| 1. |
- Romanelli, F, et al.
(författare)
-
Overview of the JET results
- 2011
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 51:9
-
Tidskriftsartikel (refereegranskat)abstract
- Since the last IAEA Conference JET has been in operation for one year with a programmatic focus on the qualification of ITER operating scenarios, the consolidation of ITER design choices and preparation for plasma operation with the ITER-like wall presently being installed in JET. Good progress has been achieved, including stationary ELMy H-mode operation at 4.5 MA. The high confinement hybrid scenario has been extended to high triangularity, lower ρ*and to pulse lengths comparable to the resistive time. The steady-state scenario has also been extended to lower ρ*and ν*and optimized to simultaneously achieve, under stationary conditions, ITER-like values of all other relevant normalized parameters. A dedicated helium campaign has allowed key aspects of plasma control and H-mode operation for the ITER non-activated phase to be evaluated. Effective sawtooth control by fast ions has been demonstrated with3He minority ICRH, a scenario with negligible minority current drive. Edge localized mode (ELM) control studies using external n = 1 and n = 2 perturbation fields have found a resonance effect in ELM frequency for specific q95values. Complete ELM suppression has, however, not been observed, even with an edge Chirikov parameter larger than 1. Pellet ELM pacing has been demonstrated and the minimum pellet size needed to trigger an ELM has been estimated. For both natural and mitigated ELMs a broadening of the divertor ELM-wetted area with increasing ELM size has been found. In disruption studies with massive gas injection up to 50% of the thermal energy could be radiated before, and 20% during, the thermal quench. Halo currents could be reduced by 60% and, using argon/deuterium and neon/deuterium gas mixtures, runaway electron generation could be avoided. Most objectives of the ITER-like ICRH antenna have been demonstrated; matching with closely packed straps, ELM resilience, scattering matrix arc detection and operation at high power density (6.2 MW m-2) and antenna strap voltages (42 kV). Coupling measurements are in very good agreement with TOPICA modelling. © 2011 IAEA, Vienna.
|
|
| 2. |
- Abel, I, et al.
(författare)
-
Overview of the JET results with the ITER-like wall
- 2013
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:10, s. 104002-
-
Tidskriftsartikel (refereegranskat)abstract
- Following the completion in May 2011 of the shutdown for the installation of the beryllium wall and the tungsten divertor, the first set of JET campaigns have addressed the investigation of the retention properties and the development of operational scenarios with the new plasma-facing materials. The large reduction in the carbon content (more than a factor ten) led to a much lower Z(eff) (1.2-1.4) during L- and H-mode plasmas, and radiation during the burn-through phase of the plasma initiation with the consequence that breakdown failures are almost absent. Gas balance experiments have shown that the fuel retention rate with the new wall is substantially reduced with respect to the C wall. The re-establishment of the baseline H-mode and hybrid scenarios compatible with the new wall has required an optimization of the control of metallic impurity sources and heat loads. Stable type-I ELMy H-mode regimes with H-98,H-y2 close to 1 and beta(N) similar to 1.6 have been achieved using gas injection. ELM frequency is a key factor for the control of the metallic impurity accumulation. Pedestal temperatures tend to be lower with the new wall, leading to reduced confinement, but nitrogen seeding restores high pedestal temperatures and confinement. Compared with the carbon wall, major disruptions with the new wall show a lower radiated power and a slower current quench. The higher heat loads on Be wall plasma-facing components due to lower radiation made the routine use of massive gas injection for disruption mitigation essential.
|
|
| 3. |
- Kiptily, V. G., et al.
