| 1. |
- Cui, Yong, et al.
(författare)
-
Wide-gap non-fullerene acceptor enabling high-performance organic photovoltaic cells for indoor applications
- 2019
-
Ingår i: NATURE ENERGY. - : NATURE PUBLISHING GROUP. - 2058-7546. ; 4:9, s. 768-775
-
Tidskriftsartikel (refereegranskat)abstract
- Organic photovoltaic cells are potential candidates to drive low power consumption off-grid electronics for indoor applications. However, their power conversion efficiency is still limited by relatively large losses in the open-circuit voltage and a non-optimal absorption spectrum for indoor illumination. Here, we carefully designed a non-fullerene acceptor named IO-4CI and blend it with a polymer donor named PBDB-TF to obtain a photoactive layer whose absorption spectrum matches that of indoor light sources. The photovoltaic characterizations reveal a low energy loss below 0.60 eV. As a result, the organic photovoltaic cell (1 cm(2)) shows a power conversion efficiency of 26.1% with an open-circuit voltage of 1.10 V under a light-emitting diode illumination of 1,000 lux (2,700 K). We also fabricated a large-area cell (4 cm(2)) through the blade-coating method. Our cell shows an excellent stability, maintaining its initial photovoltaic performance under continuous illumination of the indoor light source for 1,000 hours.
|
|
| 2. |
- Qian, Deping, et al.
(författare)
-
Design rules for minimizing voltage losses in high-efficiency organic solar cells
- 2018
-
Ingår i: Nature Materials. - : NATURE PUBLISHING GROUP. - 1476-1122 .- 1476-4660. ; 17:8, s. 703-
-
Tidskriftsartikel (refereegranskat)abstract
- The open-circuit voltage of organic solar cells is usually lower than the values achieved in inorganic or perovskite photovoltaic devices with comparable bandgaps. Energy losses during charge separation at the donor-acceptor interface and non-radiative recombination are among the main causes of such voltage losses. Here we combine spectroscopic and quantum-chemistry approaches to identify key rules for minimizing voltage losses: (1) a low energy offset between donor and acceptor molecular states and (2) high photoluminescence yield of the low-gap material in the blend. Following these rules, we present a range of existing and new donor-acceptor systems that combine efficient photocurrent generation with electroluminescence yield up to 0.03%, leading to non-radiative voltage losses as small as 0.21 V. This study provides a rationale to explain and further improve the performance of recently demonstrated high-open-circuit-voltage organic solar cells.
|
|
| 3. |
- Yao, Huifeng, et al.
(författare)
-
14.7% Efficiency Organic Photovoltaic Cells Enabled by Active Materials with a Large Electrostatic Potential Difference
- 2019
-
Ingår i: Journal of the American Chemical Society. - : American Chemical Society (ACS). - 0002-7863 .- 1520-5126. ; 141:19, s. 7743-7750
-
Tidskriftsartikel (refereegranskat)abstract
- Although significant improvements have been achieved for organic photovoltaic cells (OPVs), the top-performing devices still show power conversion efficiencies far behind those of commercialized solar cells. One of the main reasons is the large driving force required for separating electron-hole pairs. Here, we demonstrate an efficiency of 14.7% in the single-junction OPV by using a new polymer donor PTO2 and a nonfullerene acceptor IT-4F. The device possesses an efficient charge generation at a low driving force. Ultrafast transient absorption measurements probe the formation of loosely bound charge pairs with extended lifetime that impedes the recombination of charge carriers in the blend. The theoretical studies reveal that the molecular electrostatic potential (ESP) between PTO2 and IT-4F is large, and the induced intermolecular electric field may assist the charge generation. The results suggest OPVs have the potential for further improvement by judicious modulation of ESP.
|
|
| 4. |
- Cui, Yong, et al.
(författare)
-
Over 16% efficiency organic photovoltaic cells enabled by a chlorinated acceptor with increased open-circuit voltages
- 2019
-
Ingår i: Nature Communications. - : NATURE PUBLISHING GROUP. - 2041-1723. ; 10
-
Tidskriftsartikel (refereegranskat)abstract
- Broadening the optical absorption of organic photovoltaic (OPV) materials by enhancing the intramolecular push-pull effect is a general and effective method to improve the power conversion efficiencies of OPV cells. However, in terms of the electron acceptors, the most common molecular design strategy of halogenation usually results in down-shifted molecular energy levels, thereby leading to decreased open-circuit voltages in the devices. Herein, we report a chlorinated non-fullerene acceptor, which exhibits an extended optical absorption and meanwhile displays a higher voltage than its fluorinated counterpart in the devices. This unexpected phenomenon can be ascribed to the reduced non-radiative energy loss (0.206 eV). Due to the simultaneously improved short-circuit current density and open-circuit voltage, a high efficiency of 16.5% is achieved. This study demonstrates that finely tuning the OPV materials to reduce the bandgap-voltage offset has great potential for boosting the efficiency.
|
|
| 5. |
- Yao, Huifeng, et al.
(författare)
-
Critical Role of Molecular Electrostatic Potential on Charge Generation in Organic Solar Cells
- 2018
-
Ingår i: Chinese journal of chemistry. - : WILEY-V C H VERLAG GMBH. - 1001-604X .- 1614-7065. ; 36:6, s. 491-494
-
Tidskriftsartikel (refereegranskat)abstract
- Revealing the charge generation is a crucial step to understand the organic photovoltaics. Recent development in non-fullerene organic solar cells (OSCs) indicates efficient charge separation even with negligible energetic offset between the donor and acceptor materials. These new findings trigger a critical question concerning the charge separation mechanism in OSCs, traditionally believed to result from sufficient energetic offset between the polymer donor and fullerene acceptor. We propose a new mechanism, which involves the molecular electrostatic potential, to explain efficient charge separation in non-fullerene OSCs. Together with the new mechanism, we demonstrate a record efficiency of similar to 12% for systems with negligible energetic offset between donor and acceptor materials. Our analysis also rationalizes different requirement of the energetic offset between fullerene-based and non-fullerene OSCs, and paves the way for further design of OSC materials with both high photocurrent and high photovoltage at the same time.
|
|
