| 1. |
- Baveja, Prashant, 1985, et al.
(författare)
-
Impact of device parameters on thermal performance of high speed oxide confined 850 nm VCSELs
- 2012
-
Ingår i: IEEE Journal of Quantum Electronics. - 0018-9197 .- 1558-1713. ; 48:1, s. 17-26
-
Tidskriftsartikel (refereegranskat)abstract
- We study the impact of device parameters, such asinner-aperture diameter and cavity photon lifetime, on thermal rollover mechanisms in 850-nm, oxide-confined, vertical-cavity surface-emitting lasers (VCSELs) designed for high-speed operation. We perform measurements on four different VCSELs of different designs and use our empirical thermal model for calculating the power dissipated with increasing bias currents through various physical processes such as absorption within the cavity, carrier thermalization, carrier leakage, spontaneous carrier recombination, and Joule heating. When reducing the topmirror reflectivity to reduce internal optical absorption loss we find an increase of power dissipation due to carrier leakage. There is therefore a trade-ff between the powers dissipated owing to optical absorption and carrier leakage in the sense that overcompensating for optical absorption enhances carrier leakage (and vice versa). We further find that carrier leakage places the ultimate limit on the thermal performance for this entire class ofdevices. Our analysis yields useful design optimization strategies for mitigating the impact of carrier leakage and should thereby prove useful for the performance enhancement of 850-nm, highspeed, oxide-confined VCSELs.
|
|
| 2. |
- Baveja, P. P., et al.
(författare)
-
Assessment of VCSEL thermal rollover mechanisms from measurements and empirical modeling
- 2011
-
Ingår i: Optics Express. - 1094-4087 .- 1094-4087. ; 19:16, s. 15490-15505
-
Tidskriftsartikel (refereegranskat)abstract
- We use an empirical model together with experimental measurements for studying mechanisms contributing to thermal rollover in vertical-cavity surface-emitting lasers (VCSELs). The model is based on extraction of the temperature dependence of threshold current, internal quantum efficiency, internal optical loss, series resistance and thermal impedance from measurements of output power, voltage and lasing wavelength as a function of bias current over an ambient temperature range of 15-100 degrees C. We apply the model to an oxide-confined, 850-nm VCSEL, fabricated with a 9-mu m inner-aperture diameter and optimized for highspeed operation, and show for this specific device that power dissipation due to linear power dissipation (sum total of optical absorption, carrier thermalization, carrier leakage and spontaneous carrier recombination) exceeds power dissipation across the series resistance (quadratic power dissipation) at any ambient temperature and bias current. We further show that the dominant contributors to self-heating for this particular VCSEL are quadratic power dissipation, internal optical loss, and carrier leakage. A rapid reduction of the internal quantum efficiency at high bias currents (resulting in high temperatures) is identified as being the major cause of thermal rollover. Our method is applicable to any VCSEL and is useful for identifying the mechanisms limiting the thermal performance of the device and to formulate design strategies to ameliorate them.
|
|
| 3. |
- Baveja, P. P., et al.
(författare)
-
Impact of photon lifetime on thermal rollover in 850-nm high-speed VCSELs
- 2012
-
Ingår i: Proceedings of SPIE - The International Society for Optical Engineering. - : SPIE. - 0277-786X .- 1996-756X. - 9780819489197 ; 8276
-
Konferensbidrag (refereegranskat)abstract
- We present an empirical thermal model for VCSELs based on extraction of temperature dependence of macroscopic VCSEL parameters from CW measurements. We apply our model to two, oxide-confined, 850-nm VCSELs, fabricated with a 9-mu m inner-aperture diameter and optimized for high-speed operation. We demonstrate that for both these devices, the power dissipation due to linear heat sources dominates the total self-heating. We further show that reducing photon lifetime down to 2 ps drastically reduces absorption heating and improves device static performance by delaying the onset of thermal rollover. The new thermal model can identify the mechanisms limiting the thermal performance and help in formulating the design strategies to ameliorate them.
|
|
| 4. |
- Davani, Hooman A., et al.
(författare)
-
Polarization investigation of a tunable high-speed short-wavelength bulk-micromachined MEMS-VCSEL
- 2012
-
Ingår i: Proceedings of SPIE - The International Society for Optical Engineering. - : SPIE. - 0277-786X .- 1996-756X. - 9780819489197 ; 8276, s. Art. no. 82760T-
-
Konferensbidrag (refereegranskat)abstract
- We report the investigation of the state of polarization (SOP) of a tunable vertical-cavity surface-emitting laser (VCSEL) operating near 850 nm with a mode-hop free single-mode tuning range of about 12 nm and an amplitude modulation bandwidth of about 5 GHz. In addition, the effect of a sub-wavelength grating on the device and its influence on the polarization stability and polarization switching has been investigated. The VCSEL with an integrated sub-wavelength grating shows a stable SOP with a polarization mode suppression ratio (PMSR) more than 35 dB during the tuning.
|
|
| 5. |
- Gierl, Christian, et al.
(författare)
-
Tuneable VCSEL aiming for the application in interconnects and short haul systems
- 2011
-
Ingår i: Proceedings of SPIE - The International Society for Optical Engineering. - : SPIE. - 0277-786X .- 1996-756X. - 9780819484963 ; 7959
-
Konferensbidrag (övrigt vetenskapligt/konstnärligt)abstract
- Widely tunable vertical cavity surface emitting lasers (VCSEL) are of high interest for optical communications, gas spectroscopy and fiber-Bragg-grating measurements. In this paper we present tunable VCSEL operating at wavelength around 850 nm and 1550 nm with tuning ranges up to 20 nm and 76 nm respectively. The first versions of VCSEL operating at 1550 nm with 76 nm tuning range and an output power of 1.3mW were not designed for high speed modulation, but for applications where only stable continious tuning is essential (e.g. gas sensing). The next step was the design of non tunable VCSEL showing high speed modulation frequencies of 10 GHz with side mode supression ratios beyond 50 dB. The latest version of these devices show record output powers of 6.7mW at 20 °C and 3mW at 80 °C. The emphasis of our present and future work lies on the combination of both technologies. The tunable VCSEL operating in the 850 nm-region reaches a modulation bandwidth of 5.5GHz with an output power of 0.8mW.
|
|
| 6. |
- Gustavsson, Johan, 1974, et al.
