SwePub
Tyck till om SwePub Sök här!
Sök i SwePub databas

  Utökad sökning

Träfflista för sökning "WFRF:(Horacek J) srt2:(2010-2014)"

Sökning: WFRF:(Horacek J) > (2010-2014)

  • Resultat 1-6 av 6
Sortera/gruppera träfflistan
   
NumreringReferensOmslagsbildHitta
1.
  • Abel, I, et al. (författare)
  • Overview of the JET results with the ITER-like wall
  • 2013
  • Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:10, s. 104002-
  • Tidskriftsartikel (refereegranskat)abstract
    • Following the completion in May 2011 of the shutdown for the installation of the beryllium wall and the tungsten divertor, the first set of JET campaigns have addressed the investigation of the retention properties and the development of operational scenarios with the new plasma-facing materials. The large reduction in the carbon content (more than a factor ten) led to a much lower Z(eff) (1.2-1.4) during L- and H-mode plasmas, and radiation during the burn-through phase of the plasma initiation with the consequence that breakdown failures are almost absent. Gas balance experiments have shown that the fuel retention rate with the new wall is substantially reduced with respect to the C wall. The re-establishment of the baseline H-mode and hybrid scenarios compatible with the new wall has required an optimization of the control of metallic impurity sources and heat loads. Stable type-I ELMy H-mode regimes with H-98,H-y2 close to 1 and beta(N) similar to 1.6 have been achieved using gas injection. ELM frequency is a key factor for the control of the metallic impurity accumulation. Pedestal temperatures tend to be lower with the new wall, leading to reduced confinement, but nitrogen seeding restores high pedestal temperatures and confinement. Compared with the carbon wall, major disruptions with the new wall show a lower radiated power and a slower current quench. The higher heat loads on Be wall plasma-facing components due to lower radiation made the routine use of massive gas injection for disruption mitigation essential.
  •  
2.
  • Romanelli, F, et al. (författare)
  • Overview of the JET results
  • 2011
  • Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 51:9
  • Tidskriftsartikel (refereegranskat)abstract
    • Since the last IAEA Conference JET has been in operation for one year with a programmatic focus on the qualification of ITER operating scenarios, the consolidation of ITER design choices and preparation for plasma operation with the ITER-like wall presently being installed in JET. Good progress has been achieved, including stationary ELMy H-mode operation at 4.5 MA. The high confinement hybrid scenario has been extended to high triangularity, lower ρ*and to pulse lengths comparable to the resistive time. The steady-state scenario has also been extended to lower ρ*and ν*and optimized to simultaneously achieve, under stationary conditions, ITER-like values of all other relevant normalized parameters. A dedicated helium campaign has allowed key aspects of plasma control and H-mode operation for the ITER non-activated phase to be evaluated. Effective sawtooth control by fast ions has been demonstrated with3He minority ICRH, a scenario with negligible minority current drive. Edge localized mode (ELM) control studies using external n = 1 and n = 2 perturbation fields have found a resonance effect in ELM frequency for specific q95values. Complete ELM suppression has, however, not been observed, even with an edge Chirikov parameter larger than 1. Pellet ELM pacing has been demonstrated and the minimum pellet size needed to trigger an ELM has been estimated. For both natural and mitigated ELMs a broadening of the divertor ELM-wetted area with increasing ELM size has been found. In disruption studies with massive gas injection up to 50% of the thermal energy could be radiated before, and 20% during, the thermal quench. Halo currents could be reduced by 60% and, using argon/deuterium and neon/deuterium gas mixtures, runaway electron generation could be avoided. Most objectives of the ITER-like ICRH antenna have been demonstrated; matching with closely packed straps, ELM resilience, scattering matrix arc detection and operation at high power density (6.2 MW m-2) and antenna strap voltages (42 kV). Coupling measurements are in very good agreement with TOPICA modelling. © 2011 IAEA, Vienna.
  •  
3.
  • Meyer, H., et al. (författare)
  • Overview of physics results from MAST towards ITER/DEMO and the MAST Upgrade
  • 2013
  • Ingår i: Nuclear Fusion. - : IOP Publishing. - 0029-5515 .- 1741-4326. ; 53:10, s. 104008-
  • Tidskriftsartikel (refereegranskat)abstract
