| 1. |
- Aurand, Bastian, et al.
(författare)
-
Reduction of X-ray generation in high-intensity laser ion acceleration
- 2015
-
Ingår i: Applied Physics B. - : Springer Science and Business Media LLC. - 0946-2171 .- 1432-0649. ; 118:2, s. 247-251
-
Tidskriftsartikel (refereegranskat)abstract
- In this paper, we report on measurements of bremsstrahlung in laser ion acceleration experiments from ultra-thin, polymer-based target foils. The influence of laser polarization on the generated radiation, the maximum achievable proton energy and the total proton number is investigated. A clear benefit in terms of radiation reduction by the use of circular polarized light can be observed. At the same time, the total number of accelerated protons was increased.
|
|
| 2. |
- Chen, Pan, et al.
(författare)
-
Quantifying the Contribution of the Dispersion Interaction and Hydrogen Bonding to the Anisotropic Elastic Properties of Chitin and Chitosan
- 2022
-
Ingår i: Biomacromolecules. - : American Chemical Society (ACS). - 1525-7797 .- 1526-4602. ; 23:4, s. 1633-1642
-
Tidskriftsartikel (refereegranskat)abstract
- The elastic tensors of chitin and chitosan allomorphs were calculated using density functional theory (DFT) with and without the dispersion correction and compared with experimental values. The longitudinal Young's moduli were 114.9 or 126.9 GPa for alpha-chitin depending on the hydrogen bond pattern: 129.0 GPa for beta-chitin and 191.5 GPa for chitosan. Furthermore, the moduli were found to vary between 17.0 and 52.8 GPa in the transverse directions and between 2.2 and 15.2 GPa in shear. Switching off the dispersion correction led to a decrease in modulus by up to 63%, depending on the direction. The transverse Young's moduli of a-chitin strongly depended on the hydroxylmethyl group conformation coupled with the dispersion correction, suggesting a synergy between hydrogen bonding and dispersion interactions. The calculated longitudinal Young's moduli were, in general, higher than experimental values obtained in static conditions, and the Poisson's ratios were lower than experimental values obtained in static conditions.
|
|
| 3. |
- Zhao, An, et al.
(författare)
-
FEM and CFD thermal modeling of an axial-flux induction machine with experimental validation
- 2024
-
Ingår i: Case Studies in Thermal Engineering. - : Elsevier BV. - 2214-157X. ; 53
-
Tidskriftsartikel (refereegranskat)abstract
- Axial-flux electrical machines are ideal candidates as in-wheel motors for electrical vehicles (EVs). Due to their characteristics of high power density and compact structure, thermal management is vital for them. Lowering the temperature of the stator windings can protect the insulation material from rapid degradation and reduce the extra copper losses by decreasing their electrical resistance. Contrary to the widely reported axial-flux permanent magnet synchronous machines, thermal modeling methods of axial-flux induction machines are rarely seen in previous literature. Hence, the present work aims at investigating their thermal response based on both the finite element method (FEM) and computational fluid dynamics (CFD) techniques. In addition, a test rig is built to validate the computed results of these two thermal models with the experimental measurement. The CFD conjugate heat transfer analysis is found to be more accurate than the FEM thermal analysis in predicting the temperature distribution of different components in the machine and the temperature rise of the airflow, with lower than 5 ∘C average errors deviating from the corresponding measured data at three rotation speeds. Additionally, the CFD simulation is able to capture the backflow occurring near the outlets of the casing that has been found during the experiments.
|
|
