| 1. |
|
|
| 2. |
|
|
| 3. |
|
|
| 4. |
- Murari, A., et al.
(författare)
-
A control oriented strategy of disruption prediction to avoid the configuration collapse of tokamak reactors
- 2024
-
Ingår i: Nature Communications. - 2041-1723 .- 2041-1723. ; 15:1
-
Tidskriftsartikel (refereegranskat)abstract
- The objective of thermonuclear fusion consists of producing electricity from the coalescence of light nuclei in high temperature plasmas. The most promising route to fusion envisages the confinement of such plasmas with magnetic fields, whose most studied configuration is the tokamak. Disruptions are catastrophic collapses affecting all tokamak devices and one of the main potential showstoppers on the route to a commercial reactor. In this work we report how, deploying innovative analysis methods on thousands of JET experiments covering the isotopic compositions from hydrogen to full tritium and including the major D-T campaign, the nature of the various forms of collapse is investigated in all phases of the discharges. An original approach to proximity detection has been developed, which allows determining both the probability of and the time interval remaining before an incoming disruption, with adaptive, from scratch, real time compatible techniques. The results indicate that physics based prediction and control tools can be developed, to deploy realistic strategies of disruption avoidance and prevention, meeting the requirements of the next generation of devices.
|
|
| 5. |
|
|
| 6. |
|
|
| 7. |
|
|
| 8. |
- Abel, I, et al.
(författare)
-
Overview of the JET results with the ITER-like wall
- 2013
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:10, s. 104002-
-
Tidskriftsartikel (refereegranskat)abstract
- Following the completion in May 2011 of the shutdown for the installation of the beryllium wall and the tungsten divertor, the first set of JET campaigns have addressed the investigation of the retention properties and the development of operational scenarios with the new plasma-facing materials. The large reduction in the carbon content (more than a factor ten) led to a much lower Z(eff) (1.2-1.4) during L- and H-mode plasmas, and radiation during the burn-through phase of the plasma initiation with the consequence that breakdown failures are almost absent. Gas balance experiments have shown that the fuel retention rate with the new wall is substantially reduced with respect to the C wall. The re-establishment of the baseline H-mode and hybrid scenarios compatible with the new wall has required an optimization of the control of metallic impurity sources and heat loads. Stable type-I ELMy H-mode regimes with H-98,H-y2 close to 1 and beta(N) similar to 1.6 have been achieved using gas injection. ELM frequency is a key factor for the control of the metallic impurity accumulation. Pedestal temperatures tend to be lower with the new wall, leading to reduced confinement, but nitrogen seeding restores high pedestal temperatures and confinement. Compared with the carbon wall, major disruptions with the new wall show a lower radiated power and a slower current quench. The higher heat loads on Be wall plasma-facing components due to lower radiation made the routine use of massive gas injection for disruption mitigation essential.
|
|
| 9. |
- Romanelli, F, et al.
(författare)
-
Overview of the JET results
- 2011
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 51:9
-
Tidskriftsartikel (refereegranskat)abstract
- Since the last IAEA Conference JET has been in operation for one year with a programmatic focus on the qualification of ITER operating scenarios, the consolidation of ITER design choices and preparation for plasma operation with the ITER-like wall presently being installed in JET. Good progress has been achieved, including stationary ELMy H-mode operation at 4.5 MA. The high confinement hybrid scenario has been extended to high triangularity, lower ρ*and to pulse lengths comparable to the resistive time. The steady-state scenario has also been extended to lower ρ*and ν*and optimized to simultaneously achieve, under stationary conditions, ITER-like values of all other relevant normalized parameters. A dedicated helium campaign has allowed key aspects of plasma control and H-mode operation for the ITER non-activated phase to be evaluated. Effective sawtooth control by fast ions has been demonstrated with3He minority ICRH, a scenario with negligible minority current drive. Edge localized mode (ELM) control studies using external n = 1 and n = 2 perturbation fields have found a resonance effect in ELM frequency for specific q95values. Complete ELM suppression has, however, not been observed, even with an edge Chirikov parameter larger than 1. Pellet ELM pacing has been demonstrated and the minimum pellet size needed to trigger an ELM has been estimated. For both natural and mitigated ELMs a broadening of the divertor ELM-wetted area with increasing ELM size has been found. In disruption studies with massive gas injection up to 50% of the thermal energy could be radiated before, and 20% during, the thermal quench. Halo currents could be reduced by 60% and, using argon/deuterium and neon/deuterium gas mixtures, runaway electron generation could be avoided. Most objectives of the ITER-like ICRH antenna have been demonstrated; matching with closely packed straps, ELM resilience, scattering matrix arc detection and operation at high power density (6.2 MW m-2) and antenna strap voltages (42 kV). Coupling measurements are in very good agreement with TOPICA modelling. © 2011 IAEA, Vienna.
|
|
| 10. |
- Litnovsky, A., et al.
