| 1. |
- Markenroth, Karin, 1973, et al.
(författare)
-
Crossing the dripline to N-11 using elastic resonance scattering
- 2000
-
Ingår i: Physical Review C - Nuclear Physics. - 2469-9985 .- 2469-9993. ; 6203:3
-
Tidskriftsartikel (refereegranskat)abstract
- The level structure of the unbound nucleus N-11 has been studied by C-10+p elastic resonance scattering in inverse geometry with the LISE3 spectrometer at GANIL, using a C-10 beam with an energy of 9.0 MeV/ nucleon. An additional measurement was done at the A1200 spectrometer at MSU. The excitation function above the C-10+p threshold has been determined up to 5 MeV. A potential-model analysis revealed three resonance states at energies 1.27(-0.05)(+0.18) MeV (Gamma = 1.44 +/- 0.2 MeV), 2.01(-0.05)(+0.15) MeV (Gamma = 0.84 +/- 0.2 MeV), and 3.75 +/- 0.05 MeV (Gamma = 0.60 +/- 0.05 MeV) with the spin-parity assignments I-pi=1/2+,1/2,-,5/2+, respectively. Hence, N-11 is shown to have a ground state parity inversion completely analogous to its mirror partner Be-11. A narrow resonance in the excitation function at 4.33 +/- 0.05 MeV was also observed and assigned spin parity 3/2-.
|
|
| 2. |
- Appelblad, P.K., et al.
(författare)
-
Sources of uncertainty in isotope ratio measurements by inductively coupled plasma mass spectrometry
- 2001
-
Ingår i: Analytical Chemistry. - : American Chemical Society (ACS). - 0003-2700 .- 1520-6882. ; 73:13, s. 2911-2919
-
Tidskriftsartikel (refereegranskat)abstract
- A model is presented describing the effects of dead time and mass bias correction factor uncertainties, flicker noise, and counting statistics on isotope ratio measurement precision using inductively coupled plasma mass spectrometry (ICPMS) with a single collector. Noise spectral analysis is exploited to enable estimation of the flicker noise parameters. For the instrument used, the flicker noise component exhibited a fairly weak frequency (f) dependence ( f -0.33±0.12), but was directly proportional to the total number of counts, Q. As white noise, determined by counting statistics, is given by Q0.5, the isotope ratio measurement uncertainties will actually cease to improve when Q exceeds a certain threshold. This would suggest that flicker noise could become the limiting factor for the precision with which isotope ratios can be determined by ICPMS. However, under most experimental conditions, uncertainties associated with mass discrimination and dead time correction factors are decisive. For ratios up to ~22 (115In/113In), optimum major isotope count rates are generally below 0.3 MHz, for which precision in the mass discrimination factor is limiting. The model derived could be used as a starting point for determining optimum conditions and understanding the limitations of single-collector ICPMS for precise isotope ratio measurements.
|
|
| 3. |
- Appelblad, Petra K., et al.
(författare)
-
The use of Pt guard electrode in inductively coupled plasma sectorÆeld mass spectrometry: advantages and limitations
- 2000
-
Ingår i: Journal of Analytical Atomic Spectrometry. - : Royal Society of Chemistry (RSC). - 0267-9477 .- 1364-5544. ; 15:4, s. 359-364
-
Tidskriftsartikel (refereegranskat)abstract
- Performance characteristics of inductively coupled plasma sector field mass spectrometry (ICP-SFMS) were studied with a Pt guard electrode (GE) inserted between the torch and load coil. The importance of the optimisation procedure and the matrix effects caused by a seawater matrix were assessed for 20 elements. Oxide and doubly charged ion formation was also investigated. Use of the GE allows a significant increase in ion transmission, by a factor of three to 20, thus resulting in improved instrumental detection limits. The improvement in sensitivity is mass dependent, with the highest gain observed for lower mass elements. Since, for the majority of analytical applications, actual detection limits depend upon blank levels rather on instrumental sensitivity, the most important factor for the determination of elements at ultra-trace levels is the degree of contamination of reagents and containers used. At the same time, significantly greater oxide formation is observed when operating the GE grounded rather than in the floating mode. For example, the BaO+/Ba+ ratio is ten to twelve times higher in the grounded mode. This calls for compromised instrumental parameters and the potential for severe spectral interferences from oxide species, which are often unresolved, even in high-resolution mode. Furthermore, non-spectral interferences from the seawater matrix appear to be more pronounced with the grounded GE, yielding a recovery of Ni of 55% compared with 93% in the floating GE mode. Hence all possible advantages and limitations of the use of the GE should be carefully considered prior to the analysis of real samples.
|
|
| 4. |
|
|
| 5. |
|
|
