| 1. |
- Abel, I, et al.
(författare)
-
Overview of the JET results with the ITER-like wall
- 2013
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:10, s. 104002-
-
Tidskriftsartikel (refereegranskat)abstract
- Following the completion in May 2011 of the shutdown for the installation of the beryllium wall and the tungsten divertor, the first set of JET campaigns have addressed the investigation of the retention properties and the development of operational scenarios with the new plasma-facing materials. The large reduction in the carbon content (more than a factor ten) led to a much lower Z(eff) (1.2-1.4) during L- and H-mode plasmas, and radiation during the burn-through phase of the plasma initiation with the consequence that breakdown failures are almost absent. Gas balance experiments have shown that the fuel retention rate with the new wall is substantially reduced with respect to the C wall. The re-establishment of the baseline H-mode and hybrid scenarios compatible with the new wall has required an optimization of the control of metallic impurity sources and heat loads. Stable type-I ELMy H-mode regimes with H-98,H-y2 close to 1 and beta(N) similar to 1.6 have been achieved using gas injection. ELM frequency is a key factor for the control of the metallic impurity accumulation. Pedestal temperatures tend to be lower with the new wall, leading to reduced confinement, but nitrogen seeding restores high pedestal temperatures and confinement. Compared with the carbon wall, major disruptions with the new wall show a lower radiated power and a slower current quench. The higher heat loads on Be wall plasma-facing components due to lower radiation made the routine use of massive gas injection for disruption mitigation essential.
|
|
| 2. |
- Romanelli, F, et al.
(författare)
-
Overview of the JET results
- 2011
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 51:9
-
Tidskriftsartikel (refereegranskat)abstract
- Since the last IAEA Conference JET has been in operation for one year with a programmatic focus on the qualification of ITER operating scenarios, the consolidation of ITER design choices and preparation for plasma operation with the ITER-like wall presently being installed in JET. Good progress has been achieved, including stationary ELMy H-mode operation at 4.5 MA. The high confinement hybrid scenario has been extended to high triangularity, lower ρ*and to pulse lengths comparable to the resistive time. The steady-state scenario has also been extended to lower ρ*and ν*and optimized to simultaneously achieve, under stationary conditions, ITER-like values of all other relevant normalized parameters. A dedicated helium campaign has allowed key aspects of plasma control and H-mode operation for the ITER non-activated phase to be evaluated. Effective sawtooth control by fast ions has been demonstrated with3He minority ICRH, a scenario with negligible minority current drive. Edge localized mode (ELM) control studies using external n = 1 and n = 2 perturbation fields have found a resonance effect in ELM frequency for specific q95values. Complete ELM suppression has, however, not been observed, even with an edge Chirikov parameter larger than 1. Pellet ELM pacing has been demonstrated and the minimum pellet size needed to trigger an ELM has been estimated. For both natural and mitigated ELMs a broadening of the divertor ELM-wetted area with increasing ELM size has been found. In disruption studies with massive gas injection up to 50% of the thermal energy could be radiated before, and 20% during, the thermal quench. Halo currents could be reduced by 60% and, using argon/deuterium and neon/deuterium gas mixtures, runaway electron generation could be avoided. Most objectives of the ITER-like ICRH antenna have been demonstrated; matching with closely packed straps, ELM resilience, scattering matrix arc detection and operation at high power density (6.2 MW m-2) and antenna strap voltages (42 kV). Coupling measurements are in very good agreement with TOPICA modelling. © 2011 IAEA, Vienna.
|
|
| 3. |
- Aguar-Bartolome, P., et al.
(författare)
-
New determination of the eta transition form factor in the Dalitz decay eta -> e(+) e(-) gamma with the Crystal Ball/TAPS detectors at the Mainz Microtron
- 2014
-
Ingår i: Physical Review C (Nuclear Physics). - 0556-2813. ; 89:4
-
Tidskriftsartikel (refereegranskat)abstract
- The Dalitz decay eta -> e(+) e(-) gamma has been measured in the gamma p -> eta p reaction with the Crystal Ball and TAPS multiphoton spectrometers, together with the photon-tagging facility at the Mainz Microtron MAMI. The experimental statistic used in this work is one order of magnitude greater than in any previous measurement of eta -> e(+) e(-) gamma. The value obtained for the slope parameter Lambda(-2) of the eta transition form factor, Lambda(-2) = (1.95 +/- 0.15(stat) +/- 0.10(syst)) GeV-2, is in good agreement with recent measurements conducted in eta -> e(+) e(-) gamma and eta -> mu(+) mu(-) gamma decays, as well as with recent form-factor calculations. The uncertainty obtained in the value of Lambda(-2) is lower compared to results from previous measurements of the eta -> e(+) e(-) gamma decay.
|
|
| 4. |
- Aguar-Bartolome, P., et al.
(författare)
-
Measurement of the gamma p -> K-0 Sigma(+) reaction with the Crystal Ball/TAPS detectors at the Mainz Microtron
- 2013
-
Ingår i: Physical Review C (Nuclear Physics). - 0556-2813. ; 88:4
-
Tidskriftsartikel (refereegranskat)abstract
- The gamma p -> K-0 Sigma(+) reaction has been measured from threshold to E-gamma = 1.45 GeV (W-CM = 1.9 GeV) using the Crystal Ball and TAPS multiphoton spectrometers together with the photon tagging facility at the Mainz Microtron MAMI. In the present experiment, this reaction was searched for in the 3 pi(0)p final state, by assuming K-S(0) -> pi(0)pi(0) and Sigma(+) -> pi(0)p. The experimental results include total and differential cross sections as well as the polarization of the recoil hyperon. The new data significantly improve empirical knowledge about the gamma p -> K-0 Sigma(+) reaction in the measured energy range. The results are compared to previous measurements and model predictions. It is demonstrated that adding the present gamma p -> K-0 Sigma(+) results to existing data allowed a better description of this reaction with various models.
|
|
| 5. |
- Kashevarov, V. L., et al.
