| 1. |
|
|
| 2. |
- Vera, C. M., et al.
(författare)
-
A preliminary study on the selectivity of linear polynuclear aromatic hydrocarbons in SFC using phenyl-type stationary phases
- 2015
-
Ingår i: Microchemical journal (Print). - : Elsevier. - 0026-265X .- 1095-9149. ; 121, s. 136-140
-
Tidskriftsartikel (refereegranskat)abstract
- The retention behaviour of a homologous series of polyaromatic hydrocarbons was evaluated on two phenyl-type stationary phases in reversed phase supercritical fluid chromatography (SFC). These phases were the Synergi polar-RP phase and the Cosmosil 5PBB phase, both of which are polar end-capped and incorporate an ether in a propyl chain that tethers the phenyl ring to the silica surface. The Cosmosil 5PBB phase also has five bromine atoms on the phenyl ring. The retention capacity of the Cosmosil column was substantially greater than the Synergi column. However, selectivity on the Cosmosil column was effectively independent of the acetonitrile modifier composition in the CO2 mobile phase, whereas, selectivity on the Synergi column was greatly affected by the acetonitrile modifier in the CO2 mobile phase. The results from this study showed that selectivity and retention studies in HPLC cannot be used to predict selectivity and retention behaviour in SFC. (C) 2015 Elsevier B.V. All rights reserved.
|
|
| 3. |
- Decrop, Deborah, et al.
(författare)
-
Single-step manufacturing of femtoliter microwell arrays in a novel surface energy mimicking polymer
- 2015
-
Ingår i: 18th International Conference on Solid-State Sensors, Actuators and Microsystems (IEEE TRANSDUCER 2015). - : IEEE.
-
Konferensbidrag (refereegranskat)abstract
- We report a novel polymer material formulation and stamp-molding technique that enable rapid single-step manufacturing of hydrophilic-in-hydrophobic microwell arrays. We developed a modified thiol-ene-epoxy polymer (mOSTE+) formulation that mimics the surface energy of its mold during polymerization. The polymer inherits the surface energy from the mold through molecular self-assembly, in which functional monomers self-assemble at the interface between the liquid prepolymer and the mold surface. Combining this novel mOSTE+ material with a stamp-molding process leads to simultaneous surface energy mimicking and micro-structuring. This method was used to manufacture microwells with hydrophilic bottom and hydrophobic sidewall, depressed in a surrounding hydrophobic surface. The microwell arrays were successfully tested for the self-assembly of 62’000 femtoliter-droplets. Such femtoliter droplet arrays are useful for, e.g., digital ELISA and single cell/molecule analysis applications.
|
|
| 4. |
- Danish, Muhammad, et al.
(författare)
-
Effect of solution matrix and pH in Z-nZVI-catalyzed percarbonate system on the generation of reactive oxygen species and degradation of 1,1,1-trichloroethane
- 2017
-
Ingår i: Water Science and Technology. - London, UK : IWA PUBLISHING. - 1606-9749 .- 1607-0798. ; 17:6, s. 1568-1578
-
Tidskriftsartikel (refereegranskat)abstract
- This study primarily focuses on evaluating the effects of solution matrix and pH for the generation of reactive oxygen species (ROSs) in a Z-nZVI-catalyzed sodium percarbonate (SPC) system to degrade 1,1,1-trichloroethane (1,1,1-TCA) in the absence and presence of a reducing agent (RA), i.e. hydroxylamine. Degradation of 1,1,1-TCA was 49.5% and 95% in the absence and presence of RA. Probe tests confirmed the generation of major hydroxyl radicals (OH center dot) and minor superoxide species (O-2(-center dot)), and scavenger tests verified the key role of OH center dot and less of O-2(-center dot) radicals. Degradation of 1,1,1-TCA decreased significantly in the presence of Cl- and HCO3-, while NO3- and SO42- had negligible effects in the absence of RA. Addition of RA significantly enhanced 1,1,1-TCA degradation by generating more OH center dot and O-2(-center dot) radicals in the presence of anions. Degradation of 1,1,1-TCA increased in the acidic range (1-5), while an inhibitive trend from neutral to basic (7-9) was observed. In contrast, a significant increase in 1,1,1-TCA degradation was observed with the addition of RA at all pH values (1-9). In conclusion, the anions and pH significantly influenced the generation and intensity of ROSs and 1,1,1-TCA was effectively degraded in the Z-nZVI-catalyzed SPC system in the presence of RA.
|
|
| 5. |
- George, Zandra, 1985, et al.
