| 1. |
- Jentschel, M., et al.
(author)
-
EXILL - a high-efficiency, high-resolution setup for gamma-spectroscopy at an intense cold neutron beam facility
- 2017
-
In: Journal of Instrumentation. - : IOP PUBLISHING LTD. - 1748-0221. ; 12
-
Journal article (peer-reviewed)abstract
- In the EXILL campaign a highly efficient array of high purity germanium (HPGe) detectors was operated at the cold neutron beam facility PF1B of the Institut Laue-Langevin (ILL) to carry out nuclear structure studies, via measurements of gamma-rays following neutron-induced capture and fission reactions. The setup consisted of a collimation system producing a pencil beam with a thermal capture equivalent flux of about 10(8) ns(-1)cm(2) at the target position and negligible neutron halo. The targetwas surrounded by an array of eight to ten anti-Compton shielded EXOGAMClover detectors, four to six anti-Compton shielded large coaxial GASP detectors and two standard Clover detectors. For a part of the campaign the array was combined with 16 LaBr3:(Ce) detectors from the FATIMA collaboration. The detectorswere arranged in an array of rhombicuboctahedron geometry, providing the possibility to carry out very precise angular correlation and directional-polarization correlation measurements. The triggerless acquisition system allowed a signal collection rate of up to 6 x 10(5) Hz. The data allowed to set multi-fold coincidences to obtain decay schemes and in combination with the FATIMA array of LaBr3:(Ce) detectors to analyze half-lives of excited levels in the pico-to microsecond range. Precise energy and efficiency calibrations of EXILL were performed using standard calibration sources of Ba-133, Co-60 and Eu-152 as well as data from the reactions Al-27(n, gamma)Al-28 and Cl-35(n,gamma)Cl-36 in the energy range from 30 keV up to 10MeV.
|
|
| 2. |
- Clement, E., et al.
(author)
-
Conceptual design of the AGATA 1 π array at GANIL
- 2017
-
In: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 855, s. 1-12
-
Journal article (peer-reviewed)abstract
- The Advanced GAmma Tracking Array (AGATA) has been installed at the GANIL facility, Caen-France. This setup exploits the stable and radioactive heavy-ions beams delivered by the cyclotron accelerator complex of GANIL. Additionally, it benefits from a large palette of ancillary detectors and spectrometers to address in-beam γ-ray spectroscopy of exotic nuclei. The set-up has been designed to couple AGATA with a magnetic spectrometer, charged-particle and neutron detectors, scintillators for the detection of high-energy γ rays and other devices such as a plunger to measure nuclear lifetimes. In this paper, the design and the mechanical characteristics of the set-up are described. Based on simulations, expected performances of the AGATA l π array are presented.
|
|
| 3. |
- Sahin, E., et al.
(author)
-
Shell evolution beyond N=40 : Cu-69,Cu-71,Cu-73
- 2015
-
In: Physical Review C. Nuclear Physics. - 0556-2813 .- 1089-490X. ; 91:3
-
Journal article (peer-reviewed)abstract
- The level structure of the neutron-rich Cu-69, Cu-71, and Cu-73 isotopes has been investigated by means of multinucleon transfer reactions. The experiment was performed at Laboratori Nazionali di Legnaro using the AGATA Demonstrator array coupled to the PRISMA magnetic spectrometer. Lifetimes of excited states in Cu nuclei were measured with the recoil-distance Doppler-shift method. The resulting electromagnetic matrix elements for transitions from excited states in Cu-69,Cu-71,Cu-73 nuclei are used to assess the collective or single-particle character of these states. The results are compared with predictions of large-scale shell-model calculations, giving further insight into the evolution of the proton pf shell as neutrons fill the 1g(9/2) orbital.
|
|
| 4. |
- Litzinger, J., et al.
(author)
-
Transition probabilities in neutron-rich Se-80,Se-82 and the role of the nu g(9/2) orbital
- 2018
-
In: Physical Review C. - : American Physical Society. - 2469-9985 .- 2469-9993. ; 97:4
-
Journal article (peer-reviewed)abstract
- Transition probabilities of intermediate-spin yrast and non-yrast excitations in Se-80,Se-82 were investigated in a recoil distance Doppler-shift (RDDS) experiment performed at the Istituto Nazionale di Fisica Nucleare, Laboratori Nazionali di Legnaro. The Cologne Plunger device for deep inelastic scattering was used for the RDDS technique and was combined with the AGATA Demonstrator array for the gamma-ray detection and coupled to the PRISMA magnetic spectrometer for an event-by-event particle identification. In Se-80, the level lifetimes of the yrast (6(1)(+)) and (8(1)(+)) states and of a non-yrast band feeding the yrast 4(1)(+) state are determined. A spin and parity assignment of the head of this sideband is discussed based on the experimental results and supported by large-scale shell-model calculations. In Se-82, the level lifetimes of the yrast 6(1)(+) state and the yrare 4(2)(+) state and lifetime limits of the yrast (10(1)(+)) state and of the 5(1)(-) state are determined. Although the experimental results contain large uncertainties, they are interpreted with care in terms of large-scale shell-model calculations using the effective interactions JUN45 and jj44b. The excited states' wave functions are investigated and discussed with respect to the role of the neutron g(9/2) orbital.
|
|
| 5. |
- Litzinger, J., et al.
