1. |
- Abate, E., et al.
(author)
-
Combined performance tests before installation of the ATLAS Semiconductor and Transition Radiation Tracking Detectors
- 2008
-
In: Journal of Instrumentation. - 1748-0221. ; 3
-
Journal article (peer-reviewed)abstract
- The ATLAS (A Toroidal LHC ApparatuS) Inner Detector provides charged particle tracking in the centre of the ATLAS experiment at the Large Hadron Collider (LHC). The Inner Detector consists of three subdetectors: the Pixel Detector, the Semiconductor Tracker (SCT), and the Transition Radiation Tracker (TRT). This paper summarizes the tests that were carried out at the final stage of SCT+TRT integration prior to their installation in ATLAS. The combined operation and performance of the SCT and TRT barrel and endcap detectors was investigated through a series of noise tests, and by recording the tracks of cosmic rays. This was a crucial test of hardware and software of the combined tracker detector systems. The results of noise and cross-talk tests on the SCT and TRT in their final assembled configuration, using final readout and supply hardware and software, are reported. The reconstruction and analysis of the recorded cosmic tracks allowed testing of the offline analysis chain and verification of basic tracker performance parameters, such as efficiency and spatial resolution, in combined operation before installation.
|
|
2. |
- Abdesselam, A., et al.
(author)
-
Engineering for the ATLAS SemiConductor Tracker (SCT) end-cap
- 2008
-
In: Journal of Instrumentation. - 1748-0221. ; 3
-
Journal article (peer-reviewed)abstract
- The ATLAS SemiConductor Tracker (SCT) is a silicon-strip tracking detector which forms part of the ATLAS inner detector. The SCT is designed to track charged particles produced in proton-proton collisions at the Large Hadron Collider (LHC) at CERN at an energy of 14 TeV. The tracker is made up of a central barrel and two identical end-caps. The barrel contains 2112 silicon modules, while each end-cap contains 988 modules. The overall tracking performance depends not only on the intrinsic measurement precision of the modules but also on the characteristics of the whole assembly, in particular, the stability and the total material budget. This paper describes the engineering design and construction of the SCT end-caps, which are required to support mechanically the silicon modules, supply services to them and provide a suitable environment within the inner detector. Critical engineering choices are highlighted and innovative solutions are presented - these will be of interest to other builders of large-scale tracking detectors. The SCT end-caps will be fully connected at the start of 2008. Further commissioning will continue, to be ready for proton-proton collision data in 2008.
|
|
3. |
- Abdallah, J., et al.
(author)
-
Di-jet production in gamma gamma collisions at LEP2
- 2008
-
In: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044 .- 1434-6052. ; C:58, s. 531-541
-
Journal article (peer-reviewed)
|
|
4. |
- Abdallah, J., et al.
(author)
-
Higgs boson searches in CP-conserving and CP-violating MSSM scenarios with the DELPHI detector
- 2008
-
In: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044 .- 1434-6052. ; C:54, s. 1-35
-
Journal article (peer-reviewed)abstract
- This paper presents the final interpretation of the results from DELPHI on the searches for Higgs bosons in the minimal supersymmetric extension of the Standard Model (MSSM). A few representative scenarios are considered, that include CP conservation and explicit CP violation in the Higgs sector. The experimental results encompass the searches for neutral Higgs bosons at LEP1 and LEP2 in final states as expected in the MSSM, as well as LEP2 searches for charged Higgs bosons and for neutral Higgs bosons decaying into hadrons independent of the quark flavour. The data reveal no significant excess with respect to background expectations. The results are translated into excluded regions of the parameter space in the various scenarios. In the CP-conserving case, these lead to limits on the masses of the lightest scalar and pseudoscalar Higgs bosons, h and A, and on tan beta. The dependence of these limits on the top quark mass is discussed. Allowing for CP violation reduces the experimental sensitivity to Higgs bosons. It is shown that this effect depends strongly on the values of the parameters responsible for CP violation in the Higgs sector.
|
|
5. |
- Abdallah, J., et al.
