1. |
- Angelopoulus, M., et al.
(författare)
-
Physical properties of sea ice cores from site MCS_FYI measured on legs 1 to 3 of the MOSAiC expedition.
- 2022
-
Ingår i: PANGAEA.
-
Annan publikation (övrigt vetenskapligt/konstnärligt)abstract
- We present sea ice temperature and salinity data from first-year ice (FYI) and second-year ice (SYI) relevant to the temporal development of sea ice permeability and brine drainage efficiency from the early growth phase in October 2019 to the onset of spring warming in May 2020. Our dataset was collected in the central Arctic Ocean during the Multidisciplinary drifting Observatory for the Study of Arctic Climate (MOSAiC) Expedition in 2019 to 2020. MOSAiC was an international transpolar drift expedition in which the German icebreaker RV Polarstern anchored into an ice floe to gain new insights into Arctic climate over a full annual cycle. In October 2019, RV Polarstern moored to an ice floe in the Siberian sector of the Arctic at 85 degrees north and 137 degrees east to begin the drift towards the North Pole and the Fram Strait via the Transpolar Drift Stream. The data presented here were collected during the first three legs of the expedition, so all the coring activities took place on the same floe. The end dates of legs 1, 2, and 3 were 13 December, 24 February, and 4 June, respectively. The dataset contributed to a baseline study entitled, Deciphering the properties of different Arctic ice types during the growth phase of the MOSAiC floes: Implications for future studies. The study highlights downward directed gas pathways in FYI and SYI by inferring sea ice permeability and potential brine release from several time series of temperature and salinity measurements. The physical properties presented in this paper lay the foundation for subsequent analyses on actual gas contents measured in the ice cores, as well as air-ice and ice-ocean gas fluxes. Sea ice cores were collected with a Kovacs Mark II 9 cm diameter corer. To measure ice temperatures, about 4.5 cm deep holes were drilled into the core (intervals varied by site and leg) . The temperatures were measured by a digital thermometer within minutes after the cores were retrieved. The ice cores were placed into pre-labelled plastic sleeves sealed at the bottom end. The ice cores were transported to RV Polarstern and stored in a -20 degrees Celsius freezer. Each of the cores was sub-sampled, melted at room temperature, and processed for salinity within one or two days. The practical salinity was estimated by measuring the electrical conductivity and temperature of the melted samples using a WTW Cond 3151 salinometer equipped with a Tetra-Con 325 four-electrode conductivity cell. The practical salinity represents the the salinity estimated from the electrical conductivity of the solution. The dataset also contains derived variables, including sea ice density, brine volume fraction, and the Rayleigh number.
|
|
2. |
- Angelopoulus, M., et al.
(författare)
-
Physical properties of sea ice cores from site MCS-SYI measured on legs 1 to 3 of the MOSAiC expedition
- 2022
-
Ingår i: PANGAEA.
-
Annan publikation (övrigt vetenskapligt/konstnärligt)abstract
- We present sea ice temperature and salinity data from first-year ice (FYI) and second-year ice (SYI) relevant to the temporal development of sea ice permeability and brine drainage efficiency from the early growth phase in October 2019 to the onset of spring warming in May 2020. Our dataset was collected in the central Arctic Ocean during the Multidisciplinary drifting Observatory for the Study of Arctic Climate (MOSAiC) Expedition in 2019 to 2020. MOSAiC was an international transpolar drift expedition in which the German icebreaker RV Polarstern anchored into an ice floe to gain new insights into Arctic climate over a full annual cycle. In October 2019, RV Polarstern moored to an ice floe in the Siberian sector of the Arctic at 85 degrees north and 137 degrees east to begin the drift towards the North Pole and the Fram Strait via the Transpolar Drift Stream. The data presented here were collected during the first three legs of the expedition, so all the coring activities took place on the same floe. The end dates of legs 1, 2, and 3 were 13 December, 24 February, and 4 June, respectively. The dataset contributed to a baseline study entitled, Deciphering the properties of different Arctic ice types during the growth phase of the MOSAiC floes: Implications for future studies. The study highlights downward directed gas pathways in FYI and SYI by inferring sea ice permeability and potential brine release from several time series of temperature and salinity measurements. The physical properties presented in this paper lay the foundation for subsequent analyses on actual gas contents measured in the ice cores, as well as air-ice and ice-ocean gas fluxes. Sea ice cores were collected with a Kovacs Mark II 9 cm diameter corer. To measure ice temperatures, about 4.5 cm deep holes were drilled into the core (intervals varied by site and leg) . The temperatures were measured by a digital thermometer within minutes after the cores were retrieved. The ice cores were placed into pre-labelled plastic sleeves sealed at the bottom end. The ice cores were transported to RV Polarstern and stored in a -20 degrees Celsius freezer. Each of the cores was sub-sampled, melted at room temperature, and processed for salinity within one or two days. The practical salinity was estimated by measuring the electrical conductivity and temperature of the melted samples using a WTW Cond 3151 salinometer equipped with a Tetra-Con 325 four-electrode conductivity cell. The practical salinity represents the the salinity estimated from the electrical conductivity of the solution. The dataset also contains derived variables, including sea ice density, brine volume fraction, and the Rayleigh number.
|
|
3. |
- Salganik, E., et al.
