| 1. |
- Oldenbo, M., et al.
(författare)
-
Global stiffness of a SMC panel considering process induced fiber orientation
- 2004
-
Ingår i: Journal of reinforced plastics and composites (Print). - : SAGE Publications. - 0731-6844 .- 1530-7964. ; 23:1, s. 37-49
-
Tidskriftsartikel (refereegranskat)abstract
- A material model, that translates into a stiffness matrix, the second order fiber orientation tensor, described by Advani and Tucker, and the stiffness matrix of a composite with aligned ellipsoidal inclusions, has been implemented in a FE programme and validated. The stiffness of a SMC panel with known state of fiber orientation is calculated using FEM. The influence of process induced fiber orientation is analysed. The fiber orientation for a realistic charge pattern for the panel has been obtained through mould filling simulation in a separate project. It is found that the fiber orientation has a rather small impact on the global stiffness. Only 0.8% lower stiffness compared to isotropic material model is obtained taking into account the fiber orientation distribution. The main reason for the low impact of the process induced fiber orientation is that the charge is symmetrically placed in the mould leading to a symmetric fiber orientation distribution.
|
|
| 2. |
- Oldenbo, M., et al.
(författare)
-
Mechanical behaviour of SMC composites with toughening and low density additives
- 2003
-
Ingår i: Composites. Part A, Applied science and manufacturing. - : Elsevier BV. - 1359-835X .- 1878-5840. ; 34:9, s. 875-885
-
Tidskriftsartikel (refereegranskat)abstract
- A new type of SMC material (Flex-SMC) developed for automotive exterior body panels has been investigated. Flex-SMC contains hollow glass micro-spheres and thermoplastic toughening additives. A conventional SMC (Std-SMC) was used as a reference material. Materials were tested in monotonic tension and compression. Stiffness degradation with strain as well as fracture toughness was determined. In situ SEM was used to study failure mechanisms. Flex-SMC has a density almost 20% lower than Std-SMC and has higher impact resistance. The damage threshold strain of the Flex-SMCs is higher than for Std-SMC. Flex-SMCs have more than twice the fracture toughness of Std-SMC. The major reason identified is that Flex-SMCs shows extensive fibre pullout.
|
|
| 3. |
- Oldenbo, M., et al.
(författare)
-
Mechanical behaviour of SMC composites with toughening and low density additives
- 2003
-
Ingår i: Composites. Part A, Applied science and manufacturing. - 1359-835X .- 1878-5840. ; 34:9, s. 875-885
-
Tidskriftsartikel (refereegranskat)abstract
- A new type of SMC material (Flex-SMC) developed for automotive exterior body panels has been investigated. Flex-SMC contains hollow glass micro-spheres and thermoplastic toughening additives. A conventional SMC (Std-SMC) was used as a reference material. Materials were tested in monotonic tension and compression. Stiffness degradation with strain as well as fracture toughness was determined. In situ SEM was used to study failure mechanisms. Flex-SMC has a density almost 20% lower than Std-SMC and has higher impact resistance. The damage threshold strain of the Flex-SMCs is higher than for Std-SMC. Flex-SMCs have more than twice the fracture toughness of Std-SMC. The major reason identified is that Flex-SMCs shows extensive fibre pullout. © 2003 Elsevier Ltd. All rights reserved.
|
|