(author)
-
Study of b-quark mass effects in multijet topologies with the DELPHI detector at LEP
- 2008
-
In: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044 .- 1434-6052. ; C:55, s. 525-538
-
Journal article (peer-reviewed)abstract
- The effect of the heavy b-quarkmass on the two, three and four-jet rates is studied using LEP data collected by the DELPHI experiment at the Z peak in 1994 and 1995. The rates of b-quark jets and light quark jets (l = uds) in events with n = 2, 3, and 4 jets, together with the ratio of two and four-jet rates of b-quarks with respect to light-quarks, R-n(bl), have been measured with a double-tag technique using the CAMBRIDGE jet-clustering algorithm. A comparison between experimental results and theory (matrix element or Monte Carlo event generators such as PYTHIA, HERWIG andARIADNE) is done after the hadronisation phase. Using the four-jet observabl R-4(bl), a measurement of the b-quark mass using massive leading-order calculations gives: m(b)(M-Z) = 3.76 +/- 0.32 (stat) +/- 0.17 (syst) +/- 0.22 (had) +/- 0.90 (theo) GeV/c(2). This result is compatible with previous three-jet determinations at the M-Z energy scale and with low energy mass measurements evolved to the M-Z scale using QCD renormalisation group equations.
|
|
6. |
- Abdallah, J., et al.
(author)
-
Study of W-boson polarisations and triple gauge boson couplings in the reaction e(+)e(-)-> W+W- at LEP 2
- 2008
-
In: European Physical Journal C. - : Springer Science and Business Media LLC. - 1434-6044 .- 1434-6052. ; C:54, s. 345-364
-
Journal article (peer-reviewed)abstract
- A determination of the single W spin density matrix (SDM) elements in the reaction e(+)e(-) -> W+W--> l nu q (q) over bar (l=e/mu) is reported at centre-of-mass energies between 189 and 209GeV. The data sample used corresponds to an integrated luminosity of 520pb(-1) taken by DELPHI between 1998 and 2000. The single W SDM elements, rho(W +/-)(tau tau') (tau,tau'=+/- 1 or 0), are determined as a function of the W- production angle with respect to the e(-) beam direction and are obtained from measurements of the W decay products by the application of suitable projection operators, Lambda(tau tau'), which assume the V-A coupling of the W-boson to fermions. The measured SDM elements are used to obtain the fraction of longitudinally polarised Ws, with the result: sigma(L)/sigma(tot) = 24.9 +/- 4.5 (stat) +/- 2.2 (syst)% at a mean energy of 198 GeV. The SDM elements are also used to determine the triple gauge couplings Delta g(1)(Z), Delta kappa(gamma), lambda(gamma) and g(4)(Z), (kappa) over tilde (Z) and (lambda) over tilde (Z). For the CP-violating couplings the results of single parameter fits are: g(4)(Z) = -0.39(-0.20)(+0.19) (kappa) over tilde (Z) = -0.09(-0.05)(+0.08) (lambda) over tilde (Z) = -0.08 +/- 0.07. The errors are a combination of statistical and systematic errors. All results are consistent with the Standard Model.
|
|
7. |
- Abdallah, J., et al.
(author)
-
Measurement of the mass and width of the W boson in e(+) e(-) collisions at root s=161-209 GeV
- 2008
-
In: European Physical Journal C. - : Springer Science and Business Media LLC. - 1434-6044 .- 1434-6052. ; C:55, s. 1-38
-
Journal article (peer-reviewed)abstract
- A measurement of the W boson mass and width has been performed by the DELPHI collaboration using the data collected during the full LEP2 programme (1996-2000). The data sample has an integrated luminosity of 660 pb(-1) and was collected over a range of centre-of-mass energies from 161 to 209 GeV. Results are obtained by applying the method of direct reconstruction of the mass of the W from its decay products in both the W+W- -> l (nu) over bar (l) and W+W- -> q (q) over bar'(q) over barq'channels. The W mass result for the combined data set is M-W = 80.336 +/- 0.055(Stat.) +/- 0.028(Syst.) +/- 0.025(FSI) +/- 0.009(LEP) GeV/c(2) , where FSI represents the uncertainty due to final state interaction effects in the q (q) over bar'(q) over barq' channel, and LEP represents that arising from the knowledge of the collision energy of the accelerator. The combined value for the W width is Gamma(W) = 2.404 +/- 0.140(Stat.) +/- 0.077(Syst.) +/- 0.065(FSI) GeV/c(2). These results supersede all values previously published by the DELPHI collaboration.
|
|
8. |
- Abdallah, J., et al.
