| 1. |
- Byass, Peter, et al.
(författare)
-
The role of demographic surveillance systems (DSS) in assessing the health of communities : an example from rural Ethiopia
- 2002
-
Ingår i: Public Health. - : Elsevier BV. - 0033-3506 .- 1476-5616. ; 116:3, s. 145-150
-
Tidskriftsartikel (refereegranskat)abstract
- Longitudinal demographic surveillance systems (DSSs) in selected populations can provide important information in situations where routine health information is incomplete or absent, particularly in developing countries. The Butajira Rural Health Project is one such example, initiated in rural Ethiopia in 1987. DSSs rely on regular community-based surveillance as a means of vital event registration, among a sufficient population base to draw meaningful conclusions about rates and trends in relatively rare events such as maternal death. Enquiries into specific health problems can also then use this framework to quantify particular issues or evaluate interventions. Demographic characteristics and trends for a rural Ethiopian population over a 10-y period are presented as an illustration of the DSS approach, based on 336 000 person-years observed. Overall life expectancy at birth was 50 y. Demographic parameters generally showed modest trends towards improvement over the 10-y period. The DSS approach is useful in characterising populations at the community level over a period of time, providing important information for health planning and intervention. Methodological issues underlying this approach need further exploration and development.
|
|
| 2. |
|
|
| 3. |
- Emmerlich, Jens, 1974-, et al.
(författare)
-
Growth of Ti3SiC2 thin films by elemental target magnetron sputtering
- 2004
-
Ingår i: Journal of Applied Physics. - : AIP Publishing. - 0021-8979 .- 1089-7550. ; 96:9, s. 4817-4826
-
Tidskriftsartikel (refereegranskat)abstract
- Epitaxial Ti3SiC2(0001) thin films have been deposited by dc magnetron sputtering from three elemental targets of Ti, C, and Si onto MgO(111) and Al2O3(0001) substrates at temperatures of 800–900 °C. This process allows composition control to synthesize Mn + 1AXn (MAX) phases (M: early transition metal; A: A-group element; X: C and/or N; n = 1–3) including Ti4SiC3. Depositions on MgO(100) substrates yielding the Ti–Si–C MAX phases with (105), as the preferred orientation. Samples grown at different substrate temperatures, studied by means of transmission electron microscopy and x-ray diffraction investigations, revealed the constraints of Ti3SiC2 nucleation due to kinetic limitations at substrate temperatures below 700 °C. Instead, there is a competitive TiCx growth with Si segregation to form twin boundaries or Si substitutional incorporation in TiCx. Physical properties of the as-deposited single-crystal Ti3SiC2 films were determined. A low resistivity of 25 µ cm was measured. The Young's modulus, ascertained by nanoindentation, yielded a value of 343–370 GPa. For the mechanical deformation response of the material, probing with cube corner and Berkovich indenters showed an initial high hardness of almost 30 GPa. With increased maximum indentation loads, the hardness was observed to decrease toward bulk values as the characteristic kink formation sets in with dislocation ordering and delamination at basal planes.
|
|
| 4. |
|
|
| 5. |
|
|
| 6. |
|
|
| 7. |
|
|
| 8. |
- Högberg, Hans, et al.
(författare)
-
Deposition of transition metal carbides and superlattices using C-60 as carbon source
- 2000
-
Ingår i: JOURNAL OF THE ELECTROCHEMICAL SOCIETY. - 0013-4651. ; 147:9, s. 3361-3369
-
Tidskriftsartikel (refereegranskat)abstract
- Thin films of TiC, VC, and NbC have been deposited on MgO(001) by coevaporation of the metals and C-60 It was found that these metals induced a decomposition of the C-60 molecule and that carbide films can be formed at a temperature as low as 100 degrees
|
|
| 9. |
|
|
| 10. |
|
|
