| 1. |
- Abele, H., et al.
(författare)
-
Particle physics at the European Spallation Source
- 2023
-
Ingår i: Physics reports. - : Elsevier. - 0370-1573 .- 1873-6270. ; 1023, s. 1-84
-
Forskningsöversikt (refereegranskat)abstract
- Presently under construction in Lund, Sweden, the European Spallation Source (ESS) will be the world’s brightest neutron source. As such, it has the potential for a particle physics program with a unique reach and which is complementary to that available at other facilities. This paper describes proposed particle physics activities for the ESS. These encompass the exploitation of both the neutrons and neutrinos produced at the ESS for high precision (sensitivity) measurements (searches).
|
|
| 2. |
- Aguilar, J., et al.
(författare)
-
Search for Leptonic CP Violation with the ESSnuSBplus Project
- 2024
-
Ingår i: Letters in High Energy Physics. - : Andromeda Publishing And Academic Services LTD. - 2632-2714.
-
Tidskriftsartikel (refereegranskat)abstract
- ESSνSB is a design study for a next-generation long-baseline neutrino experiment that aims at the precise measurement of the CP-violating phase, δCP, in the leptonic sector at the second oscillation maximum. The conceptual design report published from the first phase of the project showed that after 10 years of data taking, more than 70% of the possible δCP range will be covered with 5σ C.L. to reject the no-CP-violation hypothesis. The expected value of δCP precision is smaller than 8◦ for all δCP values. The next phase of the project, the ESSνSB+, aims at using the intense muon flux produced together with neutrinos to measure the neutrino-nucleus cross-section, the dominant term of the systematic uncertainty, in the energy range of 0.2–0.6 GeV, using a Low Energy neutrinos from STORed Muons (LEnuSTORM) and a Low Energy Monitored Neutrino Beam (LEMNB) facilities.
|
|
| 3. |
- Aguilar, J., et al.
(författare)
-
Study of nonstandard interactions mediated by a scalar field at the ESSnuSB experiment
- 2024
-
Ingår i: Physical Review D. - : American Physical Society. - 2470-0010 .- 2470-0029. ; 109:11
-
Tidskriftsartikel (refereegranskat)abstract
- In this paper, we study scalar mediator induced nonstandard interactions (SNSIs) in the context of the ESSnuSB experiment. In particular, we study the capability of ESSnuSB to put bounds on the SNSI parameters and also study the impact of SNSIs in the measurement of the leptonic CP phase δCP. Existence of SNSIs modifies the neutrino mass matrix and this modification can be expressed in terms of three diagonal real parameters (ηee, ημμ, and ηττ) and three off-diagonal complex parameters (ηeμ, ηeτ, and ημτ). Our study shows that the upper bounds on the parameters ημμ and ηττ depend upon how Δm312 is minimized in the theory. However, this is not the case when one tries to measure the impact of SNSIs on δCP. Further, we show that the CP sensitivity of ESSnuSB can be completely lost for certain values of ηee and ημτ for which the appearance channel probability becomes independent of δCP.
|
|
| 4. |
- Blondel, A., et al.
(författare)
-
The SuperFGD Prototype charged particle beam tests
- 2020
-
Ingår i: Journal of Instrumentation. - : IOP PUBLISHING LTD. - 1748-0221 .- 1748-0221. ; 15:12
-
Tidskriftsartikel (refereegranskat)abstract
- A novel scintillator detector, the SuperFGD, has been selected as the main neutrino target for an upgrade of the T2K experiment ND280 near detector. The detector design will allow nearly 47r coverage for neutrino interactions at the near detector and will provide lower energy thresholds, significantly reducing systematic errors for the experiment. The SuperFGD is made of optically-isolated scintillator cubes of size 10 x 10 x 10 mm(3), providing the required spatial and energy resolution to reduce systematic uncertainties for future T2K runs. The SuperFGD for T2K will have close to two million cubes in a 1920 x 560 x 1840 mm(3) volume. A prototype made of 24 x 8 x 48 cubes was tested at a charged particle beamline at the CERN PS facility. The SuperFGD Prototype was instrumented with readout electronics similar to the future implementation for T2K. Results on electronics and detector response are reported in this paper, along with a discussion of the 3D reconstruction capabilities of this type of detector. Several physics analyses with the prototype data are also discussed, including a study of stopping protons.
|
|
| 5. |
- Burgman, A., et al.
