| 1. |
|
|
| 2. |
- Beshkova, Milena, 1975-, et al.
(författare)
-
Structural Properties of 3C-SiC Grown by Sublimation Epitaxy
- 2009
-
Ingår i: ECSCRM2009,2009. - Materials Science Forum Vols. 615-617 : Trans Tech Publications. - 9780878493340 ; , s. 181-184
-
Konferensbidrag (refereegranskat)abstract
- The present paper deals with morphological and structural investigation of 3C-SiC layers grown by sublimation epitaxy on on axis 6H-SiC(0001) at source temperature 2000 °C, under vacuum conditions (<10-5 mbar) and different temperature gradients in the range of 5-8 °C/mm. The layer grown at a temperature gradient 6 °C/mm has the largest average domain size of 0.4 mm2 assessed by optical microscope in transmission mode. The rocking curve full width at half maximum (FWHM) of (111) reflection is 43 arcsec which suggests good crystalline quality. The AFM image of the same layer shows steps with height 0.25 nm and 0.75 nm which are characteristic of a stacking fault free 3C-SiC surface and c-axis repeat height, respectively.
|
|
| 3. |
- Ciechonski, Rafal, 1976-, et al.
(författare)
-
Evaluation of MOS structures processed on 4H–SiC layers grown by PVT epitaxy
- 2005
-
Ingår i: Solid-State Electronics. - : Elsevier BV. - 0038-1101 .- 1879-2405. ; 49:12, s. 1917-1920
-
Tidskriftsartikel (refereegranskat)abstract
- MOS capacitors have been fabricated on 4H–SiC epilayers grown by physical vapor transport (PVT) epitaxy. The properties were compared with those on similar structures based on chemical vapor deposition (CVD) layers. Capacitance–voltage (C–V) and conductance measurements (G–V) were performed in the frequency range of 1 kHz to 1 MHz and also at temperatures up to 475 K. Detailed investigations of the PVT structures indicate a stable behaviour of the interface traps from room temperature up to 475 K. The amount of positive oxide charge QO is 6.83 × 109 cm−2 at room temperature and decreases with temperature increase. This suggests that the processed devices are temperature stable. The density of interface states Dit obtained by Nicollian–Brews conductance method is lower in the structure based on the PVT grown sample.
|
|
| 4. |
- Ciechonski, Rafal, et al.
(författare)
-
Evaluation of On-state Resistance and Boron-related Levels in n-type 4H-SiC
- 2005
-
Ingår i: Materials Science Forum, Vols. 483-485. ; , s. 425-428
-
Konferensbidrag (refereegranskat)abstract
- Specific on-resistance Ron estimated from current density-voltage characteristics of Schottky diodes on thick layers exhibits variations from tens of mΩ.cm2 to tens of Ω.cm2 for different doping levels. In order to understand the occurrence of high on-state resistance, Schottky barrier heights were first estimated for both forward and reverse bias with the application of thermionic emission theory and were in agreement with a literature reported values. Decrease in mobility with the temperature was observed and its dependencies of T–1.3 and T–2.0 for moderately doped and low doped samples respectively were estimated. From deep level measurements by Minority Carrier Transient Spectroscopy, an influence of shallow boron related levels and D-center on dependence of on-state resistance was observed, being more pronounced in low doped samples. Similar tendency was observed in depth profiling of Ron. This suggests a major role of boron in a compensation mechanism thus resulting in high Ron.
|
|
| 5. |
- Ciechonski, Rafal, et al.
(författare)
-
Structural instabilities in growth of SiC crystals
- 2005
-
Ingår i: Journal of Crystal Growth. - : Elsevier BV. - 0022-0248. ; 275:1-2, s. e461-e466
-
Tidskriftsartikel (refereegranskat)abstract
- Misoriented grains, which may occur on the growth front of 6H–SiC boules have been studied in relation to their appearance during sublimation growth. The effect was obtained by applying growth conditions at which the source powder was gradually approaching graphitisation and the vapour becoming C-rich. The high off-orientation of the grains is demonstrated through etching in molten KOH and transmission light optical microscopy. Micropipes propagating in the single crystal area and facing the misoriented grain have been studied, and it is shown that they may either be terminated at the grain or their propagation is altered to be parallel with the grain boundary. It has been found that the polytype of the grains may switch from 6H to 4H, which is explained by the change of the Si/C ratio in the vapour.
|
|
| 6. |
|
|
| 7. |
- Ewing, D.J., et al.
(författare)
-
Inhomogeneous electrical characteristics in 4H-SiC Schottky diodes
- 2007
-
Ingår i: Semiconductor Science and Technology. - : IOP Publishing. - 0268-1242 .- 1361-6641. ; 22:12, s. 1287-1291
-
Tidskriftsartikel (refereegranskat)abstract
- Hundreds of current-voltage (I-V) measurements of Ni, Pt and Ti Schottky diodes on 4H-SiC were conducted at low applied voltages. The SiC substrates contained homoepitaxial layers grown by either chemical vapor deposition or sublimation. While near-ideal contacts were fabricated on all samples, a significant percentage of diodes (∼7%-50% depending on the epitaxial growth method and the diode size) displayed a non-ideal, or inhomogeneous, barrier height. These 'non-ideal' diodes occurred regardless of growth technique, pre-deposition cleaning method, or contact metal. In concurrence with our earlier reports in which the non-ideal diodes were modeled as two Schottky barriers in parallel, the lower of the two Schottky barriers, when present, was predominantly centered at one of the three values: ∼0.60, 0.85 or 1.05 eV. The sources of these non-idealities were investigated using electron-beam- induced current (EBIC) and deep-level transient spectroscopy (DLTS) to determine the nature and energy levels of the defects. DLTS revealed a defect level that corresponds with the low- (non-ideal) barrier height, at ∼0.60 eV. It was also observed that the I-V characteristics tended to degrade with increasing deep-level concentration and that inhomogeneous diodes tended to contain defect clusters. Based on the results, it is proposed that inhomogeneities, in the form of one or more low-barrier height regions within a high-barrier height diode, are caused by defect clusters that locally pin the Fermi level. © 2007 IOP Publishing Ltd.
|
|
| 8. |
- Gällström, Andreas, 1978-, et al.
(författare)
-
Influence of Cooling Rate after High Temperature Annealing on Deep Levels in High-Purity Semi-Insulating 4H-SiC
- 2007
-
Ingår i: Materials Science Forum, vol. 556-557. - : Trans Tech Publications. ; , s. 371-
-
Konferensbidrag (refereegranskat)abstract
- The influence of different cooling rates on deep levels in 4H-SiC after high temperature annealing has been investigated. The samples were heated from room temperature to 2300°C, followed by a 20 minutes anneal at this temperature. Different subsequent cooling sequences down to 1100°C were used. The samples have been investigated using photoluminescence (PL) and IV characteristics. The PL intensities of the silicon vacancy (VSi) and UD-2, were found to increase with a faster cooling rate.
|
|
| 9. |
- Hens, Philip, et al.
(författare)
-
P- and n-type doping in SiC sublimation epitaxy using highly doped substrates
- 2009
-
Ingår i: ECSCRM2008,2008. - Materials Science Forum Vols. 615-617 : Trans Tech Publications. - 9780878493340 ; , s. 85-88
-
Konferensbidrag (refereegranskat)abstract
- The co-doping of nitrogen and aluminum has been studied in the sublimation epitaxy growth process. It is shown that the doping may be tuned from n-type to p-type by effect of substrate doping, growth face and volume of the growth crucible. The co-doped layers show a nearly ideal I V characteristic and luminescence at room temperature.
|
|
| 10. |
|
|
