| 1. |
|
|
| 2. |
- Blom, Åsa, et al.
(författare)
-
Durability of Untreated Norway Spruce (Picea abies) Exposed Outdoors Above Ground for Nine Years.
- 2004
-
Ingår i: Holzforschung. - 0018-3830 .- 1437-434X. ; 58:2, s. 167-172
-
Tidskriftsartikel (refereegranskat)abstract
- Moisture dynamics and durability during weather exposure as affected by origin and production method were studied for nine years on 113 untreated spruce samples. The moisture content was measured on 67 occasions. The weight loss was determined for each sample at the end of the sampling period. The most important factors, affecting both moisture content and weight loss, were origin and drying technique. The samples originating from central Sweden had the best durability, followed by the southern stand, while the northern stand had the lowest durability in terms of weight loss. Airdrying had a negative impact on the performance of samples from all three stands, but to different degrees. Samples from the northern stand were most sensitive to airdrying, in terms of both weight loss and moisture content, followed by the southern stand, while the central stand was least sensitive. Why the samples from the northern stand were more sensitive to airdrying and showed the largest weight losses is unknown; it can only be suggested that the origin of the wood can be of importance for the durability.
|
|
| 3. |
- Lorin, Stefan, et al.
(författare)
-
Development of a compact proton scanning system in Uppsala with a moveable second magnet
- 2000
-
Ingår i: Physics in Medicine and Biology. - : IOP Publishing. - 0031-9155 .- 1361-6560. ; 45, s. 1151-
-
Tidskriftsartikel (refereegranskat)abstract
- A scanned proton beam yields dose distributions that in most cases are superior to passively scattered proton beams and to other external radiation treatment modalities. The present paper gives a description of the scanning system that has been developed at the Svedberg Laboratory (TSL) in Uppsala. The scanning technique and the technical design are described. The solution with a small pole gap of the magnets and a moveable second magnet results in a very compact scanning head, which can therefore be incorporated in a gantry of relatively limited size. A prototype was constructed that has been used to realize various dose distributions with a scanned beam of 180 MeV protons at TSL.
|
|
| 4. |
|
|
| 5. |
- Wu, D., et al.
(författare)
-
A novel strained Si0.7Ge0.3 surface-channel pMOSFET with an ALD TiN/Al2O3/HfAlOx/Al2O3 gate stack
- 2003
-
Ingår i: IEEE Electron Device Letters. - : Institute of Electrical and Electronics Engineers (IEEE). - 0741-3106 .- 1558-0563. ; 24:3, s. 171-173
-
Tidskriftsartikel (refereegranskat)abstract
- Proof-of-concept pMOSFETs with a strained-Si0.7Ge0.3 surface-channel deposited by selective epitaxy and a TiN/Al2O3/HfAIO(x)/Al2O3 gate stack grown by atomic layer chemical vapor deposition (ALD) techniques were fabricated. The Si0.7Ge0.3 pMOSFETs exhibited more than 30% higher current drive and peak transconductance than reference Si pMOSFETs with the same gate stack. The effective mobility for the Si reference coincided with the universal hole mobility curve for Si. The presence of a relatively low density of interface states, determined as 3.3x10(11) cm(-2) eV(-1), yielded a subthreshold slope of 75 mV/dec. for the Si reference. For the Si0.7Ge0.3 pMOSFETs, these values were 1.6x10(12) cm(-2) eV(-1) and 110 mV/dec., respectively.
|
|
