| 1. |
- Jiang, Yan, et al.
(författare)
-
Negligible-Pb-Waste and Upscalable Perovskite Deposition Technology for High-Operational-Stability Perovskite Solar Modules
- 2019
-
Ingår i: Advanced Energy Materials. - : Wiley-VCH Verlagsgesellschaft. - 1614-6832 .- 1614-6840. ; 9:13
-
Tidskriftsartikel (refereegranskat)abstract
- An upscalable perovskite film deposition method combining raster ultrasonic spray coating and chemical vapor deposition is reported. This method overcomes the coating size limitation of the existing stationary spray, single-pass spray, and spin-coating methods. In contrast with the spin-coating method (>90% Pb waste), negligible Pb waste during PbI2 deposition makes this method more environmentally friendly. Outstanding film uniformity across the entire area of 5 cm x 5 cm is confirmed by both large-area compatible characterization methods (electroluminescence and scattered light imaging) and local characterization methods (atomic force microscopy, scanning electron microscopy, photoluminescence mapping, UV-vis, and X-ray diffraction measurements on multiple sample locations), resulting in low solar cell performance decrease upon increasing device area. With the FAPb(I0.85Br0.15)(3) (FA = formamidinium) perovskite layer deposited by this method, champion solar modules show a power conversion efficiency of 14.7% on an active area of 12.0 cm(2) and an outstanding shelf stability (only 3.6% relative power conversion efficiency decay after 3600 h aging). Under continuous operation (1 sun light illumination, maximum power point condition, dry N-2 atmosphere with <5% relative humidity, no encapsulation), the devices show high light-soaking stability corresponding to an average T-80 lifetime of 535 h on the small-area solar cells and 388 h on the solar module.
|
|
| 2. |
- Liang, Jia, et al.
(författare)
-
Enhancing Optical, Electronic, Crystalline, and Morphological Properties of Cesium Lead Halide by Mn Substitution for High-Stability All-Inorganic Perovskite Solar Cells with Carbon Electrodes
- 2018
-
Ingår i: Advanced Energy Materials. - : Wiley-VCH Verlagsgesellschaft. - 1614-6832 .- 1614-6840. ; 8:20
-
Tidskriftsartikel (refereegranskat)abstract
- In this work all-inorganic perovskite CsPbIBr2 are doped with Mn to compensate their shortcomings in band structure for the application of perovskite solar cells (PSCs). The novel Mn-doped all-inorganic perovskites, CsPb1-xMnxI1+2xBr2-2x, are prepared in ambient atmosphere. As the concentration of Mn2+ ions increases, the bandgaps of CsPb1-xMnxI1+2xBr2-2x decrease from 1.89 to 1.75 eV. Additionally, when the concentration of Mn dopants is appropriate, this novel Mn-doped all-inorganic perovskite film shows better crystallinity and morphology than its undoped counterpart. These advantages alleviate the energy loss in hole transfer and facilitate the charge-transfer in perovskites, therefore, PSCs based on these novel CsPb1-xMnxI1+2xBr2-2x perovskite films display better photovoltaic performance than the undoped CsPbIBr2 perovskite films. The reference CsPbIBr2 cell reaches a power conversion efficiency (PCE) of 6.14%, comparable with the previous reports. The CsPb1-xMnxI1+2xBr2-2x cells reach the highest PCE of 7.36% (when x= 0.005), an increase of 19.9% in PCE. Furthermore, the encapsulated CsPb0.995Mn0.005I1.01Br1.99 cells exhibit good stability in ambient atmosphere. The storage stability measurements on the encapsulated PSCs reveal that PCE is dropped by only 8% of the initial value after >300 h in ambient. Such improved efficiency and stability are achieved using low-cost carbon electrodes (without expensive hole transport materials and Au electrodes).
|
|
| 3. |
- Yang, Fuliu, et al.
(författare)
-
Efficient SO2 capture at ultra-low concentration using a hybrid absorbent of deep eutectic solvent and ethylene glycol
- 2023
-
Ingår i: Journal of Molecular Liquids. - : Elsevier. - 0167-7322 .- 1873-3166. ; 382
-
Tidskriftsartikel (refereegranskat)abstract
- Deep eutectic solvents (DESs) are considered as the highly effective absorbents for sulfur dioxide (SO2) capture. However, the high viscosity of DESs and the resulting slow absorption rate as well as low absorption capacity at low SO2 concentration seriously hinder their industrial application. In this study, DES of N-methyldiethanolamine (MDEA) and imidazole (Im) is simply blended with ethylene glycol (EG) forming a hybrid absorbent, namely MDEA/Im-EG, which exhibits extremely high SO2 capture capacity at low concentration. In particular, SO2 capture capacity in MDEA/Im-EG (molar ratio = 1:1) reaches 0.446 g SO2/g absorbent at 293.2 K with SO2 concentration of 2000 ppm. Moreover, the corresponding desorption enthalpy is only −40.67 kJ/mol. To well understand the results, thermodynamic analysis of SO2 capture is performed and the SO2 capture mechanism is speculated by nuclear magnetic resonance and Fourier transform infrared spectroscopy.
|
|
