| 1. |
|
|
| 2. |
|
|
| 3. |
- Kraemer, B. K., et al.
(författare)
-
Efficacy of Prolonged- and Immediate-release Tacrolimus in Kidney Transplantation : A Pooled Analysis of Two Large, Randomized, Controlled Trials
- 2017
-
Ingår i: Transplantation Proceedings. - : Elsevier BV. - 0041-1345 .- 1873-2623. ; 49:9, s. 2040-2049
-
Tidskriftsartikel (refereegranskat)abstract
- Background. Two large, prospective studies (12-03; OSAKA) compared the efficacy and tolerability of prolonged-release versus immediate-release tacrolimus in kidney transplant patients also receiving mycophenolate mofetil and low-dose corticosteroids (without induction therapy). Methods. Data were combined into one database to compare results over 24 weeks using 3 alternative endpoints: biopsy-confirmed acute rejection (BCAR); the Food and Drug Administration composite endpoint (graft loss, SCAR, and loss to follow-up), and the European Medicines Agency composite endpoint (graft loss, BCAR, and graft dysfunction). The 95% confidence intervals were calculated (10% noninferiority margin). Results. Overall, 633 patients received prolonged-release tacrolimus (12-03, n = 331; OSAKA, n = 302) and 645 received immediate-release tacrolimus (n = 336; n = 309). Baseline characteristics were comparable. Proportionately more patients receiving prolonged-release tacrolimus had trough levels of 5-15 ng/mL on day 1 (60.8%) and 2 (56.6%) versus immediate-release tacrolimus (42.5% and 43.9%, respectively, both P < .001). Efficacy of prolonged-release and immediate-release tacrolimus were similar as assessed by BCAR (13.9% vs 14.1%, respectively), European Medicines Agency composite endpoint (40.3% vs 38.3%) and US Food and Drug Administration composite endpoint (21.5% vs 19.8%). Conclusions. Novel efficacy endpoints as required by the European Medicines Agency and US Food and Drug Administration demonstrate noninferiority of prolonged-release versus immediate-release tacrolimus. Significantly more patients treated with prolonged release tacrolimus versus immediate-release tacrolimus achieved trough levels of 5 to 15 ng/mL early after transplantation.
|
|
| 4. |
- Matsushita, Taishi, et al.
(författare)
-
On the specific heat and thermal diffusivity of CGI and SGI cast irons
- 2017
-
Ingår i: International Journal of Cast Metals Research. - : Maney Publishing. - 1364-0461 .- 1743-1336. ; 30:5, s. 276-282
-
Tidskriftsartikel (refereegranskat)abstract
- The specific heat and thermal diffusivity of Compacted Graphite Iron (CGI) and Spheroidal Graphite Iron (SGI) were measured at temperatures ranging between 373 and 773 K (100 and 500 °C) using differential scanning calorimetry (DSC) and between 298 and 773 K (25 and 500 °C) using the laser flash method, respectively. Specific heat increased with increasing amounts of graphite and pearlite, as well as with Si content. As a recommended value of the specific heat for fully ferritic high-silicon SGI, the following relation was suggested:(Formula presented.) where T is the temperature in Celsius, (Formula presented.) is the mass% of Si, and fg is the area fraction of graphite (%). The thermal diffusivity of cast irons tends to increase with increasing amounts of graphite, and decrease with greater nodularity. It was found that nodularity had a strong influence on thermal diffusivity in the nodularity range of 15–30%.
|
|
| 5. |
- Matsushita, Taishi, et al.
(författare)
-
On the thermal conductivity of CGI and SGI cast irons
- 2018
-
Ingår i: International Journal of Cast Metals Research. - : Maney Publishing. - 1364-0461 .- 1743-1336. ; 31:3, s. 135-143
-
Tidskriftsartikel (refereegranskat)abstract
- The thermal conductivity of Compacted Graphite Iron (CGI) and spheroidal graphite iron (SGI) was established in the temperature range from room temperature up to 500 °C using the experimental thermal diffusivity, density and specific heat values. The influence of nodularity, graphite amount, silicon content and temperature on the thermal conductivity of fully ferritic high-silicon cast irons was investigated. It was found that the CGI materials showed higher thermal conductivity than the SGI materials. The thermal conductivity tended to increase with increasing temperature until it reached a maximum followed by a subsequent decrease as temperature was increased up to 500 °C. Conventional models were applied to estimate thermal conductivity and the predictive accuracy of each model was evaluated. The thermal conductivity could be estimated by the Helsing model. The Maxwell model, Bruggeman model and Hashin–Shtrikman model were also in fair agreement using the thermal conductivity value of graphite parallel to the basal planes in graphite.
|
|
| 6. |
- Matsushita, Taishi, et al.
(författare)
-
On Thermal Expansion and Density of CGI and SGI Cast Irons
- 2015
-
Ingår i: Metals. - : MDPI AG. - 2075-4701. ; 5:2, s. 1000-1019
-
Tidskriftsartikel (refereegranskat)abstract
- The thermal expansion and density of Compacted Graphite Iron (CGI) and Spheroidal Graphite Iron (SGI) were measured in the temperature range of 25–500 °C using push-rod type dilatometer. The coefficient of the thermal expansion (CTE) of cast iron can be expressed by the following equation: CTE = 1.38 × 10−5 + 5.38 × 10−8 N − 5.85 × 10−7 G + 1.85 × 10−8 T − 2.41 × 10−6 RP/F − 1.28 × 10−8 NG − 2.97 × 10−7 GRP/F + 4.65 × 10−9 TRP/F + 1.08 × 10−7 G2 − 4.80 × 10−11 T2 (N: Nodularity, G: Area fraction of graphite (%), T: Temperature (°C), RP/F: Pearlite/Ferrite ratio in the matrix).
|
|
