| 1. |
- Fredenberg, Erik, 1979-
(författare)
-
Spectral Mammography with X-Ray Optics and a Photon-Counting Detector
- 2009
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- Early detection is vital to successfully treating breast cancer, and mammography screening is the most efficient and wide-spread method to reach this goal. Imaging low-contrast targets, while minimizing the radiation exposure to a large population is, however, a major challenge. Optimizing the image quality per unit radiation dose is therefore essential. In this thesis, two optimization schemes with respect to x-ray photon energy have been investigated: filtering the incident spectrum with refractive x-ray optics (spectral shaping), and utilizing the transmitted spectrum with energy-resolved photon-counting detectors (spectral imaging). Two types of x-ray lenses were experimentally characterized, and modeled using ray tracing, field propagation, and geometrical optics. Spectral shaping reduced dose approximately 20% compared to an absorption-filtered reference system with the same signal-to-noise ratio, scan time, and spatial resolution. In addition, a focusing pre-object collimator based on the same type of optics reduced divergence of the radiation and improved photon economy by about 50%. A photon-counting silicon detector was investigated in terms of energy resolution and its feasibility for spectral imaging. Contrast-enhanced tumor imaging with a system based on the detector was characterized and optimized with a model that took anatomical noise into account. Improvement in an ideal-observer detectability index by a factor of 2 to 8 over that obtained by conventional absorption imaging was found for different levels of anatomical noise and breast density. Increased conspicuity was confirmed by experiment. Further, the model was extended to include imaging of unenhanced lesions. Detectability of microcalcifications increased no more than a few percent, whereas the ability to detect large tumors might improve on the order of 50% despite the low attenuation difference between glandular and cancerous tissue. It is clear that inclusion of anatomical noise and imaging task in spectral optimization may yield completely different results than an analysis based solely on quantum noise.
|
|
| 2. |
- Fredenberg, Erik, PhD, 1979-, et al.
(författare)
-
A low-absorption x-ray energy filter for small-scale applications
- 2009
-
Ingår i: Optics Express. - : The Optical Society. - 1094-4087. ; 17:14, s. 11388-11398
-
Tidskriftsartikel (refereegranskat)abstract
- We present an experimental and theoretical evaluation of an x-ray energy filter based on the chromatic properties of a prism-array lens (PAL). It is intended for small-scale applications such as medical imaging. The PAL approximates a Fresnel lens and allows for high efficiency compared to filters based on ordinary refractive lenses, however at the cost of a lower energy resolution. Geometrical optics was found to provide a good approximation for the performance of a flawless lens, but a field-propagation model was used for quantitative predictions. The model predicted a 0.29 ΔE/E energy resolution and an intensity gain of 6.5 for a silicon PAL at 23.5 keV. Measurements with an x-ray tube showed good agreement with the model in energy resolution and peak energy, but a blurred focal line contributed to a 29% gain reduction. We believe the blurring to be caused mainly by lens imperfections, in particular at the periphery of the lens.
|
|
| 3. |
- Liu, Yuanhua, 1971, et al.
(författare)
-
Considering the importance of user profiles in interface design
- 2009
-
Ingår i: User Interfaces. ; , s. 23-
-
Bokkapitel (övrigt vetenskapligt/konstnärligt)abstract
- User profile is a popular term widely employed during product design processes by industrial companies. Such a profile is normally intended to represent real users of a product. The ultimate purpose of a user profile is actually to help designers to recognize or learn about the real user by presenting them with a description of a real user’s attributes, for instance; the user’s gender, age, educational level, attitude, technical needs and skill level. The aim of this chapter is to provide information on the current knowledge and research about user profile issues, as well as to emphasize the importance of considering these issues in interface design. In this chapter, we mainly focus on how users’ difference in expertise affects their performance or activity in various interaction contexts. Considering the complex interaction situations in practice, novice and expert users’ interactions with medical user interfaces of different technical complexity will be analyzed as examples: one focuses on novice and expert users’ difference when interacting with simple medical interfaces, and the other focuses on differences when interacting with complex medical interfaces. Four issues will be analyzed and discussed: (1) how novice and expert users differ in terms of performance during the interaction; (2) how novice and expert users differ in the perspective of cognitive mental models during the interaction; (3) how novice and expert users should be defined in practice; and (4) what are the main differences between novice and expert users’ implications for interface design. Besides describing the effect of users’ expertise difference during the interface design process, we will also pinpoint some potential problems for the research on interface design, as well as some future challenges that academic researchers and industrial engineers should face in practice.
|
|
| 4. |
- Buendia, Ruben, 1982, et al.
(författare)
-
A Novel Approach for Removing the Hook Effect Artefact from Electrical Bioimpedance Spectroscopy Measurements
- 2009
-
Ingår i: Journal of Physics: Conference Series. - : Institute of Physics Publishing Ltd.. - 1742-6596.
