| 1. |
|
|
| 2. |
|
|
| 3. |
- Ferreira da Silva, Eduardo, et al.
(författare)
-
Heavy metal pollution downstream the abandoned Coval da Mó mine (Portugal) and associated effects on epilithic diatom communities
- 2009
-
Ingår i: Science of the Total Environment. - : Elsevier BV. - 0048-9697 .- 1879-1026. ; 407:21, s. 5620-5636
-
Tidskriftsartikel (refereegranskat)abstract
- This study examined trace-element concentrations in 39 sediment samples collected in the vicinity of the abandoned Coval da Mó mine, and evaluated the anthropogenic contaminant effects and other environmental variables in the taxonomic composition, structure and morphological changes of benthic diatom communities.The results show the existence of extremely high contamination in Pb, Zn and Cd (the mean values exceed the background values 376, 96 and 19 times, respectively) on the first 2.5 km in the water flow direction. Also Co, Cu, Mn and Ni are present in high concentrations. Dilution by relatively uncontaminated sediment reduces metal concentrations downstream, but Zn concentrations increase downstream Fílvida stream, as a result of several factors such as sewage and agriculture.To evaluate the biological effects caused by Pb, Cd and Zn, three sites were selected. In the stressed environment, near the mining area (C232), diatoms were extremely rare, however there was a slight recovery at site C79 located 2 km downstream. Fragilaria capucina var. rumpens, Fragilaria cf. crotonensis and Achnanthidium minutissimum showed abnormal valves which may be related to high levels of metals.Six km downstream, in Fílvida stream (C85), an increase in species richness and diversity was registered while the relative percentage of valve teratologies was lower. In the absence of OM, nutrients and low pH the diatom community patterns must be attributed to the metal concentration at some sites. Considering that community diversity can be affected by abiotic and biotic variables and valve deformations are caused by a small number of variables, basically metals, and acid conditions, we consider the presence of teratologies as an indication of the presence of metals.
|
|
| 4. |
- Hammar, N., et al.
(författare)
-
Migration and differences in dietary habits : a cross sectional study of Finnish twins in Sweden
- 2009
-
Ingår i: European Journal of Clinical Nutrition. - : Springer Science and Business Media LLC. - 0954-3007 .- 1476-5640. ; Oct 17
-
Tidskriftsartikel (refereegranskat)abstract
- Objective: To compare dietary habits between Finnish twin migrants to Sweden and their co-twins always living in Finland, and to analyse how migration influenced food consumption patterns in the migrants. Subjects/Methods: Same-sexed twin pairs born in Finland below 75 years of age, with at least one twin migrating to Sweden(n=1083 pairs). Dietary habits were assessed by a food frequency questionnaire included in a comprehensive mailed questionnaire (response rate 71%). For 76 male twin pairs, information was also collected by a dietary history interview inquiring the habitual diet during the previous year. Results: Migrant twins in Sweden had a lower intake of typical Finnish foods like dark bread and berries, and an increased consumption of fresh fruit compared with co-twins living in Finland. The migrants consumed less potatoes and more rice and pasta. Sweet pastries were consumed less often by the migrants and they also tended to more often cut out visible fat of meat and on the other hand add salt to dishes. Among men the migrants had a lower alcohol intake than their co-twins living in Finland. Conclusions: Migration from Finland to Sweden is associated with differences in the food pattern that reflect population differences in eating habits between the two countries. The differences include a reduced consumption of typical Finnish foods like dark bread and berries and are of bidirectional nature from the point of view of cardiovascular health.
|
|
| 5. |
|
|
| 6. |
- Hedlund, E., et al.
(författare)
-
A new test stand for heavy ion induced gas desorption measurements at TSL
- 2008
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 586:3, s. 377-381
-
Tidskriftsartikel (refereegranskat)abstract
- In several experiments at CERN, GSI and BNL it has been found that the lifetime of highly energetic heavy ions in synchrotrons decreases with increasing number of injected ions. This phenomenon occurs due to the collisions of beam ions and residual gas molecules leading to the change of charge of the ions and their loss on the vacuum chamber walls, which in turn cause ion-induced gas desorption and further pressure increase. To gain a deeper understanding of the ion-induced desorption process in the energy range 5-45 MeV/u, a dedicated test stand was built at the end of the K beamline at The Svedberg Laboratory (TSL) in Uppsala, Sweden. The energy range was chosen due to the fact that the injection energy of the heavy ion synchrotron SIS18 at GSI will be 10 MeV/u, and that there are insufficient data in this energy range. A Test Particle Monte-Carlo model of the experimental set-up was build-up, run and analysed for different sample configurations. An important result is that for the same sample material the desorption yield from a flat sample causes a 1.58 times larger pressure increase than that of a tubular sample. A detailed explanation of the set-up is presented.
|
|
| 7. |
|
|
| 8. |
- Hedlund, E., et al.