(author)
-
Transition probabilities in neutron-rich Se-84,Se-86
- 2015
-
In: Physical Review C. Nuclear Physics. - : American Physical Society. - 0556-2813 .- 1089-490X. ; 92:6
-
Journal article (peer-reviewed)abstract
- Reduced quadrupole transition probabilities for low-lying transitions in neutron-rich Se-84,Se-86 are investigated with a recoil distance Doppler shift (RDDS) experiment. The experiment was performed at the Istituto Nazionale di Fisica Nucleare (INFN) Laboratori Nazionali di Legnaro using the Cologne Plunger device for the RDDS technique and the AGATA Demonstrator array for the gamma-ray detection coupled to the PRISMA magnetic spectrometer for an event-by-event particle identification. In Se-86 the level lifetime of the yrast 2(1)(+) state and an upper limit for the lifetime of the 4(1)(+) state are determined for the first time. The results of Se-86 are in agreement with previously reported predictions of large-scale shell-model calculations using Ni78-I and Ni78-II effective interactions. In addition, intrinsic shape parameters of lowest yrast states in Se-86 are calculated. In semimagic Se-84 level lifetimes of the yrast 4(1)(+) and 6(1)(+) states are determined for the first time. Large-scale shell-model calculations using effective interactions Ni78-II, JUN45, jj4b, and jj4pna are performed. The calculations describe B(E2; 2(1)(+) -> 0(1)(+)) and B(E2; 6(1)(+) -> 4(1)(+)) fairly well and point out problems in reproducing the experimental B(E2; 4(1)(+) -> 2(1)(+)).
|
|
| 6. |
- Ralet, D., et al.
(author)
-
Lifetime measurement of neutron-rich even-even molybdenum isotopes
- 2017
-
In: Physical Review C: covering nuclear physics. - : AMER PHYSICAL SOC. - 2469-9985 .- 2469-9993. ; 95:3
-
Journal article (peer-reviewed)abstract
- Background: In the neutron-rich A≈100 mass region, rapid shape changes as a function of nucleon number as well as coexistence of prolate, oblate, and triaxial shapes are predicted by various theoretical models. Lifetime measurements of excited levels in the molybdenum isotopes allow the determination of transitional quadrupole moments, which in turn provides structural information regarding the predicted shape change. Purpose: The present paper reports on the experimental setup, the method that allowed one to measure the lifetimes of excited states in even-even molybdenum isotopes from mass A=100 up to mass A=108, and the results that were obtained. Method: The isotopes of interest were populated by secondary knock-out reaction of neutron-rich nuclei separated and identified by the GSI fragment separator at relativistic beam energies and detected by the sensitive PreSPEC-AGATA experimental setup. The latter included the Lund-York-Cologne calorimeter for identification, tracking, and velocity measurement of ejectiles, and AGATA, an array of position sensitive segmented HPGe detectors, used to determine the interaction positions of the γ ray enabling a precise Doppler correction. The lifetimes were determined with a relativistic version of the Doppler-shift-attenuation method using the systematic shift of the energy after Doppler correction of a γ-ray transition with a known energy. This relativistic Doppler-shift-attenuation method allowed the determination of mean lifetimes from 2 to 250 ps. Results: Even-even molybdenum isotopes from mass A=100 to A=108 were studied. The decays of the low-lying states in the ground-state band were observed. In particular, two mean lifetimes were measured for the first time: τ=29.7-9.1+11.3 ps for the 4+ state of Mo108 and τ=3.2-0.7+0.7 ps for the 6+ state of Mo102. Conclusions: The reduced transition strengths B(E2), calculated from lifetimes measured in this experiment, compared to beyond-mean-field calculations, indicate a gradual shape transition in the chain of molybdenum isotopes when going from A=100 to A=108 with a maximum reached at N=64. The transition probabilities decrease for Mo108 which may be related to its well-pronounced triaxial shape indicated by the calculations.
|
|
| 7. |
- Bouckaert, R., et al.
(author)
-
BEAST 2.5: An advanced software platform for Bayesian evolutionary analysis
- 2019
-
In: Plos Computational Biology. - : Public Library of Science (PLoS). - 1553-7358. ; 15:4
-
Journal article (peer-reviewed)abstract
- Elaboration of Bayesian phylogenetic inference methods has continued at pace in recent years with major new advances in nearly all aspects of the joint modelling of evolutionary data. It is increasingly appreciated that some evolutionary questions can only be adequately answered by combining evidence from multiple independent sources of data, including genome sequences, sampling dates, phenotypic data, radiocarbon dates, fossil occurrences, and biogeographic range information among others. Including all relevant data into a single joint model is very challenging both conceptually and computationally. Advanced computational software packages that allow robust development of compatible (sub-)models which can be composed into a full model hierarchy have played a key role in these developments. Developing such software frameworks is increasingly a major scientific activity in its own right, and comes with specific challenges, from practical software design, development and engineering challenges to statistical and conceptual modelling challenges. BEAST 2 is one such computational software platform, and was first announced over 4 years ago. Here we describe a series of major new developments in the BEAST 2 core platform and model hierarchy that have occurred since the first release of the software, culminating in the recent 2.5 release. Author summary Bayesian phylogenetic inference methods have undergone considerable development in recent years, and joint modelling of rich evolutionary data, including genomes, phenotypes and fossil occurrences is increasingly common. Advanced computational software packages that allow robust development of compatible (sub-)models which can be composed into a full model hierarchy have played a key role in these developments. Developing scientific software is increasingly crucial to advancement in many fields of biology. The challenges range from practical software development and engineering, distributed team coordination, conceptual development and statistical modelling, to validation and testing. BEAST 2 is one such computational software platform for phylogenetics, population genetics and phylodynamics, and was first announced over 4 years ago. Here we describe the full range of new tools and models available on the BEAST 2.5 platform, which expand joint evolutionary inference in many new directions, especially for joint inference over multiple data types, non-tree models and complex phylodynamics.
|
|
| 8. |
|
|
| 9. |
|
|