(författare)
-
Two-in-one : Cathode modification and improved solar cell blend stability through addition of modified fullerenes
- 2016
-
Ingår i: Journal of Materials Chemistry A. - : Royal Society of Chemistry (RSC). - 2050-7488 .- 2050-7496. ; 4:7, s. 2663-2669
-
Tidskriftsartikel (refereegranskat)abstract
- The synthesis of dual purpose modified fullerenes with pyridine-as well as amine-functional groups is reported. Addition of these fullerenes to a polymer : fullerene bulk-heterojunction blend based on a thiophene-quinoxaline donor polymer is found to modify the active layer/cathode interface of inverted solar cells (glass/ITO/active layer/MoO3/Al). In particular the open-circuit voltage of devices is increased from 0.1 V to about 0.7 V, which results in a drastic rise in photovoltaic performance with a power conversion efficiency of up to 3%. At the same time, presence of the functionalised fullerene additives prevents the detrimental formation of micrometre-sized fullerene crystals upon annealing at 140 degrees C. As a result, the device performance is retained, which promises significantly increased thermal stability of the bulk-heterojunction blend nanostructure.
|
|
| 6. |
- Nyflött, Åsa, 1986-, et al.
(författare)
-
The influence of moisture content on the polymer structure of polyvinyl alcohol in dispersion barrier coatings and its effect on the mass transport of oxygen
- 2017
-
Ingår i: JCT Research. - : Springer. - 1547-0091 .- 2168-8028. ; , s. 1345-1355
-
Tidskriftsartikel (refereegranskat)abstract
- This paper presents a study of the effect of moisture on the gas permeability of polyvinyl alcohol (PVOH) and PVOH–kaolin dispersion barrier coatings. The oxygen permeability was measured at different humidity levels, and the material properties were characterized under the same conditions: polymer crystallinity, kaolin concentration, and kaolin orientation were all evaluated. The experimental results revealed that the water plasticizes the PVOH material of the coatings, and the presence of kaolin filler is unable to affect such behavior significantly. The PVOH crystallinity was affected drastically by the humidity, as water melts polymer crystallites, which is a reversible process under removal of water. The permeability data were analyzed using a thermodynamicbased model able to account for the water effect on both the solubility of the gas and the diffusivity coefficients in the polymer and composite. The results showed good agreement between the model’s predictions and the experimental data in terms of the overall permeability of the material.
|
|
| 7. |
- Nyflött, Åsa, 1986-
(författare)
-
Structure-Performance Relations of Oxygen Barriers for Food Packaging
- 2017
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- Food packaging should ensure the safety and quality of food, minimize spoilage and provide an easy way of storing and handling it. Barrier coatings are generally used to meet the demands placed on fibre-based food packages, as these have the ability to regulate the amount of gases that can enter them. Some gases are detrimental to food quality: oxygen, for example, initiates lipid oxidation in fatty foods. Using both experimental data and computer modelling, this thesis explains some aspects of how the structure of barrier coatings influences the mass transport of oxygen with the aim of obtaining essential knowledge that can be used to optimize the performance of barriers.Barrier coatings are produced from polyvinyl alcohol and kaolin blends that are coated onto a polymeric support. The chemical and physical structures of these barriers were characterized according to their influence on permeability in various climates. At a low concentration of kaolin, the crystallinity of polyvinyl alcohol decreased; in the thinner films, the kaolin particles were orientated in the basal plane of the barrier coating. The experimental results indicated a complex interplay between the polymer and the filler with respect to permeability.A computer model for permeability incorporating theories for the filled polymeric layer to include the polymer crystallinity, addition of filler, filler aspect ratio and surrounding moisture was developed. The model shows that mass transport was affected by the aspect ratio of the clay in combination with the clay concentration, as well as the polymer crystallinity. The combined model agreed with the experiments, showing that it is possible to combine different theories into one model that can be used to predict the mass transport.Four barrier coatings: polyethylene, ethylene vinyl alcohol + kaolin, latex + kaolin and starch were evaluated using the parameters of greenhouse gas emissions and product costs. After the production of the barrier material, the coating process and the end-of-life handling scenarios were analysed, it emerged that starch had the lowest environmental impact and latex + kaolin had the highest.
