| 1. |
- Abate, E., et al.
(författare)
-
Combined performance tests before installation of the ATLAS Semiconductor and Transition Radiation Tracking Detectors
- 2008
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 3
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS (A Toroidal LHC ApparatuS) Inner Detector provides charged particle tracking in the centre of the ATLAS experiment at the Large Hadron Collider (LHC). The Inner Detector consists of three subdetectors: the Pixel Detector, the Semiconductor Tracker (SCT), and the Transition Radiation Tracker (TRT). This paper summarizes the tests that were carried out at the final stage of SCT+TRT integration prior to their installation in ATLAS. The combined operation and performance of the SCT and TRT barrel and endcap detectors was investigated through a series of noise tests, and by recording the tracks of cosmic rays. This was a crucial test of hardware and software of the combined tracker detector systems. The results of noise and cross-talk tests on the SCT and TRT in their final assembled configuration, using final readout and supply hardware and software, are reported. The reconstruction and analysis of the recorded cosmic tracks allowed testing of the offline analysis chain and verification of basic tracker performance parameters, such as efficiency and spatial resolution, in combined operation before installation.
|
|
| 2. |
- Aaron, F. D., et al.
(författare)
-
Multi-leptons with high transverse momentum at HERA
- 2009
-
Ingår i: Journal of High Energy Physics. - : Springer Science and Business Media LLC. - 1029-8479. ; :10
-
Tidskriftsartikel (refereegranskat)abstract
- Events with at least two high transverse momentum leptons (electrons or muons) are studied using the H1 and ZEUS detectors at HERA with an integrated luminosity of 0.94 fb(-1). The observed numbers of events are in general agreement with the Standard Model predictions. Seven di- and tri-lepton events are observed in e(+)p collision data with a scalar sum of the lepton transverse momenta above 100 GeV while 1.94 +/- 0.17 events are expected. Such events are not observed in e(-)p collisions for which 1.19 +/- 0.12 are predicted. Total visible and differential di-electron and di-muon photoproduction cross sections are extracted in a restricted phase space dominated by photon-photon collisions.
|
|
| 3. |
- Abdesselam, A., et al.
(författare)
-
The ATLAS semiconductor tracker end-cap module
- 2007
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 575:3, s. 353-389
-
Tidskriftsartikel (refereegranskat)abstract
- The challenges for the tracking detector systems at the LHC are unprecedented in terms of the number of channels, the required read-out speed and the expected radiation levels. The ATLAS Semiconductor Tracker. (SCT) end-caps have a total of about 3 million electronics channels each reading out every 25 ns into its own on-chip 3.3 mu s buffer. The highest anticipated dose after 10 years operation is 1.4x10(14) cm(-2) in units of 1 MeV neutron equivalent (assuming the damage factors scale with the non-ionising energy loss). The forward tracker has 1976 double-sided modules, mostly of area similar to 70 cm(2), each having 2 x 768 strips read out by six ASICs per side. The requirement to achieve an average perpendicular radiation length of 1.5% X-0, while coping with up to 7 W dissipation per module (after irradiation), leads to stringent constraints on the thermal design. The additional requirement of 1500e(-) equivalent noise charge (ENC) rising to only 1800e(-) ENC after irradiation, provides stringent design constraints on both the high-density Cu/Polyimide flex read-out circuit and the ABCD3TA read-out ASICs. Finally, the accuracy of module assembly must not compromise the 16 mu m (r phi) resolution perpendicular to the strip directions or 580 mu m radial resolution coming from the 40 mrad front-back stereo angle. A total of 2210 modules were built to the tight tolerances and specifications required for the SCT. This was 234 more than the 1976 required and represents a yield of 93%. The component flow was at times tight, but the module production rate of 40-50 per week was maintained despite this. The distributed production was not found to be a major logistical problem and it allowed additional flexibility to take advantage of where the effort was available, including any spare capacity, for building the end-cap modules. The collaboration that produced the ATLAS SCT end-cap modules kept in close contact at all times so that the effects of shortages or stoppages at different sites could be rapidly resolved.
|
|
| 4. |
- Abdesselam, A., et al.
