| 1. |
|
|
| 2. |
- Abdesselam, A., et al.
(författare)
-
Engineering for the ATLAS SemiConductor Tracker (SCT) end-cap
- 2008
-
Ingår i: Journal of Instrumentation. - 1748-0221 .- 1748-0221. ; 3
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS SemiConductor Tracker (SCT) is a silicon-strip tracking detector which forms part of the ATLAS inner detector. The SCT is designed to track charged particles produced in proton-proton collisions at the Large Hadron Collider (LHC) at CERN at an energy of 14 TeV. The tracker is made up of a central barrel and two identical end-caps. The barrel contains 2112 silicon modules, while each end-cap contains 988 modules. The overall tracking performance depends not only on the intrinsic measurement precision of the modules but also on the characteristics of the whole assembly, in particular, the stability and the total material budget. This paper describes the engineering design and construction of the SCT end-caps, which are required to support mechanically the silicon modules, supply services to them and provide a suitable environment within the inner detector. Critical engineering choices are highlighted and innovative solutions are presented - these will be of interest to other builders of large-scale tracking detectors. The SCT end-caps will be fully connected at the start of 2008. Further commissioning will continue, to be ready for proton-proton collision data in 2008.
|
|
| 3. |
- Abdesselam, A., et al.
(författare)
-
The ATLAS semiconductor tracker end-cap module
- 2007
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 575:3, s. 353-389
-
Tidskriftsartikel (refereegranskat)abstract
- The challenges for the tracking detector systems at the LHC are unprecedented in terms of the number of channels, the required read-out speed and the expected radiation levels. The ATLAS Semiconductor Tracker. (SCT) end-caps have a total of about 3 million electronics channels each reading out every 25 ns into its own on-chip 3.3 mu s buffer. The highest anticipated dose after 10 years operation is 1.4x10(14) cm(-2) in units of 1 MeV neutron equivalent (assuming the damage factors scale with the non-ionising energy loss). The forward tracker has 1976 double-sided modules, mostly of area similar to 70 cm(2), each having 2 x 768 strips read out by six ASICs per side. The requirement to achieve an average perpendicular radiation length of 1.5% X-0, while coping with up to 7 W dissipation per module (after irradiation), leads to stringent constraints on the thermal design. The additional requirement of 1500e(-) equivalent noise charge (ENC) rising to only 1800e(-) ENC after irradiation, provides stringent design constraints on both the high-density Cu/Polyimide flex read-out circuit and the ABCD3TA read-out ASICs. Finally, the accuracy of module assembly must not compromise the 16 mu m (r phi) resolution perpendicular to the strip directions or 580 mu m radial resolution coming from the 40 mrad front-back stereo angle. A total of 2210 modules were built to the tight tolerances and specifications required for the SCT. This was 234 more than the 1976 required and represents a yield of 93%. The component flow was at times tight, but the module production rate of 40-50 per week was maintained despite this. The distributed production was not found to be a major logistical problem and it allowed additional flexibility to take advantage of where the effort was available, including any spare capacity, for building the end-cap modules. The collaboration that produced the ATLAS SCT end-cap modules kept in close contact at all times so that the effects of shortages or stoppages at different sites could be rapidly resolved.
|
|
| 4. |
- Abdesselam, A., et al.
(författare)
-
The detector control system of the ATLAS SemiConductor Tracker during macro-assembly and integration
- 2008
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 3, s. P02007-
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS SemiConductor Tracker (SCT) is one of the largest existing semiconductor detectors. It is situated between the Pixel detector and the Transition Radiation Tracker at one of the four interaction points of the Large Hadron Collider (LHC). During 2006-2007 the detector was lowered into the ATLAS cavern and installed in its final position. For the assembly, integration and commissioning phase, a complete Detector Control System (DCS) was developed to ensure the safe operation of the tracker. This included control of the individual powering of the silicon modules, a bi-phase cooling system and various types of sensors monitoring the SCT environment and the surrounding test enclosure. The DCS software architecture, performance and operational experience will be presented in the view of a validation of the DCS for the final SCT installation and operation phase.
|
|
| 5. |
|
|
| 6. |
- Doherty, James M, et al.
(författare)
-
Contributions of dopamine D1, D2, and D3 receptor subtypes to the disruptive effects of cocaine on prepulse inhibition in mice.