(författare)
-
Temporal evolution of under-ice meltwater layers and false bottoms and their impact on summer Arctic sea ice mass balance
- 2023
-
Ingår i: Elementa: Science of the Anthropocene. - 2325-1026. ; 11:1
-
Tidskriftsartikel (refereegranskat)abstract
- Low-salinity meltwater from Arctic sea ice and its snow cover accumulates and creates under-ice meltwater layers below sea ice. These meltwater layers can result in the formation of new ice layers, or false bottoms, at the interface of this low-salinity meltwater and colder seawater. As part of the Multidisciplinary drifting Observatory for the Study of the Arctic Climate (MOSAiC), we used a combination of sea ice coring, temperature profiles from thermistor strings and underwater multibeam sonar surveys with a remotely operated vehicle (ROV) to study the areal coverage and temporal evolution of under-ice meltwater layers and false bottoms during the summer melt season from mid-June until late July. ROV surveys indicated that the areal coverage of false bottoms for a part of the MOSAiC Central Observatory (350 by 200 m2) was 21%. Presence of false bottoms reduced bottom ice melt by 7-8% due to the local decrease in the ocean heat flux, which can be described by a thermodynamic model. Under-ice meltwater layer thickness was larger below first-year ice and thinner below thicker second-year ice. We also found that thick ice and ridge keels confined the areas in which under-ice meltwater accumulated, preventing its mixing with underlying seawater. While a thermodynamic model could reproduce false bottom growth and melt, it could not describe the observed bottom melt rates of the ice above false bottoms. We also show that the evolution of under-ice meltwaterlayer salinity below first-year ice is linked to brine flushing from the above sea ice and accumulating in the meltwater layer above the false bottom. The results of this study aid in estimating the contribution of underice meltwater layers and false bottoms to the mass balance and salt budget for Arctic summer sea ice.
|
|
4. |
- Dijkhorst, Phillip J., et al.
(författare)
-
Core Set of Patient-Reported Outcome Measures for Measuring Quality of Life in Clinical Obesity Care
- 2024
-
Ingår i: Obesity Surgery. - : Springer. - 0960-8923 .- 1708-0428. ; 34:8, s. 2980-2990
-
Tidskriftsartikel (refereegranskat)abstract
- Purpose: The focus of measuring success in obesity treatment is shifting from weight loss to patients' health and quality of life. The objective of this study was to select a core set of patient-reported outcomes and patient-reported outcome measures to be used in clinical obesity care.Materials and Methods: The Standardizing Quality of Life in Obesity Treatment III, face-to-face hybrid consensus meeting, including people living with obesity as well as healthcare providers, was held in Maastricht, the Netherlands, in 2022. It was preceded by two prior multinational consensus meetings and a systematic review.Results: The meeting was attended by 27 participants, representing twelve countries from five continents. The participants included healthcare providers, such as surgeons, endocrinologists, dietitians, psychologists, researchers, and people living with obesity, most of whom were involved in patient representative networks. Three patient-reported outcome measures (patient-reported outcomes) were selected: the Impact of Weight on Quality of Life-Lite (self-esteem) measure, the BODY-Q (physical function, physical symptoms, psychological function, social function, eating behavior, and body image), and the Quality of Life for Obesity Surgery questionnaire (excess skin). No patient-reported outcome measure was selected for stigma.Conclusion: A core set of patient-reported outcomes and patient-reported outcome measures for measuring quality of life in clinical obesity care is established incorporating patients' and experts' opinions. This set should be used as a minimum for measuring quality of life in routine clinical practice. It is essential that individual patient-reported outcome measure scores are shared with people living with obesity in order to enhance patient engagement and shared decision-making.
|
|
5. |
- Orme, L. C., et al.
(författare)
-
Climatic impacts on an Arctic lake since 1300 AD : a multi-proxy lake sediment reconstruction from Prins Karls Forland, Svalbard
- 2023
-
Ingår i: Journal of Paleolimnology. - : Springer Science and Business Media LLC. - 0921-2728 .- 1573-0417. ; 69:3, s. 249-266
-
Tidskriftsartikel (refereegranskat)abstract
- On the remote Arctic archipelago of Svalbard, there is increasing evidence of environmental impacts from climate change. The analysis of lake sedimentary records can be used to assess how strongly these recent changes have altered lake ecosystems. Sediments deposited during the last millennium from Lake Blokkvatnet, Prins Karls Forland, were analysed using a multiproxy approach, including stable isotope and X-ray fluorescence analysis. The results were interpreted as reflecting variability of (1) soil organic matter inwash, and potentially catchment and lake primary production, and (2) catchment weathering and erosion. Organic content began increasing after 1920 AD to the present, likely in response to warming. Earlier peaks of a similar magnitude occurred on three occasions since 1300 AD, with evidence indicating that these may have coincided with multidecadal-scale periods with higher temperatures, reduced sea ice and negative phases of the North Atlantic Oscillation. Catchment weathering and fluvial erosion began to increase around 1800 AD and peaked during the early twentieth century, potentially due to rising temperatures in autumn and winter causing increased liquid water availability. The records suggest that similar levels of erosion and weathering occurred between approximately 1300 and 1600 AD, spanning the transition from the Medieval Climate Anomaly to the Little Ice Age.
|
|
6. |
|
|