(författare)
-
The ESSnuSB Design Study: Overview and Future Prospects
- 2023
-
Ingår i: Universe. - : MDPI. - 2218-1997. ; 9:8
-
Forskningsöversikt (refereegranskat)abstract
- ESSnuSB is a design study for an experiment to measure the CP violation in the leptonic sector at the second neutrino oscillation maximum using a neutrino beam driven by the uniquely powerful ESS linear accelerator. The reduced impact of systematic errors on sensitivity at the second maximum allows for a very precise measurement of the CP violating parameter. This review describes the fundamental advantages of measurement at the second maximum, the necessary upgrades to the ESS linac in order to produce a neutrino beam, the near and far detector complexes, and the expected physics reach of the proposed ESSnuSB experiment, concluding with the near future developments aimed at the project realization.
|
|
| 6. |
- Burgman, A., et al.
(författare)
-
The European Spallation Source neutrino super-beam conceptual design report
- 2022
-
Ingår i: The European Physical Journal Special Topics. - : Springer Nature. - 1951-6355 .- 1951-6401. ; 231:21, s. 3779-3955
-
Forskningsöversikt (refereegranskat)abstract
- A design study, named ESSνSB for European Spallation Source neutrino Super Beam, has been carried out during the years 2018–2022 of how the 5 MW proton linear accelerator of the European Spallation Source under construction in Lund, Sweden, can be used to produce the world’s most intense long-baseline neutrino beam. The high beam intensity will allow for measuring the neutrino oscillations near the second oscillation maximum at which the CP violation signal is close to three times higher than at the first maximum, where other experiments measure. This will enable CP violation discovery in the leptonic sector for a wider range of values of the CP violating phase δCPδCP and, in particular, a higher precision measurement of δCPδCP. The present Conceptual Design Report describes the results of the design study of the required upgrade of the ESS linac, of the accumulator ring used to compress the linac pulses from 2.86 ms to 1.2 μs, and of the target station, where the 5 MW proton beam is used to produce the intense neutrino beam. It also presents the design of the near detector, which is used to monitor the neutrino beam as well as to measure neutrino cross sections, and of the large underground far detector located 360 km from ESS, where the magnitude of the oscillation appearance of νe from νμ is measured. The physics performance of the ESSνSB research facility has been evaluated demonstrating that after 10 years of data-taking, leptonic CP violation can be detected with more than 5 standard deviation significance over 70% of the range of values that the CP violation phase angle δCPδCP can take and that δCPδCP can be measured with a standard error less than 8° irrespective of the measured value of δCPδCP. These results demonstrate the uniquely high physics performance of the proposed ESSνSBESSνSB research facility.
|
|
| 7. |
- Burgman, A., et al.
(författare)
-
Updated physics performance of the ESSnuSB experiment
- 2021
-
Ingår i: European Physical Journal C. - : Springer Nature. - 1434-6044 .- 1434-6052. ; 81:12
-
Tidskriftsartikel (refereegranskat)abstract
- In this paper, we present the physics performance of the ESSnuSB experiment in the standard three flavor scenario using the updated neutrino flux calculated specifically for the ESSnuSB configuration and updated migration matrices for the far detector. Taking conservative systematic uncertainties corresponding to a normalization error of 5% for signal and 10% for background, we find that there is 10 sigma (13 sigma) CP violation discovery sensitivity for the baseline option of 540 km (360 km) at delta(CP) = +/- 90 degrees. The corresponding fraction of delta(CP )for which CP violation can be discovered at more than 5 sigma is 70%. Regarding CP precision measurements, the 1 sigma error associated with delta(CP )= 0 degrees is around 5 degrees and with delta(CP )= -90 degrees is around 14 degrees (7 degrees) for the baseline option of 540 km (360 km). For hierarchy sensitivity, one can have 3 sigma sensitivity for 540 km baseline except delta(CP) = +/- 90 degrees and 5 sigma sensitivity for 360 km baseline for all values of delta(CP). The octant of theta(23) can be determined at 30 for the values of: theta(23) > 51 degrees (theta(23) < 42 degrees and theta(23) > 49 degrees) for baseline of 540 km (360 km). Regarding measurement precision of the atmospheric mixing parameters, the allowed values at 3 sigma are: 40 degrees < theta(23) < 52 degrees (42 degrees < theta(23) < 51.5 degrees) and 2.485 x 10(-3) eV(2) < Delta(2)(m31) < 2.545 x 10(-3) eV(2) (2.49x 10(-3 ) eV(2) < Delta(2)(m31) < 2.54 x 10(-3) eV(2)) for the baseline of 540 km (360 km).
|
|
| 8. |
- G., Aad, et al.