- 2008
-
Ingår i: Neuropsychopharmacology : official publication of the American College of Neuropsychopharmacology. - : Springer Science and Business Media LLC. ; 33:11, s. 2648-56
-
Tidskriftsartikel (refereegranskat)abstract
- Deficits in prepulse inhibition (PPI) of startle, an operational measure of sensorimotor gating, are characteristics of schizophrenia and related neuropsychiatric disorders. Previous studies in mice demonstrate a contribution of dopamine (DA) D(1)-family receptors in modulating PPI and DA D(2) receptors (D2R) in mediating the PPI-disruptive effects of amphetamine. To examine further the contributions of DA receptor subtypes in PPI, we used a combined pharmacological and genetic approach. In congenic C57BL/6 J wild-type mice, we tested whether the D1R antagonist SCH23390 or the D2/3R antagonist raclopride would attenuate the effects of the indirect DA agonist cocaine (40 mg/kg). Both the D1R and D2/3R antagonists attenuated the cocaine-induced PPI deficit. We also tested the effect of cocaine on PPI in wild-type and DA D1R, D2R, or D3R knockout mice. The cocaine-induced PPI deficit was influenced differently by the three DA receptor subtypes, being absent in D1R knockout mice, partially attenuated in D2R knockout mice, and exaggerated in D3R knockout mice. Thus, the D1R is necessary for the PPI-disruptive effects of cocaine, while the D2R partially contributes to these effects. Conversely, the D3R appears to inhibit the PPI-disruptive effects of cocaine. Uncovering neural mechanisms involved in PPI will further our understanding of substrates of sensorimotor gating and could lead to better therapeutics to treat complex cognitive disorders such as schizophrenia.
|
|
| 7. |
|
|
| 8. |
|
|
| 9. |
- Doherty, Walter J, et al.
(författare)
-
Molecular ordering in monolayers of an alkyl-Substituted perylene-bisimide dye by attenuated total reflectance ultraviolet-visible spectroscopy
- 2005
-
Ingår i: Applied Spectroscopy. - : SAGE Publications. - 0003-7028 .- 1943-3530. ; 59:10, s. 1248-1256
-
Tidskriftsartikel (refereegranskat)abstract
- Surface-relative orientational parameters were determined for monolayer films of N, N'-ditridecylperylenetetracarboxylic dianhydridediimide (C 13-PTCDI) in terms of the relative electronic transition dipole strengths, providing a three-dimensional view of the absorption dipole distribution. In order to obtain a macroscopically ordered film, C 13-PTCDI was deposited by (1) horizontal Langmuir-Blodgett (LB) transfer onto methyl- and phenyl-silanized glass, and (2) vapor deposition onto oriented films of poly(tetrafluoroethylene) (PTFE) on glass. Films of LB-deposited C13-PTCDI were found to be completely Isotropic prior to annealing. After annealing, these films remained isotropic in the plane of the substrate while the out-of-plane anisotropy was significantly enhanced. In contrast, films of C13-PTCDI vapor deposited onto oriented poly(tetrafluoroethylene) (PTFE)-modified substrates yielded films with a high degree of both in- and out-of-plane anisotropy. Atomic force microscopy (AFM) images of both the LB- and vapor-deposited films show substantial differences in film morphology and long-range order. These results demonstrate that molecular orientation in C13-PTCDI films can be controlled by varying substrate surface chemistry and post-deposition processing. © 2005 Society for Applied Spectroscopy.
|
|
| 10. |
- Gorgoi, M, et al.
(författare)
-
The high kinetic energy photoelectron spectroscopy facility at BESSY progress and first results
- 2009
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 601:1-2, s. 48-53
-
Tidskriftsartikel (refereegranskat)abstract
- Photoelectron spectroscopy at high kinetic energy is a research field that receives an increasing interest due to the possibility of studying bulk properties of materials and deeply buried interfaces. Recently the high kinetic energy electron (HIKE) spectroscopy facility at BESSY in Berlin has become operative at the bending magnet beamline KMC-1. The first results show very good performance. Electron spectra have been recorded using X-ray energies from 2 keV up to 12 keV. Using back-scattering conditions in the crystal monochromator, very high-resolution has been achieved for photon energies around 2, 6 and 8 keV. In the latter case, spectra with a resolving power from the monochromator of >= 80 000 have been achieved and it has been possible to perform electron spectroscopy with resolving power of >= 60 000, yielding a total instrument resolution of about 150 meV as determined directly from spectra. This paper describes the facility and reports some of the first results. (C) 2009 Elsevier B.V. All rights reserved.
|
|