(författare)
-
Diagnostic mirrors for ITER : research in the frame of International Tokamak Physics Activity
- 2019
-
Ingår i: Nuclear Fusion. - : IOP PUBLISHING LTD. - 0029-5515 .- 1741-4326. ; 59:6
-
Tidskriftsartikel (refereegranskat)abstract
- Mirrors will be used as first plasma-viewing elements in optical and laser-based diagnostics in ITER. Deterioration of the mirror performance due to e.g. sputtering of the mirror surface by plasma particles or deposition of impurities will hamper the entire performance of the affected diagnostic and thus affect ITER operation. The Specialists Working Group on First Mirrors (FM SWG) in the Topical Group on Diagnostics of the International Tokamak Physics Activity (ITPA) plays an important role in finding solutions for diagnostic first mirrors. Sound progress in research and development of diagnostic mirrors in ITER was achieved since the last overview in 2009. Single crystal (SC) rhodium (Rh) mirrors became available. SC rhodium and molybdenum (Mo) mirrors survived in conditions corresponding to similar to 200 cleaning cycles with a negligible degradation of reflectivity. These results are important for a mirror cleaning system which is presently under development. The cleaning system is based on sputtering of contaminants by plasma. Repetitive cleaning was tested on several mirror materials. Experiments comprised contamination/cleaning cycles. The reflectivity SC Mo and Rh mirrors has changed insignificantly after 80 cycles. First in situ cleaning using radiofrequency (RF) plasma was conducted in EAST tokamak with a mock-up plate of ITER edge Thomson Scattering (ETS) with five inserted mirrors. Contaminants from the mirrors were removed. Physics of cleaning discharge was studied both experimentally and by modeling. Mirror contamination can also be mitigated by protecting diagnostic ducts. A deposition mitigation (DeMi) duct system was exposed in KSTAR. The real-time measurement of deposition in the diagnostic duct was pioneered during this experiment. Results evidenced the dominating effect of the wall conditioning and baking on contamination inside the duct. A baffled cassette with mirrors was exposed at the main wall of JET for 23,6 plasma hours. No significant degradation of reflectivity was measured on mirrors located in the ducts. Predictive modeling was further advanced. A model for the particle transport, deposition and erosion at the port-plug was used in selecting an optical layout of several ITER diagnostics. These achievements contributed to the focusing of the first mirror research thus accelerating the diagnostic development. Modeling requires more efforts. Remaining crucial issues will be in a focus of the future work of the FM SWG.
|
|
| 11. |
|
|
| 12. |
- Madani, Nima, et al.
(författare)
-
Below-surface water mediates the response of African forests to reduced rainfall
- 2020
-
Ingår i: Environmental Research Letters. - : IOP Publishing. - 1748-9318 .- 1748-9326. ; 15:3
-
Tidskriftsartikel (refereegranskat)abstract
- Terrestrial ecosystem gross primary productivity (GPP) is the largest land-atmosphere carbon flux and the primary mechanism of photosynthetic fixation of atmospheric CO2 into plant biomass. Anomalous rainfall events have been shown to have a great impact on the global carbon cycle. However, less is known about the impact of these events on GPP, especially in Africa, where in situ observations are sparse. Here, we use a suite of satellite and other geospatial data to examine the responses of major ecosystems in Africa to anomalous rainfall events from 2003 to 2017. Our results reveal that higher-than-average groundwater storage in tropical ecosystems offsets the rainfall deficit during the dry years. While the inter-annual variations in GPP in semi-arid ecosystems are controlled by near surface soil water, deeper soil moisture and groundwater control the inter-annual variability of the GPP in dense tropical forests. Our study highlights the critical role of groundwater in buffering rainfall shortages and continued availability of near-surface water to plants through dry spells.
|
|
| 13. |
|
|
| 14. |
- Rubel, Marek, et al.