-
Konferensbidrag (refereegranskat)abstract
- Very often in Electrical Bioimpedance (EBI) spectroscopy measurements the presence of stray capacitances creates a measurement artefact commonly known as Hook Effect. Such an artefact creates a hook-alike deviation of the EBI data noticeable when representing the measurement on the impedance plane. Such Hook Effect is noticeable at high frequencies but it also causes a data deviation at lower measurement frequencies. In order to perform any accurate analysis of the EBI spectroscopy data, the influence of the Hook Effect must be removed. An established method to compensate the hook effect is the well known Td compensation, which consist on multiplying the obtained spectrum, Zmeas() by a complex exponential in the form of exp[jTd]. Such a method cannot correct entirely the Hook Effect since the hook-alike deviation occurs a broad frequency range in both magnitude and phase of the measured impedance, and by using a real value for Td. First, a real value only modifies the phase of the measured impedance and second, it can only correct the Hook Effect at a single frequency. In addition, the process to select a value for Td by an iterative process with the aim to obtain the best Cole fitting lacks solid scientific grounds. In this work the Td compensation method is revisited and a modified approach for correcting the Hook Effect that includes a novel method for selecting the correcting values is proposed. The initial validation results confirm that the proposed method entirely corrects the Hook Effect at all frequencies.
|
|
| 5. |
- Fredenberg, Erik, PhD, 1979-, et al.
(författare)
-
A Tunable Energy Filter for Medical X-Ray Imaging
- 2008
-
Ingår i: X-Ray Optics and Instrumentation. - : Hindawi. - 1687-7632 .- 1687-7640. ; 2008
-
Tidskriftsartikel (refereegranskat)abstract
- A multiprism lens (MPL) is a refractive X-ray lens, and its chromatic properties can be employed in an energy filtering setup to obtain a narrow tunable X-ray spectrum. We present the first evaluation of such a filter for medical X-ray imaging. The experimental setup yields a 6.6 gain of flux at 20 keV, and we demonstrate tunability by altering the energy spectrum to center also around 17 and 23 keV. All measurements are found to agree well with ray-tracing and a proposed geometrical model. Compared to a model mammography system with absorption filtering, the experimental MPL filter reduces dose 13–25% for 3–7 cm breasts if the spectrum is centered around the optimal energy. Additionally, the resolution is improved 2.5 times for a 5 cm breast. The scan time is increased 3 times but can be reduced with a slightly decreased energy filtering and resolution.
|
|
| 6. |
- Eklund, Anders, et al.
(författare)
-
Evaluation of applanation resonator sensors for intra-ocular pressure measurement : results from clinical and in vitro studies.
- 2003
-
Ingår i: Medical and Biological Engineering and Computing. - 0140-0118 .- 1741-0444. ; 41:2, s. 190-197
-
Tidskriftsartikel (refereegranskat)abstract
- Glaucoma is an eye disease that, in its most common form, is characterised by high intra-ocular pressure (IOP), reduced visual field and optic nerve damage. For diagnostic purposes and for follow-up after treatment, it is important to have simple and reliable methods for measuring IOP. Recently, an applanation resonator sensor (ARS) for measuring IOP was introduced and evaluated using an in vitro pig-eye model. In the present study, the first clinical evaluation of the same probe has been carried out, with experiments in vivo on human eyes. There was a low but significant correlation between IOP(ARS) and the IOP measured with a Goldmann applanation tonometer (r = 0.40, p = 0.001, n = 72). However, off-centre positioning of the sensor against the cornea caused a non-negligible source of error. The sensor probe was redesigned to have a spherical, instead of flat, contact surface against the eye and was evaluated in the in vitro model. The new probe showed reduced sensitivity to off-centre positioning, with a decrease in relative deviation from 89% to 11% (1 mm radius). For normalised data, linear regression between IOP(ARS) and direct IOP measurement in the vitreous chamber showed a correlation of r = 0.97 (p < 0.001, n = 108) and a standard deviation for the residuals of SD < or = 2.18 mm Hg (n = 108). It was concluded that a spherical contact surface should be preferred and that further development towards a clinical instrument should focus on probe design and signal analysis.
|
|
| 7. |
- Munthe, Christian, 1962
(författare)
-
Etiska aspekter på regenerativ medicin : Ethical aspects on regenerative medicine
- 2003
-
Ingår i: SNIB-konferensen 2003, Chalmers tekniska högskola, Göteborg, 16-18 maj 2003.
-
Konferensbidrag (övrigt vetenskapligt/konstnärligt)abstract
- Inom den regenerativa medicinen strävar man efter att ersätta skadat eller sjukligt biologiskt mänskligt material (celler, organ, kroppsdelar) med nya biologiska komponenter. Området aktualiserar en rad etiska frågeställningar vad gäller (1) produktionen av ersättningsmaterialet (t.ex. embryonala stamceller eller införskaffande av transplantationsvävnad från donatorer), (2) risker i samband med försök på människa (genmodifierat material, material från djur), samt (3) gränserna för hur långt man bör gå i denna slags försök att förlänga människans livsspann. Föredraget ger en kort översikt över dessa frågeställningar, ståndpunkter och argument i debatten kring dem.
|
|
| 8. |
|
|
| 9. |
|
|
| 10. |
|
|