(författare)
-
High-speed 850-nm VCSELs for 40 Gb/s transmission
- 2010
-
Konferensbidrag (övrigt vetenskapligt/konstnärligt)abstract
- We have explored the possibility to extend the data transmission rate for standard 850-nm GaAs-based VCSELs beyond the 10 Gbit/s limit of today's commercially available directly-modulated devices. By sophisticated tailoring of the design for high-speed performance we demonstrate that 10 Gb/s is far from the upper limit. For example, the thermal conductivity of the bottom mirror is improved by the use of binary compounds, and the electrical parasitics are kept at a minimum by incorporating a large diameter double layered oxide aperture in the design. We also show that the intrinsic high speed performance is significantly improved by replacing the traditional GaAs QWs with strained InGaAs QWs in the active region. The best overall performance is achieved for a device with a 9 μm diameter oxide aperture, having in a threshold current of 0.6 mA, a maximum output power of 9 mW, a thermal resistance of 1.9 °C/mW, and a differential resistance of 80 Ω. The measured 3dB bandwidth exceeds 20 GHz, and we experimentally demonstrate that the device is capable of error-free transmission (BER
|
|
| 7. |
- Gustavsson, Johan, 1974, et al.
(författare)
-
High speed 850nm VCSELs for >40Gb/s transmission
- 2013
-
Ingår i: 2013 Optical Fiber Communication Conference and Exposition and the National Fiber Optic Engineers Conference, OFC/NFOEC 2013. - 9781479904570 ; , s. OTh4H.4-
-
Konferensbidrag (refereegranskat)abstract
- VCSELs capable of direct modulation exceeding 40Gb/s are needed in next generation optical interconnect standards. Using a refined high-speed design we demonstrate GaAs-based VCSELs having record-high 28GHz modulation bandwidth, and that operate error-free at 47Gb/s.
|
|
| 8. |
- Gustavsson, Johan, 1974, et al.
(författare)
-
High-speed, high-temperature VCSELs for optical interconnects
- 2013
-
Ingår i: 2013 IEEE Photonics Society Summer Topical Meeting Series, PSSTMS 2013. - 9781467350600 ; , s. 7-8
-
Konferensbidrag (refereegranskat)abstract
- Directly modulated VCSELs operating at 40Gb/s are required for next generation optical interconnect standards. Using a refined high-speed design we demonstrate GaAs-based VCSELs that operate error-free at 47Gb/s at 25°C, and 40Gb/s at 85°C.
|
|
| 9. |
- Haglund, Erik, 1985, et al.
(författare)
-
25 Gbit/s transmission over 500 m multimode fibre using 850 nm VCSEL with integrated mode filter
- 2012
-
Ingår i: Electronics Letters. - : Institution of Engineering and Technology (IET). - 1350-911X .- 0013-5194. ; 48:9, s. 517-518
-
Tidskriftsartikel (refereegranskat)abstract
- An integrated mode filter in the form of a shallow surface relief was used to reduce the spectral width of a high-speed 850 nm vertical-cavity surface-emitting laser (VCSEL). The mode filter reduced the RMS spectral width from 0.9 to 0.3 nm for a VCSEL with an oxide aperture as large as 5 mu m. Because of reduced effects of chromatic and modal fibre dispersion, the mode filter significantly increases the maximum error-free (bit error rate
|
|
| 10. |
- Haglund, Erik, 1985, et al.
(författare)
-
850 nm datacom VCSELs for higher-speed and longer-reach transmission
- 2013
-
Ingår i: European VCSEL Day 2013.
-
Konferensbidrag (refereegranskat)abstract
- The 850 nm GaAs-based VCSEL is already the dominating technology for transmitters in optical interconnects up to 100 m in datacenters, thanks to low-cost fabrication, excellent high-speed properties at low currents and the existence of high-speed OM4 multimode fiber optimized for this particular wavelength. Future datacenters will require faster and more energy-efficient VCSELs to increase the overall bandwidth and reduce the power consumption of the datacenter network. In addition, longer-reach interconnects exceeding 1 km will also be required as datacenters grow into large multi-building complexes.By optimizing the doping profiles of the DBRs to reduce resistance, using a short (½-λ) cavity to improve longitudinal optical confinement and optimizing the photon lifetime for optimal damping, we obtained a record-high small-signal modulation bandwidth of 28 GHz for a ~4 µm oxide aperture VCSEL. A 7 µm oxide aperture VCSEL (~27 GHz bandwidth) enabled error-free transmission (bit-error-rate 300 m), the large spectral width of VCSELs leads to severe signal degradation by fiber dispersion. We have investigated two methods of fabricating low-spectral width quasi-single mode VCSELs to mitigate this problem. By using a small oxide aperture of ~3 µm, error-free transmission was achieved at 22 Gbit/s over 1.1 km of OM4 fiber. An alternative approach is to use an integrated mode filter in the form of a shallow surface relief to reduce the spectral width of the VCSEL. The mode filter allows for the use of a larger oxide aperture and thereby enables a lower resistance and operation at a lower current density. A 5 µm oxide aperture VCSEL with a mode filter enabled error-free transmission at 25 Gbit/s over 500 m of OM4 fiber.
|
|