(författare)
-
First mirror erosion-deposition studies in JET using an ITER-like mirror test assembly
- 2021
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 0029-5515 .- 1741-4326. ; 61:4
-
Tidskriftsartikel (refereegranskat)abstract
- Mirror tests for ITER have been carried out in JET for over 15 years. During the third JET campaign with the ITER-like wall (2015-2016), comprising a total tokamak plasma exposure duration of 23.4 h and 1027 h of glow discharge cleaning, a new experiment was performed with a specially designed ITER-like test assembly housing six polycrystalline molybdenum mirror samples and featuring trapezoidal entrance apertures simulating the geometry of cut-outs in the diagnostic first wall of the ITER shielding blanket. The assembly was installed on the vacuum vessel wall at the outer midplane, set back radially behind the JET poloidal outer limiters such that the contact with thermal plasma should be largely avoided. The total and diffuse reflectivity of all mirrors was measured in the range 300-2500 nm before and after exposure. Post-exposure studies of mirror surface composition and of surfaces outside and inside the assembly were performed using microscopy, x-ray spectroscopy and ion beam analysis methods. The main results are: (i) no measured degradation of total reflectivity; (ii) diffuse reflectivity increased especially at short wavelengths (below 500 nm) from 1.1 to 2.7% and from 0.8%-1.3% above 1000 nm; (iii) mirrors were coated with a thin co-deposited layer (similar to 20-30 nm) containing carbon, oxygen and traces of nitrogen, beryllium and metals (Ni, Cr, Fe); (iv) no deuterium was detected; (v) surface composition of the mirror box inner walls was similar to that of the mirrors; (vi) less than or similar to 100 nm thick beryllium was the main component on external surfaces of the assembly. These results provide new input to ITER both for the modelling of FM erosion/deposition and for the consideration of requirements for mirror cleaning methods.
|
|
| 15. |
|
|
| 16. |
- Vizvary, Z., et al.
(författare)
-
Engineering design and analysis of an ITER-like first mirror test assembly on JET
- 2017
-
Ingår i: Fusion engineering and design. - : ELSEVIER SCIENCE SA. - 0920-3796 .- 1873-7196. ; 123, s. 1054-1057
-
Tidskriftsartikel (refereegranskat)abstract
- The ITER first mirrors are the components of optical diagnostic systems closest to the plasma. Deposition may build up on the surfaces of the mirror affecting their ability to fulfil their function. However, physics modelling of this layer growth is fraught with uncertainty. A new experiment is underway on JET, under contract to ITER, with primary objective to test if, under realistic plasma and wall material conditions and with ITER-like first mirror aperture geometry, deposits do grow on first mirrors. This paper describes the engineering design and analysis of this mirror test assembly. The assembly was installed in the 2014-15 shutdown and will be removed in the 2016-17 shutdown.
|
|
| 17. |
- Madani, Nima, et al.
(författare)
-
The Impacts of Climate and Wildfire on Ecosystem Gross Primary Productivity in Alaska
- 2021
-
Ingår i: Journal of Geophysical Research: Biogeosciences. - 2169-8953. ; 126:6
-
Tidskriftsartikel (refereegranskat)abstract
- The increase in wildfire occurrence and severity seen over the past decades in the boreal and Arctic biomes is expected to continue in the future in response to rapid climate change in this region. Recent studies documented positive trends in gross primary productivity (GPP) for Arctic boreal biomes driven by warming, but it is unclear how GPP trends are affected by wildfires. Here, we used satellite vegetation observations and environmental data with a diagnostic GPP model to analyze recovery from large fires in Alaska over the period 2000–2019. We confirmed earlier findings that warmer-than-average years provide favorable climate conditions for vegetation growth, leading to a GPP increase of 1 Tg C yr−1, contributed mainly from enhanced productivity in the early growing season. However, higher temperatures increase the risk of wildfire occurrence leading to direct carbon loss over a period of 1–3 years. While mortality related to severe wildfires reduce ecosystem productivity, post-fire productivity in moderately burned areas shows a significant positive trend. The rapid GPP recovery following fires reported here might be favorable for maintaining the region's net carbon sink, but wildfires can indirectly promote the release of long-term stored carbon in the permafrost. With the projected increase in severity and frequency of wildfires in the future, we expect a reduction of GPP and therefore amplification of climate warming in this region.
|
|