    • New diagnostic, modelling and plant capability on the Mega Ampere Spherical Tokamak (MAST) have delivered important results in key areas for ITER/DEMO and the upcoming MAST Upgrade, a step towards future ST devices on the path to fusion currently under procurement. Micro-stability analysis of the pedestal highlights the potential roles of micro-tearing modes and kinetic ballooning modes for the pedestal formation. Mitigation of edge localized modes (ELM) using resonant magnetic perturbation has been demonstrated for toroidal mode numbers n = 3, 4, 6 with an ELM frequency increase by up to a factor of 9, compatible with pellet fuelling. The peak heat flux of mitigated and natural ELMs follows the same linear trend with ELM energy loss and the first ELM-resolved T-i measurements in the divertor region are shown. Measurements of flow shear and turbulence dynamics during L-H transitions show filaments erupting from the plasma edge whilst the full flow shear is still present. Off-axis neutral beam injection helps to strongly reduce the redistribution of fast-ions due to fishbone modes when compared to on-axis injection. Low-k ion-scale turbulence has been measured in L-mode and compared to global gyro-kinetic simulations. A statistical analysis of principal turbulence time scales shows them to be of comparable magnitude and reasonably correlated with turbulence decorrelation time. T-e inside the island of a neoclassical tearing mode allow the analysis of the island evolution without assuming specific models for the heat flux. Other results include the discrepancy of the current profile evolution during the current ramp-up with solutions of the poloidal field diffusion equation, studies of the anomalous Doppler resonance compressional Alfven eigenmodes, disruption mitigation studies and modelling of the new divertor design for MAST Upgrade. The novel 3D electron Bernstein synthetic imaging shows promising first data sensitive to the edge current profile and flows.
  •  
4.
  •  
5.
  • Horacek, J., et al. (författare)
  • Lignin transformations to chemicals
  • 2013
  • Ingår i: Proceedings of the 1st INTERNATIONAL CONFERENCE ON CHEMICAL TECHNOLOGY. - : Czech Chemical Society. - 9788086238555 ; , s. 382-388
  • Konferensbidrag (refereegranskat)abstract
    • Sodium lignosulfonate was decomposed at 320 degrees C and 130 bar over various catalysts. Zeolites Beta modified with 0.5 % of Pt showed important effect of Al content in the support on product yields. Alumina-supported NiO was also found as active in lignosulfonate decomposition to guaiacol: Moreover, the contact time of substrate with the active centers was identified as the key reaction factor in lignosulfonate decomposition. Model compounds of lignin decomposition were hydrodeoxygenated at 180 degrees C and 5 MPa over Pt modified zeolites Beta. Dealuminated zeolite was found as more active in phenol conversion than zeolite with similar Si/Al ratio obtained by direct synthesis. Reactivity of cresols increased in order m>o>p for catalyst with higher Si/Al ratio, decrease of Al content resulted in lower reactivity of cresols and change of reactivity order of isomers to o>m>p.
  •  
6.
  • ter Haar, C. Cato, et al. (författare)
  • Difference vectors to describe dynamics of the ST segment and the ventricular gradient in acute ischemia
  • 2013
  • Ingår i: Journal of Electrocardiology. - : Elsevier BV. - 1532-8430 .- 0022-0736. ; 46:4, s. 302-311
  • Tidskriftsartikel (refereegranskat)abstract
    • Background: The ECG is important in the diagnosis and triage of the acute coronary syndrome (ACS), especially in the hyperacute phase, the "golden hours," during which myocardial salvage possibilities are largest. An important triaging decision to be taken is whether or not a patient requires primary PCI, for which, as mentioned in the guidelines, the presence of an ST elevation (STE) pattern in the ECG is a major criterion. However, preexisting non-zero ST amplitudes (diagnostic, but also non-diagnostic) can obscure or even preclude this diagnosis. Methods: In this study, we investigated the potential diagnostic possibilities of ischemia detection by means of changes in the ST vector, Delta ST, and changes in the VG (QRST integral) vector, Delta VG. We studied the vectorcardiograms (VCGs) synthesized of the ECGs of 84 patients who underwent elective PTCA. Mean +/- SD balloon occlusion times were 260 +/- 76 s. The ECG ischemia diagnosis (ST elevation, STE, or non-ST-elevation, NSTE), magnitudes and orientations of the ST and VG vectors, and the differences Delta ST and Delta VG with the baseline ECG were measured after 3 min of balloon occlusion. Results: Planar angles between the Delta ST and Delta VG vectors were 14.9 +/- 14.0 degrees. Linear regression of Delta VG on Delta ST yielded Delta VG = 324. Delta ST (r = 0.85; P < 0.0001, Delta ST in mV). We adopted Delta ST > 0.05 mV, and the corresponding Delta VG > 16.2 mV.ms as ischemia thresholds. The classical criteria characterized the ECGs of 46/84 (55%) patients after 3 min of occlusion as STE ECGs. Combined application of the Delta ST and Delta VG criteria identified 73/84 (87%) of the patients as ischemic. Conclusion: Differential diagnosis by Delta ST and Delta VG (requiring an earlier made non-ischemic baseline ECG) could dramatically improve ECG guided detection of patients who urgently require catheter intervention. (C) 2013 Elsevier Inc. All rights reserved.
  •  
Skapa referenser, mejla, bekava och länka
  • Resultat 1-6 av 6

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy