| 1. |
- Ferreira, Mjv, et al.
(författare)
-
Poster Session 3 : Tuesday 5 May 2015, 08
- 2015
-
Ingår i: European Heart Journal Cardiovascular Imaging. - : Oxford University Press (OUP). - 2047-2404 .- 2047-2412. ; 16 Suppl 1
-
Tidskriftsartikel (refereegranskat)
|
|
| 2. |
- Gamelas, José A. F., et al.
(författare)
-
On the morphology of cellulose nanofibrils obtained by TEMPO-mediated oxidation and mechanical treatment
- 2015
-
Ingår i: Micron. - : Elsevier BV. - 0968-4328 .- 1878-4291. ; 72, s. 28-33
-
Tidskriftsartikel (refereegranskat)abstract
- The morphological properties of cellulose nanofibrils obtained from eucalyptus pulp fibres were assessed. Two samples were produced with the same chemical treatment (NaClO/NaBr/TEMPO (2,2,6,6-tetramethylpiperidine-1-oxyl radical) oxidation), but distinct mechanical treatment intensities during homogenization. It was shown that the nanofibrils production yield increases with the mechanical energy. The effect of mechanical treatment on the yield was confirmed by laser profilometry of air-dried nanocellulose films. However, no significant differences were detected regarding the nanofibrils width as measured by atomic force microscopy (AFM) of air-dried films. On the other hand, differences in size were found either by laser diffraction spectroscopy or by dynamic light scattering (DLS) of the cellulose nanofibrils suspensions as a consequence of the differences in the length distribution of both samples. The nanofibrils length of the more nanofibrillated sample was calculated based on the width measured by AFM and the hydrodynamic diameter obtained by DLS. A length value of ca. 600. nm was estimated. The DLS hydrodynamic diameter, as an equivalent spherical diameter, was used to estimate the nanofibrils length assuming a cylinder with the same volume and with the diameter (width) assessed by AFM. A simple method is thus proposed to evaluate the cellulose nanofibrils length combining microscopy and light scattering methods.
|
|
| 3. |
- Liu, Tao, et al.
(författare)
-
Understanding LiOH Formation in a Li-O2 Battery with LiI and H2O Additives
- 2019
-
Ingår i: ACS Catalysis. - : American Chemical Society (ACS). - 2155-5435. ; 9:1, s. 66-77
-
Tidskriftsartikel (refereegranskat)abstract
- LiI-promoted LiOH formation in Li-O2 batteries with wet ether electrolytes has been investigated by Raman, nuclear magnetic resonance spectroscopy, operando pressure tests, and molecular dynamics simulations. We find that LiOH formation is a synergistic effect involving both H2O and LiI additives, whereas with either alone Li2O2 forms. LiOH is generated via a nominal four-electron oxygen reduction reaction, the hydrogen coming from H2O and the oxygen from both O2 and H2O, and with fewer side reactions than typically associated with Li2O2 formation; the presence of fewer parasitic reactions is attributed to the proton donor role of water, which can coordinate to O2- and the higher chemical stability of LiOH. Iodide plays a catalytic role in decomposing H2O2/HO2- and thereby promoting LiOH formation, its efficacy being highly dependent on the water concentration. This iodide catalysis becomes retarded at high water contents due to the formation of large water-solvated clusters, and Li2O2 forms again.
|
|
| 4. |
- Rosenberg, M. J. F., et al.
(författare)
-
The Herschel Comprehensive (U)lirg Emission Survey (Hercules): Co Ladders, Fine Structure Lines, and Neutral Gas Cooling
- 2015
-
Ingår i: Astrophysical Journal. - : American Astronomical Society. - 1538-4357 .- 0004-637X. ; 801:2
-
Tidskriftsartikel (refereegranskat)abstract
- (Ultra) luminous infrared galaxies ((U)LIRGs) are objects characterized by their extreme infrared (8-1000 mu m) luminosities (L-LIRG > 10(11) L-circle dot and L-ULIRG > 10(12) L-circle dot). The Herschel Comprehensive ULIRG Emission Survey (PI: van derWerf) presents a representative flux-limited sample of 29 (U)LIRGs that spans the full luminosity range of these objects (10(11)L(circle dot)
|
|
| 5. |
- Zamora, Juan Carlos, et al.
(författare)
-
Considerations and consequences of allowing DNA sequence data as types of fungal taxa
- 2018
-
Ingår i: IMA Fungus. - : INT MYCOLOGICAL ASSOC. - 2210-6340 .- 2210-6359. ; 9:1, s. 167-185
-
Tidskriftsartikel (refereegranskat)abstract
- Nomenclatural type definitions are one of the most important concepts in biological nomenclature. Being physical objects that can be re-studied by other researchers, types permanently link taxonomy (an artificial agreement to classify biological diversity) with nomenclature (an artificial agreement to name biological diversity). Two proposals to amend the International Code of Nomenclature for algae, fungi, and plants (ICN), allowing DNA sequences alone (of any region and extent) to serve as types of taxon names for voucherless fungi (mainly putative taxa from environmental DNA sequences), have been submitted to be voted on at the 11th International Mycological Congress (Puerto Rico, July 2018). We consider various genetic processes affecting the distribution of alleles among taxa and find that alleles may not consistently and uniquely represent the species within which they are contained. Should the proposals be accepted, the meaning of nomenclatural types would change in a fundamental way from physical objects as sources of data to the data themselves. Such changes are conducive to irreproducible science, the potential typification on artefactual data, and massive creation of names with low information content, ultimately causing nomenclatural instability and unnecessary work for future researchers that would stall future explorations of fungal diversity. We conclude that the acceptance of DNA sequences alone as types of names of taxa, under the terms used in the current proposals, is unnecessary and would not solve the problem of naming putative taxa known only from DNA sequences in a scientifically defensible way. As an alternative, we highlight the use of formulas for naming putative taxa (candidate taxa) that do not require any modification of the ICN.
|
|
