| 1. |
|
|
| 2. |
|
|
| 3. |
- Lamalle, P. U., et al.
(författare)
-
Expanding the operating space of ICRF on JET with a view to ITER
- 2006
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 0029-5515 .- 1741-4326. ; 46:2, s. 391-400
-
Tidskriftsartikel (refereegranskat)abstract
- This paper reports on ITER-relevant ion cyclotron resonance frequency (ICRF) physics investigated on JET in 2003 and early 2004. Minority heating of helium three in hydrogen plasmas-(He-3)H-was systematically explored by varying the 3 He concentration and the toroidal phasing of the antenna arrays. The best heating performance (a maximum electron temperature of 6.2 keV with 5 MW of ICRF power) was obtained with a preferential wave launch in the direction of the plasma current. A clear experimental demonstration was made of the sharp and reproducible transition to the mode conversion heating regime when the 3 He concentration increased above similar to 2%. In the latter regime the best heating performance (a maximum electron temperature of 8 keV with 5 MW of ICRF power) was achieved with dipole array phasing, i.e. a symmetric antenna power spectrum. Minority heating of deuterium in hydrogen plasmas-(D)H-was also investigated but was found inaccessible because this scenario is too sensitive to impurity ions with Z/A = 1/2 such as C6+, small amounts of which directly lead into the mode conversion regime. Minority heating of up to 3% of tritium in deuterium plasmas was systematically investigated during the JET trace tritium experimental campaign (TTE). This required operating JET at its highest possible magnetic field (3.9 to 4 T) and the ICRF system at its lowest frequency (23 MHz). The interest of this scenario for ICRF heating at these low concentrations and its efficiency at boosting the suprathermal neutron yield were confirmed, and the measured neutron and gammay ray spectra permit interesting comparisons with advanced ICRF code simulations. Investigations of finite Larmor radius effects on the RF-induced high-energy tails during second harmonic (omega = 2 omega(c)) heating of a hydrogen minority in D plasmas clearly demonstrated a strong decrease in the RF diffusion coefficient at proton energies similar to 1 MeV in agreement with theoretical expectations. Fast wave heating and current drive experiments in deuterium plasmas showed effective direct electron heating with dipole phasing of the antennas, but only small changes of the central plasma current density were observed with the directive phasings, in particular at low single pass damping. New investigations of the heating efficiency of ICRF antennas confirmed its strong dependence on the parallel wavenumber spectrum. Advances in topics of a more technological nature are also summarized: ELM studies using fast RF measurements, the successful experimental demonstration of a new ELM-tolerant antenna matching scheme and technical enhancements planned on the JET ICRF system for 2006, they being equally strongly driven by the preparation for ITER.
|
|
| 4. |
- Lamalle, P.U, et al.
(författare)
-
Expanding the operating space of ICRF on JET with a view to ITER
- 2006
-
Ingår i: Nucl. Fusion. ; 46, s. 391-
-
Tidskriftsartikel (refereegranskat)abstract
- Mercury (Hg) has been used for millennia in many applications, primarily in artisanal mining and as an electrode in the chlor–alkali industry. It is anthropogenically emitted as a pollutant from coal fired power plants and naturally emitted, primarily from volcanoes. Its unique chemical characteristics enable global atmospheric transport and it is deposited after various processes, ultimately ending up in one of its final sinks, such as incorporated into deep sediment or bioaccumulated, primarily in the marine environment. All forms of Hg have been established as toxic, and there have been no noted biological benefits from the metal.Throughout time, there have been notable incidents of Hg intoxication documented, and the negative health effects have been documented to those chronically or acutely exposed. Today, exposure to Hg is largely diet or occupationally dependent, however, many are exposed to Hg from their amalgam fillings. This paper puts a tentative monetary value on Hg polluted food sources in the Arctic, where local, significant pollution sources are limited, and relates this to costs for strategies avoiding Hg pollution and to remediation costs of contaminated sites in Sweden and Japan. The case studies are compiled to help policy makers and the public to evaluate whether the benefits to the global environment from banning Hg and limiting its initial emission outweigh the benefits from its continued use or lack of control of Hg emissions. The cases we studied are relevant for point pollution sources globally and their remediation costs ranged between 2500 and 1.1 million US$ kg−1 Hg isolated from the biosphere. Therefore, regulations discontinuing mercury uses combined with extensive flue gas cleaning for all power plants and waste incinerators is cost effective.
|
|
| 5. |
|
|
| 6. |
- Abdu, Y. A., et al.
