| 1. |
|
|
| 2. |
- Abdesselam, A., et al.
(författare)
-
The ATLAS semiconductor tracker end-cap module
- 2007
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 575:3, s. 353-389
-
Tidskriftsartikel (refereegranskat)abstract
- The challenges for the tracking detector systems at the LHC are unprecedented in terms of the number of channels, the required read-out speed and the expected radiation levels. The ATLAS Semiconductor Tracker. (SCT) end-caps have a total of about 3 million electronics channels each reading out every 25 ns into its own on-chip 3.3 mu s buffer. The highest anticipated dose after 10 years operation is 1.4x10(14) cm(-2) in units of 1 MeV neutron equivalent (assuming the damage factors scale with the non-ionising energy loss). The forward tracker has 1976 double-sided modules, mostly of area similar to 70 cm(2), each having 2 x 768 strips read out by six ASICs per side. The requirement to achieve an average perpendicular radiation length of 1.5% X-0, while coping with up to 7 W dissipation per module (after irradiation), leads to stringent constraints on the thermal design. The additional requirement of 1500e(-) equivalent noise charge (ENC) rising to only 1800e(-) ENC after irradiation, provides stringent design constraints on both the high-density Cu/Polyimide flex read-out circuit and the ABCD3TA read-out ASICs. Finally, the accuracy of module assembly must not compromise the 16 mu m (r phi) resolution perpendicular to the strip directions or 580 mu m radial resolution coming from the 40 mrad front-back stereo angle. A total of 2210 modules were built to the tight tolerances and specifications required for the SCT. This was 234 more than the 1976 required and represents a yield of 93%. The component flow was at times tight, but the module production rate of 40-50 per week was maintained despite this. The distributed production was not found to be a major logistical problem and it allowed additional flexibility to take advantage of where the effort was available, including any spare capacity, for building the end-cap modules. The collaboration that produced the ATLAS SCT end-cap modules kept in close contact at all times so that the effects of shortages or stoppages at different sites could be rapidly resolved.
|
|
| 3. |
|
|
| 4. |
- Abdesselam, A., et al.
(författare)
-
The barrel modules of the ATLAS semiconductor tracker
- 2006
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 568:2, s. 642-671
-
Tidskriftsartikel (refereegranskat)abstract
- This paper describes the silicon microstrip modules in the barrel section of the SemiConductor Tracker (SCT) of the ATLAS experiment at the CERN Large Hadron Collider (LHC). The module requirements, components and assembly techniques are given, as well as first results of the module performance on the fully assembled barrels that make up the detector being installed in the ATLAS experiment.
|
|
| 5. |
- Aad, G., et al.
(författare)
-
The ATLAS Experiment at the CERN Large Hadron Collider
- 2008
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 3:S08003
-
Forskningsöversikt (refereegranskat)abstract
- The ATLAS detector as installed in its experimental cavern at point 1 at CERN is described in this paper. A brief overview of the expected performance of the detector when the Large Hadron Collider begins operation is also presented.
|
|
| 6. |
- Alonso-Fernandez, Fernando, et al.
(författare)
-
Iris Recognition Based on SIFT Features
- 2009
-
Ingår i: 2009 First IEEE International Conference on Biometrics, Identity and Securit. - 9781424452767 ; , s. 1-8
-
Konferensbidrag (refereegranskat)abstract
- Biometric methods based on iris images are believed to allow very high accuracy, and there has been an explosion of interest in iris biometrics in recent years. In this paper, we use the Scale Invariant Feature Transformation (SIFT) for recognition using iris images. Contrarily to traditional iris recognition systems, the SIFT approach does not rely on the transformation of the iris pattern to polar coordinates or on highly accurate segmentation, allowing less constrained image acquisition conditions. We extract characteristic SIFT feature points in scale space and perform matching based on the texture information around the feature points using the SIFT operator. Experiments are done using the BioSec multimodal database, which includes 3,200 iris images from 200 individuals acquired in two different sessions. We contribute with the analysis of the influence of different SIFT parameters on the recognition performance. We also show the complementarity between the SIFT approach and a popular matching approach based on transformation to polar coordinates and Log-Gabor wavelets. The combination of the two approaches achieves significantly better performance than either of the individual schemes, with a performance improvement of 24% in the Equal Error Rate.
|
|
| 7. |
|
|
| 8. |
- Campoy-Quiles, M., et al.
(författare)
-
On the determination of anistropy in polymer thin films : A comparative study of optical techniques
- 2008
-
Ingår i: Physica Status Solidi. C: Current Topics in Solid State Physics. - Weinheim, Germany : Wiley-VCH Verlagsgesellschaft. - 1862-6351. ; 5:5, s. 1270-1273
-
Tidskriftsartikel (refereegranskat)abstract
- We have used seven different techniques to measure the anisotropic refractive index of poly(vinylcarbazole) films. These techniques are: two types of variable angle spectroscopic ellipsometry (VASE) with multiple sample analysis, Interference enhanced VASE, Transmittance combined with VASE, Polarised Reflectance, beta-scan VASE, and prism coupling. We have found the average ordinary and extraordinary indices at 633 nm to be no = nTE = 1.675 ± 0.008, and ne = nTM = 1.722 ± 0.018, respectively, consistent amongst methods and conclusive on the magnitude of Δn in polymer films.
|
|
| 9. |
- Ferwerda, Bart, et al.
(författare)
-
Functional and genetic evidence that the Mal/TIRAP allele variant 180L has been selected by providing protection against septic shock.
- 2009
-
Ingår i: Proceedings of the National Academy of Sciences of the United States of America. - : Proceedings of the National Academy of Sciences. - 0027-8424 .- 1091-6490. ; 106:25, s. 10272-10277
-
Tidskriftsartikel (refereegranskat)abstract
- Adequate responses by our innate immune system toward invading pathogens were of vital importance for surviving infections, especially before the antibiotic era. Recently, a polymorphism in Mal (Ser180Leu, TIRAP rs8177374), an important adaptor protein downstream of the Toll-like receptor (TLR) 2 and 4 pathways, has been described to provide protection against a broad range of infectious pathogens. We assessed the functional effects of this polymorphism in human experimental endotoxemia, and we demonstrate that individuals bearing the TIRAP 180L allele display an increased, innate immune response to TLR4 and TLR2 ligands, but not to TLR9 stimulation. This phenotype has been related to an increased resistance to infection. However, an overshoot in the release of proinflammatory cytokines by TIRAP 180L homozygous individuals suggests a scenario of balanced evolution. We have also investigated the worldwide distribution of the Ser180Leu polymorphism in 14 populations around the globe to correlate the genetic makeup of TIRAP with the local infectious pressures. Based on the immunological, clinical, and genetic data, we propose that this mutation might have been selected in West Eurasia during the early settlement of this region after the out-of-Africa migration of modern Homo sapiens. This combination of functional and genetic data provides unique insights to our understanding of the pathogenesis of sepsis.
|
|
| 10. |
|
|
