| 1. |
- Charity, R. J., et al.
(författare)
-
Two-proton decay of the 6Be ground state and the double isobaric analog of 11Li
- 2013
-
Ingår i: Journal of Physics: Conference Series. - : IOP Publishing. - 1742-6588 .- 1742-6596. ; 420:1
-
Konferensbidrag (refereegranskat)abstract
- Two-proton decay is discussed in a number of light isobaric multiplets. For the lightest two-proton emitter, 6Be, the momentum correlations between the three decay products were measured and found to be consistent with quantum-mechanical three-cluster-model calculations. Two-proton decay was also found for two members of the A=8 and A=11 quintets. Finally, a third member of the A=11 sextet, the double isobaric analog of the halo nucleus 11Li in 11B was observed by its two-proton decay.
|
|
| 2. |
- Egorova, I. A., et al.
(författare)
-
Democratic Decay of Be-6 Exposed by Correlations
- 2012
-
Ingår i: Physical Review Letters. - 1079-7114 .- 0031-9007. ; 109:20
-
Tidskriftsartikel (refereegranskat)abstract
- The interaction of an E/A = 70-MeV Be-7 beam with a Be target was used to populate levels in Be-6 following neutron knockout reactions. The three-body decay of the ground and first excited states into the alpha + p + p exit channel were detected in the High Resolution Array. Precise three-body correlations extracted from the experimental data allowed us to obtain insight into the mechanism of the three-body democratic decay. The correlation data are in good agreement with a three-cluster-model calculation and thus validate this theoretical approach over a broad energy range.
|
|
| 3. |
|
|
| 4. |
|
|
| 5. |
- Drikakis, D., et al.
(författare)
-
Numerics for iles : Limiting algorithms
- 2007
-
Bok (övrigt vetenskapligt/konstnärligt)abstract
- Large eddy simulation (LES) has emerged as the next-generation simulation tool for handling complex engineering, geophysical, astrophysical, and chemically reactive flows. As LES moves from being an academic tool to being a practical simulation strategy, the robustness of the LES solvers becomes a key issue to be concerned with, in conjunction with the classical and well-known issue of accuracy. For LES to be attractive for complex flows, the computational codes must be readily capable of handling complex geometries. Today, most LES codes use hexahedral elements; the grid-generation process is therefore cumbersome and time consuming. In the future, the use of unstructured grids, as used in Reynolds-averaged NavierâStokes (RANS) approaches, will also be necessary for LES. This will particularly challenge the development of high-order unstructured LES solvers. Because it does not require explicit filtering, Implicit LES (ILES) has some advantages over conventional LES; however, numerical requirements and issues are otherwise virtually the same for LES and ILES. In this chapterwe discuss an unstructured finite-volume methodology for both conventional LES and ILES, that is particularly suited for ILES. We believe that the next generation of practical computational fluid dynamics (CFD) models will involve structured and unstructured LES, using high-order flux-reconstruction algorithms and taking advantage of their built-in subgrid-scale (SGS) models. ILES based on functional reconstruction of the convective fluxes by use of high-resolution hybrid methods is the subject of this chapter. We use modified equation analysis (MEA) to show that the leading-order truncation error terms introduced by such methods provide implicit SGS models similar in form to those of conventional mixed SGS models.
|
|
| 6. |
- Xu, Xin, et al.
(författare)
-
Effect of heat treatment above the miscibility gap on nanostructure formation due to spinodal decomposition in Fe-52.85 at.%Cr
- 2018
-
Ingår i: Acta Materialia. - : Acta Materialia Inc. - 1359-6454 .- 1873-2453. ; 145, s. 347-358
-
Tidskriftsartikel (refereegranskat)abstract
- The effect of heat treatment at temperatures above the miscibility gap (MG) on subsequent nanostructure formation due to spinodal decomposition (SD) has been investigated in an Fe-52.85 at.%Cr alloy. In-situ total neutron scattering measurements were conducted above and inside the MG to shed light on the high temperature nanostructure. Thereafter, different quenched-in nanostructures were imposed by heat treatments at various temperatures above the MG, followed by rapid quenching. The effect of the quenched-in nanostructure on subsequent SD was investigated ex-situ by small-angle neutron scattering, analytical transmission electron microscopy and hardness testing. The critical temperature of the miscibility gap was found at ∼580 °C for the Fe-52.85 at.%Cr alloy and below that temperature, phase separation occurs, where the ferrite decomposes into Fe-rich α-phase and Cr-rich α′-phase. It was found that transient clustering of Cr occurs above the MG and that the tendency of clustering increases with decreasing temperature. The quenched-in clustering present in rapidly quenched materials treated above the MG has a significant effect on the kinetics of SD upon further aging within the MG. It is clear that the significant quenched-in Cr clustering present in samples heat treated at 600 and 700 °C accelerates SD. However, samples heat treated at 1000 °C demonstrate more rapid SD kinetics than samples heat treated at 800 °C. Cr clustering and other mechanisms affecting the kinetics of SD are discussed in the light of the results obtained.
|
|
| 7. |
- Xu, Xin, 1987-, et al.
(författare)
-
Effect of heat treatment above the miscibility gap on nanostructure formation due to spinodal decomposition in Fe-52.85 at.%Cr
-
Annan publikation (övrigt vetenskapligt/konstnärligt)abstract
- The effect of heat treatment at temperatures above the miscibility gap (MG) on subsequent nanostructure formation due to spinodal decomposition (SD) has been investigated in an Fe-52.85 at.%Cr alloy. In-situ total neutron scattering measurements were conducted above and inside the MG to shed light on the high temperature nanostructure. Thereafter, different quenched-in nanostructures were imposed by heat treatments at various temperatures above the MG, followed by rapid quenching. The effect of the quenched-in nanostructure on subsequent SD was investigated ex-situ by small-angle neutron scattering, analytical transmission electron microscopy and hardness testing. The critical temperature of the miscibility gap was found at ~570oC and below that temperature, thermodynamically stable α'-phase forms. It was found that transient clustering of Cr occurs above the MG and that the tendency of clustering increases with decreasing temperature. The quenched-in clustering present in rapidly quenched materials treated above the MG has a significant effect on the kinetics of SD upon further aging within the MG. It is clear that the significant quenched-in Cr clustering present in samples heat treated at 600 and 700oC accelerates SD. However, samples heat treated at 1000oC demonstrate more rapid SD kinetics than samples heat treated at 800oC. Cr clustering and other mechanisms affecting the kinetics of SD are discussed in the light of the results obtained.
|
|
