SwePub
Sök i SwePub databas

  Utökad sökning

Träfflista för sökning "WFRF:(Carlsson Lars 1952) srt2:(2000-2004)"

Sökning: WFRF:(Carlsson Lars 1952) > (2000-2004)

  • Resultat 1-4 av 4
Sortera/gruppera träfflistan
   
NumreringReferensOmslagsbildHitta
1.
  • Gabrielsson, Britt, 1957, et al. (författare)
  • Depot-specific expression of fibroblast growth factors in human adipose tissue.
  • 2002
  • Ingår i: Obesity research. - : Wiley. - 1071-7323 .- 1550-8528. ; 10:7, s. 608-16
  • Tidskriftsartikel (refereegranskat)abstract
    • We have investigated the expression of several fibroblast growth factors (FGFs) and FGF-receptors (FGFRs) in human adipose tissue and adipose-tissue cell fractions obtained from both subcutaneous (sc) and omental (om) depots.
  •  
2.
  • Carlsson, Lars, 1952, et al. (författare)
  • Bone conserving hip replacement.
  • 2004
  • Ingår i: 3rd Annual SICOT/SIROT Conference 2004.
  • Konferensbidrag (refereegranskat)
  •  
3.
  •  
4.
  • Macdonald, Warren, 1954, et al. (författare)
  • Improved tibial cutting accuracy in knee arthroplasty.
  • 2004
  • Ingår i: Medical engineering & physics. - : Elsevier BV. - 1350-4533. ; 26:9, s. 807-12
  • Tidskriftsartikel (refereegranskat)abstract
    • Initial stability and development of long-term fixation for cementless tibial components at the knee both depend on the accuracy of fit between implanted components and prepared bone surfaces. Tibial surfaces prepared for total knee replacement with conventional saw-blades and guides were shown by Toksvig-Larsen to vary by over 2 mm, from a flat surface at the point of maximum variation, and all points varied with a standard deviation of up to 0.4 mm. Surface cutting errors are caused by flexion of the saw-blade and blade angulation from the ideal alignment, due to poor guidance or control by the saw-block or guide. Most conventional knee instrumentation relies on flat surface or slotted cutting blocks, constraining the moving saw-blade against one or two guide surfaces. Improved cutting action was achieved by constraining the saw from the pivot point of the blade, and controlling motion of this constraint with parallel action slides. Using this saw-guide and an improved saw-blade, tibial cuts were made in mock arthroplasty procedures on twenty four cadaveric tibiae in mortuo. Analysis of Variance and Tukey's HSD test showed that the improved saw technique yielded significantly better flatness (p < 0.03) and greatly improved roughness (p < 0.0005).
  •  
Skapa referenser, mejla, bekava och länka
  • Resultat 1-4 av 4

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy