| 1. |
- Rehan, Arbab, et al.
(författare)
-
Effect of Austenitization and Tempering on the Microstructure and Mechanical Properties of a 5 wt% Cr Cold Work Tool Steel
- 2016
-
Ingår i: Steel Research International. - : Wiley. - 1611-3683 .- 1869-344X. ; 12:1 December, s. 1609-1618
-
Tidskriftsartikel (refereegranskat)abstract
- The effects of austenitization and tempering temperatures for a 5 wt% Cr cold work tool steel are studied with an aim of understanding the influence on microstructure and mechanical properties. Microstructures are characterized with scanning electron microscopy and light optical microscopy. Retained austenite contents and martensite start temperatures are measured by X-ray diffraction and dilatometry, respectively. Hardness, impact toughness, and compressive yield strength are also determined. When the austenitization temperature is increased from 1020 or 1050 to 1075 °C, followed by tempering at 525 °C, significant hardness is gained while there is no increase in compressive yield strength. Higher austenitization temperatures also produce larger amounts of retained austenite. At the same time, the impact toughness is reduced due to coarsening of the martensitic microstructure. When the steel is tempered at 200 °C, a higher impact toughness and a higher volume fraction of retained austenite are observed. Retained austenite is not found after tempering at temperatures of 525 °C or above. It is concluded that the best combination of mechanical properties is achieved by austenitization at 1020 or 1050 °C followed by tempering at 525 °C.
|
|
