 0031-9007. ; 123:9
-
Tidskriftsartikel (refereegranskat)abstract
- A direct and complete measurement of isotopic fission-fragment yields of U-239 has been performed for the first time. The U-239 fissioning system was produced with an average excitation energy of 8.3 MeV in one-neutron transfer reactions between a U-239 beam and a Be-9 target at Coulomb barrier energies. The fission fragments were detected and isotopically identified using the VAMOS++ spectrometer at the GANIL facility. The measurement allows us to directly evaluate the fission models at excitation energies of fast neutrons, which are relevant for next-generation nuclear reactors. The present data, in agreement with model calculations, do not support the recently reported anomaly in the fission-fragment yields of U-239, and they confirm the persistence of spherical shell effects in the Sn region at excitation energies exceeding the fission barrier by a few mega-electron volts.
|
|
| 12. |
- Ramos, D., et al.
(författare)
-
Scission configuration of U-239 from yields and kinetic information of fission fragments
- 2020
-
Ingår i: Physical Review C. - 2469-9985 .- 2469-9993. ; 101:3
-
Tidskriftsartikel (refereegranskat)abstract
- The simultaneous measurement of the isotopic fission-fragment yields and fission-fragment velocities of U-239 has been performed for the first time. The U-239 fissioning system was produced in one-neutron transfer reactions between a U-238 beam at 5.88 MeV/nucleon and a Be-9 target. The combination of inverse kinematics at low energy and the use of the VAMOS + + spectrometer at the GANIL facility allows the isotopic identification of the full fission-fragment distribution and their velocity in the reference frame of the fissioning system. The proton and neutron content of the fragments at scission, their total kinetic and total excitation energy, as well as the neutron multiplicity were determined. Information from the scission point configuration is obtained from these observables and the correlation between them. The role of the octupole-deformed proton and neutron shells in the fission-fragment production is discussed.
|
|
| 13. |
- Fernandez, D., et al.
(författare)
-
Experimental study of high-energy fission and quasi-fission dynamics with fusion-induced fission reactions at VAMOS(++)
- 2023
-
Ingår i: 15TH INTERNATIONAL CONFERENCE ON NUCLEAR DATA FOR SCIENCE AND TECHNOLOGY, ND2022. - 2100-014X. ; 284
-
Konferensbidrag (refereegranskat)abstract
- During the last decade, the use of inverse kinematics in the experimental study of fission is bringing a wealth of new observables obtained in single measurements, allowing their analysis and their correlations. An ongoing application of this technique is the basis of a series of experiments performed with the variable -mode, large -acceptance VAMOS++ spectrometer at GANIL. A recent experiment has been focused on the survival of the nuclear structure effects at high excitation energy in fission and quasi-fission. The full isotopic identification of fragments, the fission dynamics and the ratio between the production of fragments with even and odd atomic numbers, the so-called proton even -odd effect, are shown. The latter shows a different mechanism for fission and quasi -fission that could be used to separate fission from quasi-fission.
|
|
| 14. |
- Kukreja, S.L., et al.
(författare)
-
NARMAX representation and identification of ankle dynamics
- 2003
-
Ingår i: IEEE Transactions on Biomedical Engineering. - 0018-9294 .- 1558-2531. ; 50:1, s. 70-81
-
Tidskriftsartikel (refereegranskat)abstract
- Representation and identification of a parallel pathway description of ankle dynamics as a model of the nonlinear autoregressive, moving average exogenous (NARMAX) class is considered. A nonlinear difference equation describing this ankle model is derived theoretically and shown to be of the NARMAX form. Identification methods for NARMAX models are applied to ankle dynamics and its properties investigated via continuous-time simulations of experimental conditions. Simulation results show that 1) the outputs of the NARMAX model match closely those generated using continuous-time methods and 2) NARMAX identification methods applied to ankle dynamics provide accurate discrete-time parameter estimates. Application of NARMAX identification to experimental human ankle data models with high cross-validation variance accounted for.
|
|
