| 1. |
- Gao, Yu, et al.
(författare)
-
Analysis of gas chromatography/mass spectrometry data for catalytic lignin depolymerization using positive matrix factorization
- 2018
-
Ingår i: Green Chemistry. - : Royal Society of Chemistry (RSC). - 1463-9262 .- 1463-9270. ; 20:18, s. 4366-4377
-
Tidskriftsartikel (refereegranskat)abstract
- Various catalytic technologies are being developed to efficiently convert lignin into renewable chemicals. However, due to its complexity, catalytic lignin depolymerization often generates a wide and complex distribution of product compounds. Gas chromatography/mass spectrometry (GC-MS) is a common analytical technique to profile the compounds that comprise lignin depolymerization products. GC-MS is applied not only to determine the product composition, but also to develop an understanding of the catalytic reaction pathways and of the relationships among catalyst structure, reaction conditions, and the resulting compounds generated. Although a very useful tool, the analysis of lignin depolymerization products with GC-MS is limited by the quality and scope of the available mass spectral libraries and the ability to correlate changes in GC-MS chromatograms to changes in lignin structure, catalyst structure, and other reaction conditions. In this study, the GC-MS data of the depolymerization products generated from organosolv hybrid poplar lignin using a copper-doped porous metal oxide catalyst and a methanol/dimethyl carbonate co-solvent was analyzed by applying a factor analysis technique, positive matrix factorization (PMF). Several different solutions for the PMF model were explored. A 13-factor solution sufficiently explains the chemical changes occurring to lignin depolymerization products as a function of lignin, reaction time, catalyst, and solvent. Overall, seven factors were found to represent aromatic compounds, while one factor was defined by aliphatic compounds.
|
|
| 2. |
|
|
| 3. |
|
|
| 4. |
- Liu, Cong, et al.
(författare)
-
Effects of nanocrystalline cellulose on the micro-creep properties of phenol formaldehyde resin
- 2018
-
Ingår i: Materials Research Express. - : Institute of Physics Publishing. - 2053-1591. ; 5:12
-
Tidskriftsartikel (refereegranskat)abstract
- The use of nanocrystalline cellulose (NCC) has become increasingly prevalent in recent years, with limited studies on the the time-dependent characteristics of wood-adhesive composite reinforced by it. To analyze the viscoelasticity of control phenol formaldehyde (PF) resin and wood-resin composites added with three types of NCC, the micro-creep properties of control phenol formaldehyde (PF) resin and PF resin with cellulose nanofibrils (CNF), cellulose microfibrils (CMF), and cellulose nanocrystals (CNC) were investigated by nanoindentation (NI). The sample creep curves proved that adding CNC, CMF, and CNF into the PF resin remarkably impacted the creep properties of the wood-resin sample interface. The cured resin sample had the lowest strength and the most deformation, and the pure wood sample performed slightly better. Among the three NCC-added wood-resin samples, the CNF-added wood-resin sample has the least deformation in the same load and the least permanent deformation after unloading followed by CMF-added and CNC-added wood-resin samples. In the derivative of creep curve function, the depth tendency of CNC-added and CNF-added wood-resin samples showed a gently increasing slope with time in contrast to CMF-added ones. Furthermore, scanning probe microscopy (SPM) images supported that PF resin had filled up the pores of the wood microstructures and strengthened the wood-resin sample in the company of NCC, which was then able to carry the load.
|
|
