| 1. |
- Guan, Tianfu, et al.
(author)
-
Decoding the Self-Assembly Plasmonic Interface Structure in a PbS Colloidal Quantum Dot Solid for a Photodetector
- 2023
-
In: ACS Nano. - : American Chemical Society (ACS). - 1936-0851 .- 1936-086X. ; 17:22, s. 23010-23019
-
Journal article (peer-reviewed)abstract
- Hybrid plasmonic nanostructures have gained enormous attention in a variety of optoelectronic devices due to their surface plasmon resonance properties. Self-assembled hybrid metal/quantum dot (QD) architectures offer a means of coupling the properties of plasmonics and QDs to photodetectors, thereby modifying their functionality. The arrangement and localization of hybrid nanostructures have an impact on exciton trapping and light harvesting. Here, we present a hybrid structure consisting of self-assembled gold nanospheres (Au NSs) embedded in a solid matrix of PbS QDs for mapping the interface structures and the motion of charge carriers. Grazing-incidence small-angle X-ray scattering is utilized to analyze the localization and spacing of the Au NSs within the hybrid structure. Furthermore, by correlating the morphology of the Au NSs in the hybrid structure with the corresponding differences observed in the performance of photodetectors, we are able to determine the impact of interface charge carrier dynamics in the coupling structure. From the perspective of architecture, our study provides insights into the performance improvement of optoelectronic devices.
|
|
| 2. |
- Tu, Suo, et al.
(author)
-
Improvement of the thermoelectric properties of PEDOT:PSS films via DMSO addition and DMSO/salt post-treatment resolved from a fundamental view
- 2022
-
In: Chemical Engineering Journal. - : Elsevier BV. - 1385-8947 .- 1873-3212. ; 429
-
Journal article (peer-reviewed)abstract
- The combination of dimethyl sulfoxide (DMSO)-solvent doping and physical-chemical DMSO/salt de-doping in a sequence has been used to improve the thermoelectric (TE) properties of poly(3,4-ethylenedioxythiophene):poly (4-styrenesulfonate) (PEDOT:PSS) films. A high power factor of ca.105.2 mu W m(-1) K-2 has been achieved for the PEDOT:PSS film after post-treatment with 10 % sodium sulfite (Na2SO3) in the DMSO/salt mixture (v/v), outperforming sodium bicarbonate (NaHCO3). The initial DMSO-doping treatment induces a distinct phase separation by facilitating the aggregation of the PEDOT molecules. At the same time, the subsequent DMSO/salt dedoping post-treatment strengthens the selective removal of the surplus non-conductive PSS chains. Substantial alterations in the oxidation level, chain conformations, PEDOT crystallites and their preferential orientation are observed upon treatment on the molecular level. At the mesoscale level, the purification and densification of PEDOT-rich domains enable the realization of inter-grain coupling by the formation of the electronically well-percolated network. Thereby, both electrical conductivity and Seebeck coefficient are optimized.
|
|
| 3. |
- Xiao, Tianxiao, et al.
(author)
-
Autonomous self-healing hybrid energy harvester based on the combination of triboelectric nanogenerator and quantum dot solar cell
- 2024
-
In: Nano Energy. - : Elsevier BV. - 2211-2855 .- 2211-3282. ; 125
-
Journal article (peer-reviewed)abstract
- Realization of multi-source energy harvesting with one single device would maximize power output. Thus, it is emerging as a promising strategy towards renewable energy generation and has attracted worldwide attention in the past decades. Capable of capturing mechanical energy that is ubiquitous in the ambient environment, triboelectric nanogenerator (TENG) has been considered a novel yet effective source towards next-generation energy harvesting. In this work, a flexible hybrid energy harvester (HEH) is developed via the rational integration of autonomous self-healing TENG and high bending-stable lead sulfide quantum dot (PbS QD) solar cell, enabling independent electricity generation by two different mechanisms. The single-electrode mode TENG component with self-healing is realized by a polydimethylsiloxane/Triton X-100 (PDMS/TX100) mixture as the dielectric layer and the shared gold (Au) electrode, which generates 0.39 µA of output current (Iout), 24.6 V of output voltages (Vout), 15.4 nC of transfer charges (Qsc), and 7.80 mW m−2 of output power peak density. The thin-film solar cell component is based on a PbS QD layer as the light absorber with a planar structure fabricated under low-cost and compatible conditions, achieving 22.8 mA cm−2 of short-circuit current density (Jsc) and 4.92% of power conversion efficiency (PCE). As a proof of concept, an electronic watch is successfully powered by harnessing ambient mechanical and solar energy with a hybridized energy cell. This approach will offer more opportunities to construct a versatile platform towards remote monitoring and smart home systems.
|
|
| 4. |
- Yin, Shanshan, et al.
(author)
-
Tailored fabrication of quasi-isoporous and double layered alpha-Fe2O3 thin films and their application in photovoltaic devices
- 2023
-
In: Chemical Engineering Journal. - : Elsevier BV. - 1385-8947 .- 1873-3212. ; 455, s. 140135-
-
Journal article (peer-reviewed)abstract
- A series of α-Fe2O3 thin films with distinct morphologies are prepared via a facile polystyrene-block-polyethylene oxide templated sol–gel method. By tailoring the poor solvent contents and FeCl3-to-polymer weight ratio in the sol–gel solutions, quasi-isoporous α-Fe2O3 thin films with different substructures and thicknesses are obtained. Via a thermal annealing post-treatment, double layered structures are induced by a synergistic dewetting and Oswald ripening effect. Special focus is set on the α-Fe2O3 thin films prepared with no annealing/annealing-medium FeCl3 concentration, as they possess uniform periodic structures, which is suitable to be used as hole blocking modification layer of perovskite solar cells (PSCs). An improved power conversion efficiency (PCE) is obtained when the double layered α-Fe2O3 thin film is applied as the hole blocking modification layer for PSCs. The improved PCE primarily originates from the increased VOC, which probably benefits from the synergistic effect of the suppressed charge carrier recombination at the interfaces, the enhanced light transmittance as well as the superior electron extraction capacity.
|
|