(författare)
-
Engineering for the ATLAS SemiConductor Tracker (SCT) end-cap
- 2008
-
Ingår i: Journal of Instrumentation. - 1748-0221 .- 1748-0221. ; 3
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS SemiConductor Tracker (SCT) is a silicon-strip tracking detector which forms part of the ATLAS inner detector. The SCT is designed to track charged particles produced in proton-proton collisions at the Large Hadron Collider (LHC) at CERN at an energy of 14 TeV. The tracker is made up of a central barrel and two identical end-caps. The barrel contains 2112 silicon modules, while each end-cap contains 988 modules. The overall tracking performance depends not only on the intrinsic measurement precision of the modules but also on the characteristics of the whole assembly, in particular, the stability and the total material budget. This paper describes the engineering design and construction of the SCT end-caps, which are required to support mechanically the silicon modules, supply services to them and provide a suitable environment within the inner detector. Critical engineering choices are highlighted and innovative solutions are presented - these will be of interest to other builders of large-scale tracking detectors. The SCT end-caps will be fully connected at the start of 2008. Further commissioning will continue, to be ready for proton-proton collision data in 2008.
|
|
| 5. |
|
|
| 6. |
- Aktas, A., et al.
(författare)
-
Search for a narrow baryonic resonance decaying to K(s)(0)p or K-s(0)(p)over-bar in deep inelastic scattering at HERA
- 2006
-
Ingår i: Physics Letters. Section B: Nuclear, Elementary Particle and High-Energy Physics. - : Elsevier BV. - 0370-2693. ; 639:3-4, s. 202-209
-
Tidskriftsartikel (refereegranskat)abstract
- A search for a narrow baryonic resonance decaying to K(s)(0)p or K-s(0)(p) over bar is carried out in deep inelastic ep scattering with the H1 detector at HERA. ss Such a resonance could be a strange pentaquark Theta(+), evidence for which has been reported by several experiments. The K(s)(0)p and K-s(0)(p) over bar invariant ss mass distributions presented here do not show any significant peak in the mass range from threshold up to 1.7 GeV. Mass dependent upper limits on sigma(ep -> e Theta X+) x BR(Theta(+) -> K(0)p) are obtained at the 95% confidence level.
|
|
| 7. |
- Aktas, A., et al.
(författare)
-
Search for doubly-charged Higgs boson production at HERA
- 2006
-
Ingår i: Physics Letters. Section B: Nuclear, Elementary Particle and High-Energy Physics. - : Elsevier BV. - 0370-2693. ; 638:5-6, s. 432-440
-
Tidskriftsartikel (refereegranskat)abstract
- A search for the single production of doubly-charged Higgs bosons H-+/-+/- in ep collisions is presented. The signal is searched for via the Higgs decays into a high mass pair of same charge leptons, one of them being an electron. The analysis uses up to 118 pb(-1) of ep data collected by the H1 experiment at HERA. No evidence for doubly-charged Higgs production is observed and mass dependent upper limits are derived on the Yukawa couplings h(el) of the Higgs boson to an electron-lepton pair. Assuming that the doubly-charged Higgs only decays into an electron and a muon via a coupling of electromagnetic strength h(e mu) = root 4 pi alpha(em) similar or equal to 0.3, a lower limit of 141 GeV on the H-+/-+/- mass is obtained at the 95% confidence level. For a doubly-charged Higgs decaying only into an electron and a tau and a coupling h(e tau) similar or equal to 0.3, masses below 112 GeV are ruled out.
|
|
| 8. |
- Aktas, A., et al.