(författare)
-
A search for the Zγ decay mode of the Higgs boson in pp collisions at s=13 TeV with the ATLAS detector
- 2020
-
Ingår i: Physics Letters, Section B: Nuclear, Elementary Particle and High-Energy Physics. - : Elsevier BV. - 0370-2693 .- 1873-2445. ; 809
-
Tidskriftsartikel (refereegranskat)abstract
- A search for the Zγ decay of the Higgs boson, with Z boson decays into pairs of electrons or muons is presented. The analysis uses proton–proton collision data at s = 13 TeV corresponding to an integrated luminosity of 139 fb−1 recorded by the ATLAS detector at the Large Hadron Collider. The observed data are consistent with the expected background with a p-value of 1.3%. An upper limit at 95% confidence level on the production cross-section times the branching ratio for pp→H→Zγ is set at 3.6 times the Standard Model prediction while 2.6 times is expected in the presence of the Standard Model Higgs boson. The best-fit value for the signal yield normalised to the Standard Model prediction is 2.0−0.9 +1.0 where the statistical component of the uncertainty is dominant. © 2020 The Author
|
|
| 9. |
- G., Aad, et al.
(författare)
-
CP Properties of Higgs Boson Interactions with Top Quarks in the t t ¯ H and tH Processes Using H →γγ with the ATLAS Detector
- 2020
-
Ingår i: Physical Review Letters. - : American Physical Society (APS). - 0031-9007 .- 1079-7114. ; 125:6
-
Tidskriftsartikel (refereegranskat)abstract
- A study of the charge conjugation and parity (CP) properties of the interaction between the Higgs boson and top quarks is presented. Higgs bosons are identified via the diphoton decay channel (H→γγ), and their production in association with a top quark pair (tt¯H) or single top quark (tH) is studied. The analysis uses 139 fb-1 of proton-proton collision data recorded at a center-of-mass energy of s=13 TeV with the ATLAS detector at the Large Hadron Collider. Assuming a CP-even coupling, the tt¯H process is observed with a significance of 5.2 standard deviations. The measured cross section times H→γγ branching ratio is 1.64-0.36+0.38(stat)-0.14+0.17(sys) fb, and the measured rate for tt¯H is 1.43-0.31+0.33(stat)-0.15+0.21(sys) times the Standard Model expectation. The tH production process is not observed and an upper limit on its rate of 12 times the Standard Model expectation is set. A CP-mixing angle greater (less) than 43 (-43)° is excluded at 95% confidence level. © 2020 CERN.
|
|
| 10. |
- G., Aad, et al.
(författare)
-
Evidence for electroweak production of two jets in association with a Zγ pair in pp collisions at s=13 TeV with the ATLAS detector
- 2020
-
Ingår i: Physics Letters, Section B: Nuclear, Elementary Particle and High-Energy Physics. - : Elsevier BV. - 0370-2693 .- 1873-2445. ; 803
-
Tidskriftsartikel (refereegranskat)abstract
- Evidence for electroweak production of two jets in association with a Zγ pair in s=13 TeV proton–proton collisions at the Large Hadron Collider is presented. The analysis uses data collected by the ATLAS detector in 2015 and 2016 that corresponds to an integrated luminosity of 36.1fb−1. Events that contain a Z boson candidate decaying leptonically into either e+e− or μ+μ−, a photon, and two jets are selected. The electroweak component is measured with observed and expected significances of 4.1 standard deviations. The fiducial cross-section for electroweak production is measured to be σZγjj−EW=7.8±2.0fb, in good agreement with the Standard Model prediction. © 2020 The Author(s)
|
|