(författare)
-
Experimental study of the gamma p -> pi (0)pi(0) p reaction with the Crystal Ball/TAPS detector system at the Mainz Microtron
- 2012
-
Ingår i: Physical Review C (Nuclear Physics). - 0556-2813. ; 85:6
-
Tidskriftsartikel (refereegranskat)abstract
- The gamma p -> pi(0)pi(0) p reaction has been measured from threshold to 1.4 GeV using the Crystal Ball and TAPS photon spectrometers together with the photon tagging facility at the Mainz Microtron. The experimental results include total and differential cross sections as well as specific angular distributions, which were used to extract partial-wave amplitudes. In particular, the energy region below the D-13(1520) resonance was studied.
|
|
| 6. |
- Adlarson, Patrik, et al.
(författare)
-
Evidence for a New Resonance from Polarized Neutron-Proton Scattering
- 2014
-
Ingår i: Physical Review Letters. - 0031-9007 .- 1079-7114. ; 112:20, s. 202301-
-
Tidskriftsartikel (refereegranskat)abstract
- Exclusive and kinematically complete high-statistics measurements of quasifree polarized (n) over right arrowp scattering have been performed in the energy region of the narrow resonancelike structure d* with I(J(P)) = 0(3(+)),M approximate to 2380 MeV, and Gamma approximate to 70 MeV observed recently in the double-pionic fusion channels pn -> d pi(0)pi(0) and pn -> d pi(+)pi(-). The experiment was carried out with the WASA detector setup at COSY having a polarized deuteron beam impinged on the hydrogen pellet target and utilizing the quasifree process (d) over right arrowp -> np + p(spectator). This allowed the np analyzing power, A(y), to be measured over a broad angular range. The obtained A(y) angular distributions deviate systematically from the current SAID SP07 NN partial-wave solution. Incorporating the new A(y) data into the SAID analysis produces a pole in the D-3(3) - (3)G(3) waves in support of the d* resonance hypothesis.
|
|
| 7. |
- Myers, L. S., et al.
(författare)
-
Compton scattering from C-12 using tagged photons in the energy range 65-115 MeV
- 2014
-
Ingår i: Physical Review C (Nuclear Physics). - 0556-2813. ; 89:3
-
Tidskriftsartikel (refereegranskat)abstract
- Elastic scattering of photons from C-12 has been investigated using quasimonoenergetic tagged photons with energies in the range 65-115 MeV at laboratory angles of 60 degrees, 120 degrees, and 150 degrees. at the Tagged-Photon Facility at the MAX IV Laboratory in Lund, Sweden. A phenomenological model was employed to provide an estimate of the sensitivity of the C-12(gamma,gamma)C-12 cross section to the bound- nucleon polarizabilities.
|
|
| 8. |
- Adler, Jan-Olof, et al.
(författare)
-
The upgraded photon tagging facility at the MAX IV Laboratory
- 2013
-
Ingår i: Nuclear Instruments & Methods in Physics Research. Section A: Accelerators, Spectrometers, Detectors, and Associated Equipment. - : Elsevier BV. - 0167-5087 .- 0168-9002. ; 715, s. 1-10
-
Tidskriftsartikel (refereegranskat)abstract
- A description is given of the upgraded photon tagging facility at the MAX IV Laboratory. Two magnetic spectrometers are used to momentum analyze post-bremsstrahlung electrons. The tagged photon range extends from 10 to 180 MeV with an energy resolution of about 300 keV. The system has been operated at rates up to 4 x 10(6) photons s(-1) MeV (-1). Different diagnostic tools are described as well as the experimental program.
|
|
| 9. |
|
|
| 10. |
- Pilkington, Georgia A., et al.
(författare)
-
Amontonian frictional behaviour of nanostructured surfaces
- 2011
-
Ingår i: Physical Chemistry, Chemical Physics - PCCP. - : Royal Society of Chemistry. - 1463-9076 .- 1463-9084. ; 13, s. 9318-9326
-
Tidskriftsartikel (refereegranskat)abstract
- With nanotextured surfaces and interfaces increasingly being encountered in technological and biomedical applications, there is a need for a better understanding of frictional properties involving such surfaces. Here we report friction measurements of several nanostructured surfaces using an Atomic Force Microscope (AFM). These nanostructured surfaces provide well defined model systems on which we have tested the applicability of Amontons' laws of friction. Our results show that Amontonian behaviour is observed with each of the surfaces studied. However, no correlation has been found between measured friction and various surface roughness parameters such as average surface roughness (Ra) and root mean squared (rms) roughness. Instead, we propose that the friction coefficient may be decomposed into two contributions, i.e., μ = μ0 + μg, with the intrinsic friction coefficient μ0 accounting for the chemical nature of the surfaces and the geometric friction coefficient μg for the presence of nanotextures. We have found a possible correlation between μg and the average local slope of the surface nanotextures.
|
|
