Temperature increases during surface decontamination of titanium implants using CO2 laser.

• The purpose of the present in vitro investigation was to measure temperature changes at the implant surface when using pulsed CO2 laser in a simulated implant surface decontamination protocol. Six threaded titanium implants were placed in a fresh resected pig mandible. A 4 x 4 mm defect was created buccally to each implant in order to expose the implant head and approximately 5 threads. Temperature changes were monitored by two thermocouples placed near the dehiscence and at the apical part of the implant. Several setting combinations of the CO2 laser with regard to output power, pulse width, pulse repetition rate and irradiation time were tested on dry and wet (distilled water) surfaces. Only minor temperature increases were measured when lasing wet titanium surfaces, while the temperature at dry surfaces exceeded the proposed thresholds for bone damage at clinically relevant settings. It is concluded that the CO2 laser when used on a wet implant surface in a pulsed mode at 8 W/10 ms/20 hz during 5 s induces a temperature increase of less than 3 degrees C. This would minimize the risk of temperature induced tissue damage as a result of lasing implant surfaces.

Ämnesord

MEDICIN OCH HÄLSOVETENSKAP  -- Klinisk medicin -- Odontologi (hsv//swe)

MEDICAL AND HEALTH SCIENCES  -- Clinical Medicine -- Dentistry (hsv//eng)

Nyckelord

Animals

Bone and Bones

injuries

Carbon Dioxide

Decontamination

instrumentation

Dental Implants

Hot Temperature

Lasers

adverse effects

Swine

Temperature

Titanium

Water

chemistry

Publikations- och innehållstyp

ref (ämneskategori)

art (ämneskategori)