| 1. |
- Stern, Natalia, et al.
(författare)
-
Subchronic toxicity of Baltic herring oil and its fractions in the rat II : Clinical observations and toxicological parameters.
- 2002
-
Ingår i: Pharmacology and Toxicology. - : Wiley. - 0901-9928 .- 1600-0773. ; 91:5, s. 232-244
-
Tidskriftsartikel (refereegranskat)abstract
- This study aimed to increase the knowledge about the toxicity of fish-derived organohalogen pollutants in mammals. The strategy chosen was to separate organohalogen pollutants derived from Baltic herring (Clupea harengus) fillet, in order to obtain fractions with differing proportions of identified and unidentified halogenated pollutants, and to perform a subchronic toxicity study in rats, essentially according to the OECD guidelines, at three dose levels. Nordic Sea lodda (Mallotus villosus) oil, with low levels of persistent organohalogen pollutants, was used as an additional control diet. The toxicological examination showed that exposure to Baltic herring oil and its fractions at dose levels corresponding to a human intake in the range of 1.6 to 34.4 kg Baltic herring per week resulted in minimal effects. The spectrum of effects was similar to that, which is observed after low-level exposure to pollutants such as chlorinated dibenzo-p-dioxins and dibenzofurans (CDD/F) and chlorinated biphenyls, despite the fact that these contaminants contribute to a minor part of the extractable organically bound chlorine (EOCl). The study confirmed previous findings that induction of hepatic ethoxyresorufin deethylase (EROD) activity takes place at daily intake levels 0.15 ng fish-derived CDD/F-TEQs/kg body weight. The study also demonstrated that hepatic vitamin A reduction takes place at somewhat higher daily exposure levels, i.e. 0.16–0.30 ng fish-derived CDD/F-TEQs/kg body weight. Halogenated fatty acids, the major component of EOCl, could not be linked to any of the measured effects. From a risk management point of view, the study provides important new information of effect levels for Ah-receptor mediated responses following low level exposure to organohalogen compounds from a matrix relevant for human exposure.
|
|
| 2. |
- Aldin, Niklas, et al.
(författare)
-
Business development with electronic commerce : refinement and repositioning
- 2004
-
Ingår i: Business Process Management Journal. - : Emerald. - 1463-7154 .- 1758-4116. ; 10:1, s. 44-62
-
Tidskriftsartikel (refereegranskat)abstract
- Electronic commerce enables business development for marketing channel intermediaries and strengthens their existing operations and strategic management. This research shows that electronic commerce provides stepwise business development refinement and repositioning in the form of process change and increased customer service. Based on marketing and logistics literature, a business development model with three developmental phases is proposed in this paper. The findings are based on the electronic commerce development of three intermediaries providing industrial products and services in the northern European market. Refinement is achieved through a focus on activities for internal efficiency, and through changing processes for increased integration, shorter time and lower costs. Repositioning involves extended focus on service improvements, image and customer tailored services. It is found that electronic commerce has not radically reshaped and developed the role of marketing channel intermediaries. Instead, it has strengthened existing business. Future electronic commerce efforts need to be viewed in a business wide development context, including structural change and reaching new segments or markets, to utilise fully the development potential of electronic commerce.
|
|
| 3. |
- Andgart, Niklas, et al.
(författare)
-
PSD-constrained PAR reduction for DMT/OFDM
- 2004
-
Ingår i: Eurasip Journal on Applied Signal Processing. - 1110-8657. ; 2004:10
-
Tidskriftsartikel (refereegranskat)abstract
- Common to all DMT/OFDM systems is a large peak-to-average ratio (PAR), which can lead to low power efficiency and nonlinear distortion. Tone reservation uses unused or reserved tones to design a peak-canceling signal to lower the PAR of a transmit block. In DMT ADSL systems, the power allocated to these tones may be limited due to crosstalk issues with many users in one twisted pair bundle. This PSD limitation not only limits PAR reduction ability, but also makes the optimization problem more challenging to solve. Extending the recently proposed active set tone reservation method, we develop an efficient algorithm with performance close to the optimal solution.
|
|
| 4. |
- Berlind, Torun, 1965-, et al.
