| 1. |
- Niemi, MEK, et al.
(författare)
-
- 2021
-
swepub:Mat__t
|
|
| 2. |
- Kanai, M, et al.
(författare)
-
- 2023
-
swepub:Mat__t
|
|
| 3. |
- Adamczak, Desiree, et al.
(författare)
-
Influence of synthetic pathway, molecular weight and side chains on properties of indacenodithiophene-benzothiadiazole copolymers made by direct arylation polycondensation
- 2021
-
Ingår i: Journal of Materials Chemistry C. - : Royal Society of Chemistry (RSC). - 2050-7534 .- 2050-7526. ; 9:13, s. 4597-4606
-
Tidskriftsartikel (refereegranskat)abstract
- Atom-economic protocols for the synthesis of poly(indacenodithiophene-alt-benzothiadiazole) (PIDTBT) are presented in which all C-C coupling steps are achieved by direct arylation. Using two different synthetic pathways, PIDTBT copolymers with different side chains (hexylphenyl, octylphenyl, dodecyl, methyl/2-octyldodecylphenyl, 2-octyldodecylphenyl/2-octyldodecylphenyl) and molecular weight (MW) are prepared. Route A makes use of direct arylation polycondensation (DAP) of indacenodithiophene (IDT) and 4,7-dibromo-2,1,3-benzothiadiazole (BTBr2) leading to PIDTBT in high yields, with adjustable MW and without indications for structural defects. Route B starts from a polyketone precursor also prepared by DAP following cyclization. While route B allows introduction of asymmetric side chains at the IDT unit, polymer analogous cyclization gives rise to defect formation. The absorption coefficient of PIDTBT with alkylphenyl side chains made by route A increases with MW. Field-effect hole mobilities around similar to 10(-2) cm(2) V-1 s(-1) are molecular weight-independent, which is ascribed to a largely amorphous thin film morphology. PIDTBT with linear dodecyl side (C12) chains exhibits a bathochromic shift (20 nm), in agreement with theory, and more pronounced vibronic contributions to absorption spectra. In comparison to alkylphenyl side chains, C12 side chains allow for increased order in thin films, a weak melting endotherm and lower energetic disorder, which altogether explain substantially higher field-effect hole mobilities of similar to 10(-1) cm(2) V-1 s(-1).
|
|
| 4. |
- Firdaus, Yuliar, et al.
(författare)
-
Novel wide-bandgap non-fullerene acceptors for efficient tandem organic solar cells
- 2020
-
Ingår i: Journal of Materials Chemistry A. - : Royal Society of Chemistry (RSC). - 2050-7488 .- 2050-7496. ; 8:3, s. 1164-1175
-
Tidskriftsartikel (refereegranskat)abstract
- The power conversion efficiency (PCE) of tandem organic photovoltaics (OPVs) is currently limited by the lack of suitable wide-bandgap materials for the front-cell. Here, two new acceptor molecules, namely IDTA and IDTTA, with optical bandgaps (Eoptg) of 1.90 and 1.75 eV, respectively, are synthesized and studied for application in OPVs. When PBDB-T is used as the donor polymer, single-junction cells with PCE of 7.4%, for IDTA, and 10.8%, for IDTTA, are demonstrated. The latter value is the highest PCE reported to date for wide-bandgap (Eoptg ≥ 1.7 eV) bulk-heterojunction OPV cells. The higher carrier mobility in IDTTA-based cells leads to improved charge extraction and higher fill-factor than IDTA-based devices. Moreover, IDTTA-based OPVs show significantly improved shelf-lifetime and thermal stability, both critical for any practical applications. With the aid of optical-electrical device modelling, we combined PBDB-T:IDTTA, as the front-cell, with PTB7-Th:IEICO-4F, as the back-cell, to realize tandem OPVs with open circuit voltage of 1.66 V, short circuit current of 13.6 mA cm-2 and a PCE of 15%; in excellent agreement with our theoretical predictions. The work highlights IDTTA as a promising wide-bandgap acceptor for high-performance tandem OPVs. © 2019 The Royal Society of Chemistry.
|
|
| 5. |
- Green, Joshua P., et al.