(författare)
-
Tau lepton production in ep collisions at HERA
- 2006
-
Ingår i: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044. ; 48:3, s. 699-714
-
Tidskriftsartikel (refereegranskat)abstract
- The production of tau leptons in ep collisions is investigated using data recorded by the H1 detector at HERA in the period 1994-2000. Tau leptons are identified by detecting their decay products, using leptonic and hadronic decay modes. The cross section for the production of tau lepton pairs is measured for the first time at HERA. Furthermore, a search for events with an energetic isolated tau lepton and with large missing transverse momentum is performed. The results are found to be in agreement with the Standard Model predictions.
|
|
| 9. |
- Aktas, A., et al.
(författare)
-
Diffractive deep-inelastic scattering with a leading proton at HERA
- 2006
-
Ingår i: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044. ; 48:3, s. 749-766
-
Tidskriftsartikel (refereegranskat)abstract
- The cross section for the diffractive deep-inelastic scattering process ep -> eX(P) is measured, with the leading final state proton detected in the H1 Forward Proton Spectrometer. The data analysed cover the range x(P) < 0.1 in fractional proton longitudinal momentum loss, 0.08 < vertical bar t vertical bar < 0.5 GeV-2 in squared four-momentum transfer at the proton vertex, 2 < Q(2) < 50 GeV2 in photon virtuality and 0.004 < beta = x/x(P) < 1, where x is the Bjorken scaling variable. For x(P) less than or similar to 10(-2), the differential cross section has a dependence of approximately d sigma/dt proportional to e(6t), independently of x(P), beta and Q(2) within uncertainties. The cross section is also measured triple differentially in x(P), beta and Q(2). The x(P) dependence is interpreted in terms of an effective pomeron trajectory with intercept alpha(P) (0) = 1.114 +/- 0.018(stat.) +/- 0.012(syst.)(-0.020)(+0.040) (model) and a subleading exchange. The data are in good agreement with an H1 measurement for which the event selection is based on a large gap in the rapidity distribution of the final state hadrons, after accounting for proton dissociation contributions in the latter. Within uncertainties, the dependence of the cross section on x and Q(2) can thus be factorised from the dependences on all studied variables which characterise the proton vertex, for both the pomeron and the sub-leading exchange.
|
|
| 10. |
- Aktas, A., et al.
(författare)
-
Measurement and QCD analysis of the diffractive deep-inelastic scattering cross section at HERA
- 2006
-
Ingår i: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044. ; 48:3, s. 715-748
-
Forskningsöversikt (refereegranskat)abstract
- A detailed analysis is presented of the diffractive deep-inelastic scattering process ep -> eXY, where Y is a proton or a low mass proton excitation carrying a fraction 1 - x(IP) > 0.95 of the incident proton longitudinal momentum and the squared four-momentum transfer at the proton vertex satisfies |t| < 1 GeV2. Using data taken by the H1 experiment, the cross section is measured for photon virtualities in the range 3.5 <= Q(2) <= 1600 GeV2, triple differentially in x(IP), Q(2) and beta = x/x(P), where x is the Bjorken scaling variable. At low x(IP), the data are consistent with a factorisable x(IP) dependence, which can be described by the exchange of an effective pomeron trajectory with intercept alpha(IP)(0) = 1.118 +/- 0.008(exp.)(-0.010)(+0.029)(model). Diffractive parton distribution functions and their uncertainties are determined from a next-to-leading order DGLAP QCD analysis of the Q(2)and beta dependences of the cross section. The resulting gluon distribution carries an integrated fraction of around 70% of the exchanged momentum in the Q(2) range studied. Total and differential cross sections are also measured for the diffractive charged current process e(+) p -> (v) over bar eXY and are found to be well described by predictions based on the diffractive parton distributions. The ratio of the diffractive to the inclusive neutral current ep cross sections is studied. Over most of the kinematic range, this ratio shows no significant dependence on Q(2) at fixed x(P) and x or on x at fixed Q(2) and beta.
|
|