(författare)
-
Fusion Alpha-Particle Diagnostics for DT Experiments on the Joint European Torus
- 2014
-
Ingår i: FUSION REACTOR DIAGNOSTICS. - : AIP Publishing LLC. ; , s. 87-92
-
Konferensbidrag (refereegranskat)abstract
- JET equipped with ITER-like wall (a beryllium wall and a tungsten divertor) can provide auxiliary heating with power up to 35MW, producing a significant population of alpha-particles in DT operation. The direct measurements of alphas are very difficult and alpha-particle studies require a significant development of dedicated diagnostics. JET now has an excellent set of confined and lost fast particle diagnostics for measuring the alpha-particle source and its evolution in space and time, alpha-particle energy distribution, and alpha-particle losses. This paper describes how the above mentioned JET diagnostic systems could be used for alpha-particle measurements, and what options exist for keeping the essential alpha-particle diagnostics functioning well in the presence of intense DT neutron flux. Also, alpha-particle diagnostics for ITER are discussed.
|
|
| 4. |
- Nocente, M., et al.
(författare)
-
High-resolution gamma ray spectroscopy measurements of the fast ion energy distribution in JET He-4 plasmas
- 2012
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 0029-5515 .- 1741-4326. ; 52:6, s. 063009-
-
Tidskriftsartikel (refereegranskat)abstract
- High-resolution gamma-ray measurements were carried out on the Joint European Torus (JET) in an experiment aimed at accelerating He-4 ions in the MeV range by coupling third harmonic radio frequency heating to an injected He-4 beam. For the first time, Doppler broadening of gamma-ray peaks from the C-12(d, p gamma)C-13 and Be-9(alpha, n gamma)C-12 reactions was observed and interpreted with dedicated Monte Carlo codes based on the detailed nuclear physics of the processes. Information on the confined He-4 and deuteron energy distribution was inferred, and confined He-4 ions with energies as high as 6 MeV were assessed. A signature of MHD activity in gamma-ray traces was also detected. The reported results have a bearing on diagnostics for fast ions in the MeV range in next step fusion devices.
|
|
| 5. |
- Kiptily, V., et al.
(författare)
-
Doppler broadening of gamma ray lines and fast ion distribution in JET plasmas
- 2010
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 0029-5515 .- 1741-4326. ; 50:8, s. 084001-
-
Tidskriftsartikel (refereegranskat)abstract
- The Doppler broadening of individual γ-ray lines was measured with a high purity germanium detector in JET plasma experiments. High-resolution γ-ray spectrometry of nuclear reactions between energetic D, 3 He and 4 He ions accelerated by ion cyclotron resonance heating and main plasma impurities such as carbon and beryllium has been used. The nuclear reactions giving rise to γ-rays have been identified and an effective temperature of the heated ions has been obtained in JET discharges. This technique could be used for fast ion and fusion alpha-particle studies in ITER.
|
|
| 6. |
- Rafat, Mehrdad, et al.
(författare)
-
PEG-PLAmicroparticles for encapsulation and delivery of Tat-EGFP to retinal cells
- 2010
-
Ingår i: Biomaterials. - : Elsevier. - 0142-9612 .- 1878-5905. ; 31:12, s. 3414-3421
-
Tidskriftsartikel (refereegranskat)abstract
- The efficient and controlled delivery of genes and proteins to retinal cells remains a challenge. In this study, we evaluated polyethylene glycol-polylactic acid (PEG–PLA) microparticles for encapsulation and delivery of a Transactivator of transcription-enhanced green fluorescent protein fusion (Tat-EGFP) to retinal cells. Our main objective was to develop a microparticle system that delivers Tat-EGFP with an initial rapid release (within 24 h) followed by a sustained release. We prepared four different formulations of Tat-EGFP encapsulated PEG–PLA particles to investigate the effects of protein and polymer concentrations on particle morphology and protein release, using scanning electron microscopy (SEM) and fluorometry techniques. The optimum formulation was selected based on higher protein release, and smaller particle size. The optimum formulation was then tested in vitro for cell biocompatibility and protein internalization, and in vivo for cellular toxicity following sub-retinal injections into rat eyes. The results suggest that PEG–PLA microparticles can deliver proteins in cell culture allowing protein internalization in as little as 1 h. In vivo, protein was shown to localize within the photoreceptor layer of the retina, and persist for at least 9 weeks with no observed toxicity.
|
|