(författare)
-
Ar ion induced desorption yields at the energies 5-17.7 MeV/u
- 2009
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 599:1, s. 1-8
-
Tidskriftsartikel (refereegranskat)abstract
- Particle accelerators have, during Operation with heavy ion beams, shown a significant pressure rise when the intensity of the beam is increased. This pressure rise is due to ion induced desorption, which is the result of beam ions colliding with residual gas atoms in the beam pipe, where they undergo charge exchange. This causes them to hit the vacuum chamber after the next dipole magnet and gas to be released. For the upgrade of the SIS18 synchrotron at GSI the intensity has to be a few orders of magnitude higher than it is today at the injection energy of 10 MeV/u. The aim of this experiment is to measure desorption yields, n, (released Molecules per incident ion) from materials commonly used in accelerators: 316LN stainless steel, Cu, etched Cu, gold coated Cu and Ta, using an Ar beam at impact energies in the range of 5-17.7 MeV/u for perpendicular incidence. The measured initial desorption yields vary for the same material from sample to sample: up to 4.5 times for stainless steel and Lip to 3 times for etched Cu. Therefore more samples should be Studied to have better statistics. Beam conditioning at lower energy does not significantly reduce the desorption yield at higher energy. There is a significant difference Of Lip to a few times in desorption yield between flat and tubular samples. The desorption yield from a Cu sample at grazing incident angle of 125 mrad was an order of magnitude larger than at normal incident angle. It Was found that the total number of positively and negatively charged secondary particles, emitted from the Surface bombarded with heavy ions, does not exceed -40 secondary particles per impact heavy ion. The current of negatively charged particles was about 2.3 times larger than the current for positively charged particles. The impact from secondary particles on dynamic gas pressure was not possible to investigate.
|
|
| 9. |
- Hedlund, E., et al.
(författare)
-
Heavy-ion induced desorption of a TiZrV coated vacuum chamber bombarded with 5 MeV/u Ar8+ beam at grazing incidence
- 2009
-
Ingår i: Journal of Vacuum Science & Technology. A. Vacuum, Surfaces, and Films. - : American Vacuum Society. - 0734-2101 .- 1520-8559. ; 27:1, s. 139-144
-
Tidskriftsartikel (refereegranskat)abstract
- TiZrV nonevaporable getter (NEG) coated vacuum chambers is a new vacuum technology which is already used in many particle accelerators worldwide. This coating is also of interest for heavy-ion accelerator vacuum chambers. Heavy-ion desorption yields from an activated as well as a CO saturated NEG coated tube have been measured with 5 MeV/u Ar8+ beam. The sticking probability of the NEG film was obtained by using the partial pressure ratios on two sides of the NEG coated tube. These ratios were compared to results of modeling of the experimental setup with test particle Monte Carlo and angular coefficient methods. The partial pressures inside the saturated NEG coated tube bombarded with heavy ions were up to 20 times larger than those inside the activated one. However, the partial pressure of methane remained the same. The value of the total desorption yield from the activated NEG coated tube is 2600 molecules/ion. The desorption yields after saturation for CH4, H-2, and CO2 were found to be very close to the yields measured after the activation, while CO increased by up to a factor of 5. The total desorption yield for the saturated tube is up to 7000 molecules/ion. The large value of the desorption yield of the activated NEG coated tube, an order of magnitude higher than the desorption yield from a stainless steel tube at normal incident angle, could be explained by the grazing incident angle.
|
|
| 10. |
- Hedlund, Emma, et al.
(författare)
-
Improved determination of the gas flow rate for UHV and leak metrology with laser refractometry
- 2006
-
Ingår i: Measurement science and technology. - : IOP Publishing. - 0957-0233 .- 1361-6501. ; 17:10, s. 2767-2772
-
Tidskriftsartikel (refereegranskat)abstract
- A system often used for vacuum metrology purposes in order to calibrate vacuum gauges in the UHV region and to calibrate gas leak rates is the throughput system, employing the continuous ( or dynamic) expansion method. An important component in such systems is the flowmeter, which has to deliver a pure and well-determined gas flow into the system. To determine the generated gas flow, a number of factors including the pressure inside the flowmeter have to be determined. However, it has turned out that the calibration uncertainty when measuring the pressure in the flowmeter gives a main contribution to the total uncertainty (of typically about 0.1%) for the generated flow, thereby limiting the accuracies of the generated vacuum pressure as well as gas leak rates in UHV metrology. A feasibility study is reported in this paper about the possibility of using laser refractometry to monitor dynamic gas density in situ in the flowmeter, as an alternative and possibly more accurate means of determining the generated gas flow, thereby potentially improving the calibration gas leak rates in the range 10(-8) - 10(-4) Pa m(3) s(-1).
|
|