(författare)
-
Dithieno[3,2-b:2,3-d]arsole-containing conjugated polymers in organic photovoltaic devices
- 2019
-
Ingår i: Dalton Transactions. - : Royal Society of Chemistry. - 1477-9226 .- 1477-9234. ; 48:20, s. 6676-6679
-
Tidskriftsartikel (refereegranskat)abstract
- Arsole-derived conjugated polymers are a relatively new class of materials in the field of organic electronics. Herein, we report the synthesis of two new donor polymers containing fused dithieno[3,2-b:2,3-d]arsole units and report their application in bulk heterojunction solar cells for the first time. Devices based upon blends with PC71BM display high open circuit voltages around 0.9 V and demonstrate power conversion efficiencies around 4%.
|
|
| 6. |
- Hallam, Toby, et al.
(författare)
-
Local Charge Trapping in Conjugated Polymers Resolved by Scanning Kelvin Probe Microscopy
- 2009
-
Ingår i: Physical Review Letters. - : American Physical Society. - 0031-9007 .- 1079-7114. ; 103:25
-
Tidskriftsartikel (refereegranskat)abstract
- The microstructure of conjugated polymers is heterogeneous on the length scale of individual polymer chains, but little is known about how this affects their electronic properties. Here we use scanning Kelvin probe microscopy with resolution-enhancing carbon nanotube tips to study charge transport on a 100 nm scale in a chain-extended, semicrystalline conjugated polymer. We show that the disordered grain boundaries between crystalline domains constitute preferential charge trapping sites and lead to variations on a 100 nm scale of the carrier concentration under accumulation conditions.
|
|
| 7. |
- Koch, Felix Peter Vinzenz, et al.
(författare)
-
The impact of molecular weight on microstructure and charge transport in semicrystalline polymer semiconductors–poly(3-hexylthiophene), a model study
- 2013
-
Ingår i: Progress in Polymer Science. - : Elsevier BV. - 0079-6700. ; 38:12, s. 1978-1989
-
Tidskriftsartikel (refereegranskat)abstract
- Electronic properties of organic semiconductors are often critically dependent upon their ability to order from the molecular level to the macro-scale, as is true for many other materials attributes of macromolecular matter such as mechanical characteristics. Therefore, understanding of the molecular assembly process and the resulting solid-state short- and long-range order is critical to further advance the field of organic electronics. Here, we will discuss the structure development as a function of molecular weight in thin films of a model conjugated polymer, poly(3-hexylthiophene) (P3HT), when processed from solution and the melt. While focus is on the microstructural manipulation and characterization, we also treat the influence of molecular arrangement and order on electronic processes such as charge transport and show, based on classical polymer science arguments, how accounting for the structural complexity of polymers can provide a basis for establishing relevant processing/structure/property-interrelationships to explain some of their electronic features. Such relationships can assist with the design of new materials and definition of processing protocols that account for the molecular length, chain rigidity and propensity to order of a given system.
|
|
| 8. |
- Scaccabarozzi, Alberto D., et al.
(författare)
-
Doping Approaches for Organic Semiconductors
- 2022
-
Ingår i: Chemical Reviews. - : American Chemical Society (ACS). - 0009-2665 .- 1520-6890. ; 122:4, s. 4420-4492
-
Forskningsöversikt (refereegranskat)abstract
- Electronic doping in organic materials has remained an elusive concept for several decades. It drew considerable attention in the early days in the quest for organic materials with high electrical conductivity, paving the way for the pioneering work on pristine organic semiconductors (OSCs) and their eventual use in a plethora of applications. Despite this early trend, however, recent strides in the field of organic electronics have been made hand in hand with the development and use of dopants to the point that are now ubiquitous. Here, we give an overview of all important advances in the area of doping of organic semiconductors and their applications. We first review the relevant literature with particular focus on the physical processes involved, discussing established mechanisms but also newly proposed theories. We then continue with a comprehensive summary of the most widely studied dopants to date, placing particular emphasis on the chemical strategies toward the synthesis of molecules with improved functionality. The processing routes toward doped organic films and the important doping-processing-nanostructure relationships, are also discussed. We conclude the review by highlighting how doping can enhance the operating characteristics of various organic devices.
|
|