(författare)
-
High-temperature cation ordering in olivine : an in situ Mossbauer study of synthetic (Mg0.55Fe0.45)(2) SiO4
- 2008
-
Ingår i: Hyperfine Interactions. - : Springer Science and Business Media LLC. - 0304-3843 .- 1572-9540. ; 186:1-3, s. 99-103
-
Tidskriftsartikel (refereegranskat)abstract
- High- temperature in situ Mossbauer spectroscopy measurements ( 300 950. C) were done on synthetic olivine of composition ( Mg0.55Fe0.45) 2 SiO4 (= Fa45) in order to study the distribution of Fe2+ over the M1 and M2 octahedral sites. The spectra are fit with two doublets, which are assigned to Fe2+ at the M1 ( smaller splitting) and M2 sites. The Fe2+ site- occupancies at M1 and M2, obtained from the Mossbauer relative areas, suggest that Fe2+ has a slight preference for the M1 site at temperatures below similar to 500. C, with a tendency of disordering around this temperature. At higher temperatures, Fe2+ again prefers to occupy the M1 site, where it shows a considerable order at this site up to 750C. At still higher temperatures, the spectra indicated partial reduction of the Fa- component into metallic iron and the resolution of the doublets was severely deteriorated.
|
|
| 7. |
|
|
| 8. |
- Chan, T., et al.
(författare)
-
DECOVALEX III BMT3/BENCHPAR WP4 : The thermo-hydro-mechanical responses to a glacial cycle and their potential implications for deep geological disposal of nuclear fuel waste in a fractured crystalline rock mass
- 2005
-
Ingår i: International Journal of Rock Mechanics And Mining Sciences. - : Elsevier BV. - 1365-1609 .- 1873-4545. ; 42:5-6, s. 805-827
-
Tidskriftsartikel (refereegranskat)abstract
- A number of studies related to past and on-going deep repository performance assessments have identified glaciation/ deglaciation as major future events in the next few hundred thousand years capable of causing significant impact on the long term performance of the repository system. Benchmark Test 3 (BMT3) of the international DECOVALEX III project has been designed to provide an illustrative example that explores the mechanical and hydraulic response of a fractured crystalline rock mass to a period of glaciation. The primary purpose of this numerical study is to investigate whether transient events associated with a glacial cycle could significantly influence the performance of a deep geological repository in a crystalline Shield setting. A conceptual site-scale (tens of kilometres) hydro-mechanical (HM) model was assembled based primarily on site-specific litho-structural, hydrogeological and geomechanical data from the Whiteshell Research Area in the Canadian Shield, with simplification and generalization. Continental glaciological modelling of the Laurentide ice sheet through the last glacial cycle lasting approximately 100,000 years suggests that this site was glaciated at about 60 ka and between about 22.5 and 11 ka before present with maximum ice sheet thickness reaching 2500 m and maximum basal water pressure head reaching 2000m. The ice-sheet/drainage model was scaled down to generate spatially and temporally variable hydraulic and mechanical glaciated surface boundary conditions for site-scale subsurface HM modelling and permafrost modelling. Under extreme periglacial conditions permafrost was able to develop down to the assumed 500-m repository horizon. Two- and three-dimensional coupled HM finite-element simulations indicate: during ice-sheet advance there is rapid rise in hydraulic head, high transient hydraulic gradients and high groundwater velocities 2-3 orders of magnitude higher than under nonglacial conditions; surface water recharges deeper than under nonglacial conditions; upon ice-sheet retreat, the gradients reverse; fracture zone network geometry, interconnectivity and hydraulic properties significantly influence flow domain response; residual elevated heads are preserved for 10,000s in the low-diffusivity rock; and no hydraulic jacking or shear failure occurs at depth. It was found that transient coupled modelling is necessary to capture the essence of glacial effects on Performance Assessment. Model dimensionality also significantly affects simulated results.
|
|
| 9. |
- Ericsson, AnnMarie, 1972-
(författare)
-
Enabling Tool Support for Formal Analysis of ECA Rules
- 2009
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- Rule-based systems implemented as event-condition-action (ECA) rules utilize a powerful and flexible paradigm when it comes to specifying systems that need to react to complex situation in their environment. Rules can be specified to react to combinations of events occurring at any time in any order. However, the behavior of a rule based system is notoriously hard to analyze due to the rules ability to interact with each other.Formal methods are not utilized in their full potential for enhancing software quality in practice. We argue that seamless support in a high-level paradigm specific tool is a viable way to provide industrial system designers with powerful verification techniques. This thesis targets the issue of formally verifying that a set of specified rules behaves as indented.The prototype tool REX (Rule and Event eXplorer) is developed as a proof of concept of the results of this thesis. Rules and events are specified in REX which is acting as a rule-based front-end to the existing timed automata CASE tool UPPAAL. The rules, events and requirements of application design are specified in REX. To support formal verification, REX automatically transforms the specified rules to timed automata, queries the requirement properties in the model-checker provided by UPPAAL and returns results to the user of REX in terms of rules and events.The results of this thesis consist of guidelines for modeling and verifying rules in a timed automata model-checker and experiences from using and building a tool implementing the proposed guidelines. Moreover, the result of an industrial case study is presented, validating the ability to model and verify a system of industrial complexity using the proposed approach.
|
|
| 10. |
|
|