(author)
-
Measurement of the tau lepton polarisation at LEP2
- 2008
-
In: Physics Letters. Section B: Nuclear, Elementary Particle and High-Energy Physics. - : Elsevier BV. - 0370-2693 .- 1873-2445. ; 659:1-2, s. 65-73
-
Journal article (peer-reviewed)abstract
- A first measurement of the average polarisation P-tau of tau leptons produced in e(+)e(-) annihilation at energies significantly above the Z resonance is presented. The polarisation is determined from the kinematic spectra of tau hadronic decays. The measured value P-tau = -0.164 +/- 0.125 is consistent with the Standard Model prediction for the mean LEP energy of 197 GeV. (c) 2007 Elsevier B.V. All rights reserved.
|
|
9. |
- Abdallah, J, et al.
(author)
-
Observation of the muon inner bremsstrahlung at LEP1
- 2008
-
In: European Physical Journal C. - : Springer Science and Business Media LLC. - 1434-6044 .- 1434-6052. ; C:57, s. 499-514
-
Journal article (peer-reviewed)abstract
- Muon bremsstrahlung photons converted in front of the DELPHI main tracker (TPC) in dimuon events at LEP1 were studied in two photon kinematic ranges: 0.2< E-gamma <= 1 GeV and transverse momentum with respect to the parent muon p(T) < 40 MeV/c, and 1< E-gamma <= 10 GeV and pT < 80 MeV/c. A good agreement of the observed photon rate with predictions from QED for the muon inner bremsstrahlung was found, contrary to the anomalous soft photon excess that has been observed recently in hadronic Z(0) decays. The obtained ratios of the observed signal to the predicted level of the muon bremsstrahlung are 1.06 +/- 0.12 +/- 0.07 in the photon energy range 0.2< E-gamma <= 1 GeV and 1.04 +/- 0.09 +/- 0.12 in the photon energy range 1< E-gamma <= 10 GeV. The bremsstrahlung dead cone is observed for the first time in the direct photon production at LEP.
|
|
10. |
- Pischon, T., et al.
(author)
-
General and Abdominal Adiposity and Risk of Death in Europe
- 2008
-
In: New England Journal of Medicine. - 0028-4793. ; 359:20, s. 2105-2120
-
Journal article (peer-reviewed)abstract
- BACKGROUND Previous studies have relied predominantly on the body-mass index (BMI, the weight in kilograms divided by the square of the height in meters) to assess the association of adiposity with the risk of death, but few have examined whether the distribution of body fat contributes to the prediction of death. METHODS We examined the association of BMI, waist circumference, and waist-to-hip ratio with the risk of death among 359,387 participants from nine countries in the European Prospective Investigation into Cancer and Nutrition (EPIC). We used a Cox regression analysis, with age as the time variable, and stratified the models according to study center and age at recruitment, with further adjustment for educational level, smoking status, alcohol consumption, physical activity, and height. RESULTS During a mean follow-up of 9.7 years, 14,723 participants died. The lowest risks of death related to BMI were observed at a BMI of 25.3 for men and 24.3 for women. After adjustment for BMI, waist circumference and waist-to-hip ratio were strongly associated with the risk of death. Relative risks among men and women in the highest quintile of waist circumference were 2.05 (95% confidence interval [CI], 1.80 to 2.33) and 1.78 (95% CI, 1.56 to 2.04), respectively, and in the highest quintile of waist-to-hip ratio, the relative risks were 1.68 (95% CI, 1.53 to 1.84) and 1.51 (95% CI, 1.37 to 1.66), respectively. BMI remained significantly associated with the risk of death in models that included waist circumference or waist-to-hip ratio (P<0.001). CONCLUSIONS These data suggest that both general adiposity and abdominal adiposity are associated with the risk of death and support the use of waist circumference or waist-tohip ratio in addition to BMI in assessing the risk of death.
|
|