SwePub
Sök i SwePub databas

  Utökad sökning

Träfflista för sökning "WFRF:(Tingvall Bror) "

Sökning: WFRF:(Tingvall Bror)

  • Resultat 1-33 av 33
Sortera/gruppera träfflistan
   
NumreringReferensOmslagsbildHitta
1.
  •  
2.
  •  
3.
  •  
4.
  • Haupt, Dan, et al. (författare)
  • Investigating the potential to obtain low emissions from a diesel engine running on ethanol and equipped with EGR, catalyst and DPF
  • 2004
  • Konferensbidrag (övrigt vetenskapligt/konstnärligt)abstract
    • Experiments were performed to investigate the potential to achieve low emissions from a diesel engine fueled by ethanol and equipped with a commercially available exhaust after-treatment device, DNO\dx\sT from STT Emtec. The DNO\dx\sT system includes exhaust gas recirculation (EGR) catalysts and a continuously regenerating diesel particulate filter (DPF). Two Euro III classified 9-liter turbocharged, after-cooled diesel engines from Scania were used for the task. One engine was fueled by ethanol and the other by Swedish diesel fuel, EC1. Engine operating conditions of a 22-mode test cycle, including the 13 modes of the European Stationary Cycle (ESC cycle), were used for the tests. The emissions of NO\dx and HC were small for the ethanol-fueled engine, 3.48 and 0.53 g/kWh, respectively, while the emission of CO was higher, 2.07 g/kWh. Estimations of emitted particle mass were calculated by using the software supplied in the Scanning Mobility Particle Sizer (SMPS). The estimations showed that the ethanol engine emitted only \mA1/10 of the particle mass emitted by the diesel-fueled engine. A powerful reduction of the regulated emissions was obtained when equipping the ethanol engine with EGR, catalyst and DPF. The emissions of HC, CO and NO\dx decreased down to 0.15, 0.04 and 2.54 g/kWh, respectively, while the estimated particle mass was reduced by 67%. Actually, by using the aftertreatment system, the engine became a Euro IV engine regarding the emissions of HC, CO and NO\dx. The system worked even better with the diesel-fueled engine. The NO\dx emission was reduced by approximately 33% and the estimated particle mass by more than 99%. Calculations showed that the EGR ratio was higher for the diesel engine than for the ethanol engine. Consequently, by applying a higher EGR ratio for the ethanol engine an additional reduction of the NO\dx emissions should be obtained. The results indicate that very low NO\dx and particle emissions could be obtained for an ethanol-fueled diesel engine by using the right aftertreatment equipment. Future studies should investigate the possibility to increase the EGR ratio further. The investigations also underline the need for development of a special particulate filter for ethanol engines.
  •  
5.
  •  
6.
  • Nybacka, Mikael, et al. (författare)
  • Project: CASTT - Centre for Automotive Systems Technologies and Testing
  • 2007
  • Annan publikation (populärvet., debatt m.m.)abstract
    • Through the Centre for Automotive Systems Technologies and Testing, Luleå University of Technology aims to first of all support automotive winter testing in Northern Sweden. This means to support the local automotive test entrepreneurs and through them their customers: the car manufacturers and their suppliers. To succeed in this task, the center relies on the university's areas of leading research and most importantly on the cooperation between those areas.
  •  
7.
  •  
8.
  •  
9.
  •  
10.
  •  
11.
  •  
12.
  •  
13.
  •  
14.
  • Sundbäck, Ulrik, et al. (författare)
  • Economic benefits of noise control
  • 1998
  • Ingår i: Inter-noise 98. - Auckland : Caxton Press. - 0473054396 ; , s. 349-352
  • Konferensbidrag (refereegranskat)
  •  
15.
  •  
16.
  •  
17.
  • Sundbäck, Ulrik, et al. (författare)
  • Impact noise control, within ironworks
  • 1982
  • Ingår i: Inter-noise 82. - Poughkeepsie, NY : Noise control foundation. - 0931784077 ; , s. 265-268
  • Konferensbidrag (refereegranskat)
  •  
18.
  • Sundbäck, Ulrik, et al. (författare)
  • Investigation of the physical working environment for cabin attendants within Scandinavian Airline System (SAS)
  • 1980
  • Ingår i: Noise control for the 80's. - Poughkeepsie, NY : Noise control foundation. - 0931784034 ; , s. 341-344
  • Konferensbidrag (refereegranskat)abstract
    • The considered investigation was conducted on board a number of aircraft during regular flights. The investigation was mainly concerned with noise conditions and the vibrations to which the entire body of a cabin attendant had been subjected. The types of aircraft studied included the Douglas 8, Douglas 9, Douglas 10, and Boeing 747. The noise was recorded with the aid of tape recorders at various locations in the cabin, taking into account different phases of the flight. Four cabin attendants were carrying noise dose meters during their entire working period in order to record the amount of noise they are exposed to. The vibration levels were found to be very low. In most cases the levels are below the reference curves for 'fatigue decreased proficiency' except for measurements conducted on a DC 8 at a jump seat at the back galley.