(författare)
-
Microstructure, mechanical properties, and wetting behaviorof Si-C-N thin films grown by reactive magnetron sputtering
- 2001
-
Ingår i: Surface and Coatings Technology. - : Elsevier. - 0257-8972. ; 141:2-3, s. 145-155
-
Tidskriftsartikel (refereegranskat)abstract
- Silicon–carbon–nitride (Si–C–N) thin films were deposited by reactive magnetron co-sputtering of C and Si targets in a mixed Ar/N2 discharge. Films were grown to a thickness of more than 0.5 μm on graphite and Si(001) substrates held at a negative floating potential of −35 V, and substrate temperature between 100 and 700°C. The total pressure was constant at 0.4 Pa (3 mtorr), and the nitrogen fraction in the gas mixture was varied between 0 and 100%. As-deposited films were analyzed with respect to composition, state of chemical bonding, microstructure, mechanical properties, and wetting behavior by Rutherford backscattering spectroscopy (RBS), energy dispersive spectroscopy (EDS), X-ray photoelectron spectrometry (XPS), transmission electron microscopy (TEM), scanning electron microscopy (SEM), nanoindentation and contact angle measurements, respectively. Depending on the deposition condition, ternary SixCyNz films within the composition range 1≤x≤34 at.%, 34≤y≤81 at.%, and 16.5≤z≤42 at.% were prepared with a textured, amorphous-to-graphite-like microstructure. For Si–C–N films with low Si content, C---C, C---N and Si---C bonds were present. At higher Si content, N preferentially bonds to Si, while less C---N bonds were observed. Films containing more than 12 at.% of Si contained widely dispersed crystallites, 2–20 nm in diameter. Incorporation of a few at.% Si resulted in a dramatic reduction of the film surface energy compared to pure CN films. The measured contact angles using distilled water and glycerol liquids were for some films comparable with those on a polytetrafluoroethylene (PTFE), Teflon® surface. The hardness of Si–C–N films could be varied over the range 9–28 GPa.
|
|
| 5. |
- Borälv, Erik, et al.
(författare)
-
A Design Case: Interactive Sports Content Broadcasting
- 2004
-
Rapport (populärvet., debatt m.m.)abstract
- Digital television is a new and interesting platform for developing multimedia services. The MELISA platform aims at cross-media broadcasting over digital television and 3G mobile networks. The platform provides presentation of interactive video content, advertisement and gaming. The devices targeted by these services are Set-Top Boxes and Portable Digital Assistants. A new service, in combination with technology that does not yet allow for very rich interaction, requires careful and inventive design of the user interfaces. The key to gaining consumer acceptance of interactive TV is ease of use. In this paper we present the system architecture briefly and discuss issues related to user interface design, considering both the type of media content and hardware platforms. We reflect on the design process used and its suitability as we as designers have experienced it.
|
|
| 6. |
|
|
| 7. |
|
|
| 8. |
|
|
| 9. |
|
|
| 10. |
- Hellgren, Niklas, et al.
(författare)
-
Fullerene-like B C N thin films a computational andexperimental study
- 2004
-
Ingår i: Materials Science and Engineering B. - : Elsevier. ; 113:3, s. 242-247
-
Tidskriftsartikel (refereegranskat)abstract
- Ab initio calculations show that the energy cost for incorporating lattice defects such as pentagons and heptagons is significantly reduced for BCN compared to BN, thus promoting bending of basal planes in these compounds. Boron–carbon–nitride (Bsingle bondCsingle bondN) thin films with a fullerene-like (FL) microstructure were then deposited by dual cathode magnetron sputtering from C and B4C targets. Up to 1 μm thick films were grown at a total gas pressure of 3 mTorr (0.4 Pa) in varying Ar/N2 ratios, and substrate temperatures between 225 and 350 °C. Compositional and microstructural studies were performed using RBS, SEM and HREM, respectively. Depending on the deposition condition, ternary BxCyNz films with fullerene-like microstructure could be prepared in agreement with the calculations within the composition range 0 ≤ x ≤ 53, 15 ≤ y ≤ 62, and 24 ≤ z ≤ 50 at.%. Fullerene-like structures also tend to form at lower temperatures in the case of BCN compared to CN. Nanoindentation measurements show that all BxCyNz films exhibited a highly elastic response independent of elemental composition. In addition, the calculations suggest a driving force for C and BN phase separation.
|
|