|
|
| 8. |
- Kothapalli, Satya V.V.N. 1985-
(författare)
-
Nano-Engineered Contrast Agents : Toward Multimodal Imaging and Acoustophoresis
- 2015
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- Diagnostic ultrasound (US) is safer, quicker and cheaper than other diagnostic imaging modalities. Over the past two decades, the applications of US imaging has been widened due to the development of injectable, compressible and encapsulated microbubbles (MBs) that provide an opportunity to improve conventional echocardiographic imaging, blood flow assessment and molecular imaging. The encapsulating material is manufactured by different biocompatible materials such as proteins, lipids or polymers. In current research, researchers modify the encapsulated shell with the help of advanced molecular chemistry techniques to load them with dyes (for fluorescent imaging), nanoparticles and radioisotopes (for multimodal imaging) or functional ligands or therapeutic gases (for local drug delivery). The echogenicity and the radial oscillation of MBs is the result of their compressibility, which undoubtedly varies with the encapsulated shell characteristics such as rigidity or elasticity.In this thesis, we present acoustic properties of novel type of polyvinyl alcohol (PVA)-shelled microbubble (PVA-MB) that was further modified with superparamagnetic iron oxide nanoparticles (SPIONs) to work as a dual-modal contrast agent for magnetic resonance (MR) imaging along with US imaging. Apparently, the shell modification changes their mechanical characteristics, which affects their acoustic properties. The overall objective of the thesis is to investigate the acoustic properties of modified and unmodified PVA-MBs at different ultrasound parameters.The acoustic and mechanical characterization of SPIONs modified PVA-MBs revealed that the acoustical response depends on the SPION inclusion strategy. However they retain the same structural characteristics after the modification. The modified MBs with SPIONs included on the surface of the PVA shell exhibit a soft-shelled behavior and produce a higher echogenicity than the MBs with the SPIONs inside the PVA shell. The fracturing mechanism of the unmodified PVA-MBs was identified to be different from the other fracturing mechanisms of conventional MBs. With the interaction of high-pressure bursts, the air gas core is squeezed out through small punctures in the PVA shell. During the fracturing, the PVA-MBs exhibit asymmetric (other modes) oscillations, resulting in sub- and ultra-harmonic generation. Exploiting the US imaging at the other modes of the oscillation of the PVA-MBs would provide an opportunity to visualize very low concentrations of (down to single) PVA-MBs. We further introduced the PVA-MBs along with particles mimicking red blood cells in an acoustic standing-wave field to observe the acoustic radiation force effect. We observed that the compressible PVA-MBs drawn toward pressure antinode while the solid blood phantoms moved toward the pressure node. This acoustic separation method (acoustophoresis) could be an efficient tool for studying the bioclearance of the PVA-MBs in the body, either by collecting blood samples (in-vitro) or by using the extracorporeal medical procedure (ex-vivo) at different organs.Overall, this work contributes significant feedback for chemists (to optimize the nanoparticle inclusion) and imaging groups (to develop new imaging sequences), and the positive findings pave new paths and provide triggers to engage in further research.
|
|
| 9. |
- Kharazmi, Parastou, 1977-
(författare)
-
Monitoring the gelation time and curing process of a reinforced polyester lining-original data
- 2019
-
Annan publikationabstract
- Polymer linings used in sewer rehabilitation technologies are expected to cure fast in order for the renewed line to return to the service quickly and with minimum disruption. This dataset includes the original data obtained from the thermal analyses of a reinforced polyester composite used as pipe lining, including studying gelation, enthalpy and curing process for a better understanding of the material's curing behaviour after application in the field.
|
|
| 10. |
- Pardon, Gaspard, 1983-, et al.
(författare)
-
Simultaneous replication of hydrophilic and superhydrophobic micropatterns through area-selective monomer self-assembly
- 2016
-
Ingår i: Advanced Materials Interfaces. - Weinheim : Wiley-VCH Verlagsgesellschaft. - 2196-7350. ; 3:17
-
Tidskriftsartikel (refereegranskat)abstract
- The control and permanent modification of the surface properties of polymers is a critical enabler for many applications. Here, we demonstrate a strategy, which we call surface energy mimicking, for the spontaneous replication of micropatterns of surface energies ranging from hydrophilic to superhydrophobic from a mold to several replicas.We introduce surface energy mimicking, enabling spontaneous replication of micropatterns (2D and 2.5D) of different surface energies, and enabled by self-assembly of functional mimicking monomers within a polymer matrix. We demonstrate replication of surface energies ranging from hydrophilic to superhydrophobic, and self-assembly of picoliter-droplet arrays on replicated micropatterned arrays containing hydrophilic patches in a hydrophobic surface.
|
|