  •  
19.
  • Sundbäck, Ulrik, et al. (författare)
  • Materialhantering : sammanställning av projekt under åren 1977 - 1999
  • 1999
  • Rapport (övrigt vetenskapligt/konstnärligt)abstract
    • Avdelningen Fysikalisk Miljöteknik vid Luleå tekniska universitet har under mer än 20 år genomfört projekt inom området materialhantering. Den övergripande målsättningen för projekt inom området materialhantering har varit att genom forskning och utveckling få fram ny kunskap och ny teknik för att förbättra materialhanteringen och därigenom förbättra både arbetsmiljö och produktivitet. Ett viktigt krav på den nya kunskapen har varit att den ska vara generaliserbar och därigenom kunna utnyttjas av flera företag. Projekten har haft en helhetssyn på materialhantering och omfattat alla typer av transporter och materialflöden från inkommande material till en industri fram till att en färdig produkt leveras till en kund och alltså även omfattat all intern manuell hantering av material till och från maskiner. En målsättning med de större projekten har varit att genom diskussioner och genom konstruktion av nya tekniska lösningar höja kompetensen och medvetenheten om samspelet mellan arbetsmiljö och ekonomi hos ledning, konstruktörer, projektörer och operatörer, dvs hos alla inblandade i projektet. Flertalet av projekten har fått finansiellt stöd av RALF (Rådet för arbetslivsforskning) eller dess föregångare, AMFO och ASF. Denna rapport redovisar en sammanställning av de viktigaste resultaten inom området. Rapporten utges på CD-rommedia med sammanställningsrapporter på en CD samt två CD som innehåller filmavsnitt.
  •  
20.
  •  
21.
  • Sundbäck, Ulrik, et al. (författare)
  • Press brakes
  • 1996
  • Ingår i: 4th Pan pacific conference on occupational ergonomics. - : Ergonomics society of Taiwan.
  • Konferensbidrag (refereegranskat)
  •  
22.
  •  
23.
  •  
24.
  •  
25.
  •  
26.
  •  
27.
  •  
28.
  • Tingvall, Bror, et al. (författare)
  • Noise emissions from snowmobiles
  • 1994
  • Ingår i: Noise - quantity and quality. - Poughkeepsie, NY : Noise control foundation. ; , s. 407-410
  • Konferensbidrag (refereegranskat)
  •  
29.
  •  
30.
  •  
31.
  • Tingvall, Bror, et al. (författare)
  • Vehicle test system : a pilot study
  • 2007
  • Rapport (övrigt vetenskapligt/konstnärligt)abstract
    • Vehicle test system and exhaust multi gas equipment for transient measurements in cold climate. A pilot study to demonstrate regional competence of advanced measurement technology for vehicle test companies in north of Sweden.
  •  
32.
  • Tingvall, Bror, et al. (författare)
  • Vibrationer i gruvindustrin
  • 2005
  • Rapport (övrigt vetenskapligt/konstnärligt)abstract
    • Exponering för vibrationer anses kunna leda till olika typer av skador på människokroppen. Med de metoder som nyttjas vid losstagning av berg används gruvutrustning som under vissa förutsättningar genererar vibrationer av icke acceptabla nivåer. För att klara de nya kraven på maximala vibrationsnivåer har en satsning gjorts för att kartlägga vibrationsnivåerna i gruvmaskinerna. Kartläggningen av vibrationsnivåer inom svensk gruvindustri syftar till att skapa förståelse för sambandet mellan operatör och utrustning. Resultaten från studierna skall ge kunskap som kan användas för insatser som syftar till att minska vibrationerna samt för information till och utbildning av personalen. Studierna skall också ge underlag som senare kan användas som ett bidrag i arbetet med att reducera vibrationer i gruvmaskiner genom utveckling och förbättringar av stolar, hytter, körcykler, körsätt och enklare mätsystem för vibrationsregistrering (mätlogger). Kartläggningen skall också ge underlag på aktuella vibrationsnivåer och tillåtna exponeringstider i olika gruvmaskiner i enlighet med den nya föreskriften AFS 2005:15
  •  
33.
  • Tingvall, Bror, et al. (författare)
  • Ytterväggars ljudisolering
  • 2008
  • Rapport (övrigt vetenskapligt/konstnärligt)abstract
    • Projektets mål är att ta fram mer underlag för en databas för ljudisoleringen på ett antal vanligt förekommande ytterväggskonstruktioner samt olika förbättringsåtgärder av konstruktionerna. Databasen ska sedan kunna användas vid byggteknisk projektering av ytterväggar. Mätresultaten bör lämpa sig att användas som indata till exempelvis standarden EN 12354 och beräkningsprogrammet Bastian eller andra byggberäkningsprogram. Ljudisoleringen på flertal ytterväggskonstruktioner med olika förbättringsåtgärder har testats, företrädesvis "lätta" ytterväggskonstruktioner. En sandwich betongvägg har också ingått i proven. I flera av testerna uppnås stora förbättringar av ljudisoleringen.
  •  
Skapa referenser, mejla, bekava och länka
  • Resultat 1-33 av 33

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy