| 1. |
- Bladh, Henrik, et al.
(author)
-
Influence of Soot Particle Aggregation on Time-Resolved Laser-Induced Incandescence Signals
- 2011
-
In: Applied Physics B. - : Springer Science and Business Media LLC. - 0946-2171 .- 1432-0649. ; 104:2, s. 331-341
-
Journal article (peer-reviewed)abstract
- Laser-induced incandescence (LII) is a versatile technique for quantitative soot measurements in flames and exhausts. When used for particle sizing, the time-resolved signals are analysed as these will show a decay rate dependent on the soot particle size. Such an analysis has traditionally been based on the assumption of isolated primary particles. However, soot particles in flames and exhausts are usually aggregated, which implies loss of surface area, less heat conduction and hence errors in estimated particle sizes. In this work we present an experimental investigation aiming to quantify this effect. A soot generator, based on a propane diffusion flame, was used to produce a stable soot stream and the soot was characterised by transmission electron microscopy (TEM), a scanning mobility particle sizer (SMPS) and an aerosol particle mass analyzer coupled in series after a differential mobility analyzer (DMA-APM). Despite nearly identical primary particle size distributions for three selected operating conditions, LII measurements resulted in signal decays with significant differences in decay rate. However, the three cases were found to have quite different levels of aggregation as shown both in TEM images and mobility size distributions, and the results agree qualitatively with the expected effect of diminished heat conduction from aggregated particles resulting in longer LII signal decays. In an attempt to explain the differences quantitatively, the LII signal dependence on aggregation was modelled using a heat and mass transfer model for LII given the primary particle and aggregate size distribution data as input. Quantitative agreement was not reached and reasons for this discrepancy are discussed.
|
|
| 2. |
- Bladh, Henrik, et al.
(author)
-
Optical soot characterization using two-color laser-induced incandescence (2C-LII) in the soot growth region of a premixed flat flame
- 2011
-
In: Proceedings of the Combustion Institute. - : Elsevier BV. - 1540-7489. ; 33, s. 641-648
-
Journal article (peer-reviewed)abstract
- The soot growth region of a premixed one-dimensional ethylene/air flame has been investigated using two-color laser-induced incandescence (2C-LII) with focus on optical soot properties. From the 2C-LII technique, primary soot particle sizes were deduced together with the temperature from pyrometry of the laser-heated particles, while the gas temperatures were obtained from pure rotational CARS nitrogen thermometry. Soot particle sizes were also measured from thermophoretically sampled soot particles analyzed by transmission electron microscopy (TEM), and the results showed growing isolated primary soot particles up to a height of 10 mm, after which strong soot aggregation occurred and the increase in soot primary particle size ceased. The measured data was used in the evaluation of the soot absorption function, E(m), and a strong increase by a factor of two was observed from the lowest heights to the highest for assumed constant values of soot density and specific heat at all heights. By comparing the 2C-LII particle sizes with the sizes obtained from TEM, differences were observed. Part of the explanation is that the 2C-LII evaluation did not take aggregation into account, but it is additionally speculated that the thermal accommodation coefficient decreases with height above burner. These results are interesting in view of morphological and composition changes of the soot during the growth process and have implications for the use of 2C-LII as a soot diagnostic technique. (C) 2010 The Combustion Institute. Published by Elsevier Inc. All rights reserved.
|
|
| 3. |
- Johnsson, Jonathan, et al.
(author)
-
Influence of soot aggregate structure on particle sizing using laser-induced incandescence: importance of bridging between primary particles
- 2013
-
In: Applied Physics B. - : Springer Science and Business Media LLC. - 0946-2171 .- 1432-0649. ; 112:3, s. 321-332
-
Journal article (peer-reviewed)abstract
- Soot aggregates formed in combustion processes are often described as clusters of carbonaceous particles in random fractal structures. For theoretical studies of the physical properties of such aggregates, they have often been modelled as spherical primary particles in point contact. However, transmission electron microscopy (TEM) images show that the primary particles are more connected than in a single point; there is a certain amount of bridging between the primary particles. Particle sizing using the diagnostic technique laser-induced incandescence (LII) is crucially dependent on the heat conduction rate from the aggregate to the ambient gas, which depends on the amount of bridging. In this work, aggregates with bridging are modelled using overlapping spheres, and it is shown how such aggregates can be built to fulfil specific fractal parameters. Aggregates with and without bridging are constructed numerically, and it is investigated how the bridging influences the heat conduction rate in the free-molecular regime. The calculated heat conduction rates are then used in an LII model to show how LII particle sizing is influenced by different amounts of bridging. For realistic amounts of bridging (), the primary particle diameters were overestimated by up to 9 % if bridging was not taken into account.
|
|
| 4. |
- Oliveira, M. H. de Andrade, et al.
(author)
-
Soot, PAH and OH measurements in vaporized liquid fuel flames
- 2013
-
In: Fuel. - : Elsevier BV. - 1873-7153 .- 0016-2361. ; 112, s. 145-152
-
Journal article (peer-reviewed)abstract
- Qualitative measurements of both OH and polycyclic aromatic hydrocarbons (PAH) as well as quantitative data of soot volume fraction f(v) have been obtained in vaporized liquid fuels, with the main goal of providing experimental data for combustion models and numerical mechanism validation. Measurements were carried out in a laminar coflow burner which was designed, built and integrated with an evaporation system, enabling the combustion of vaporized liquid fuels at pressures of up to 3.0 MPa to be studied. The fuels n-heptane and n-decane, referred to in the literature as being important surrogate fuels, were selected for measurements at atmospheric pressure that were carried out in the experimental setup described, making use of a combination of the Laser Induced Fluorescence (LIF) and Laser Induced Incandescence (LII) techniques. Partially premixed flames of n-heptane and n-decane showed similar combustion characteristics in the range of 1.9 < phi < 3.7. For both of the fuels the threshold for soot formation was found to be at about phi similar to 3.3. Comparison of the LIF and LII measurements for the n-heptane flames within the range of 3.7 <= phi <= 8.5 indicated the maximum PAH LIF signal to be a good predictor of f(vmax) obtained from LII. Excitation at 266 nm using delayed detection was found to result in the signals obtained showing a close linear correlation with the soot volume fraction obtained from LII when prompt detection at 1064 nm excitation was used. Neither the effects of any additional photo-chemical processes making use of high laser power at 266 nm nor the effects of particle size on the delayed gate times appeared to be of any significance for the flame conditions studied here. (C) 2013 Elsevier Ltd. All rights reserved.
|
|
| 5. |
- Olofsson, Nils-Erik, et al.
(author)
-
Are Sooting Premixed Porous-Plug Burner Flames One-Dimensional? A Laser-Based Experimental Investigation
- 2013
-
In: Combustion Science and Technology. - : Informa UK Limited. - 1563-521X .- 0010-2202. ; 185:2, s. 293-309
-
Journal article (peer-reviewed)abstract
- The one-dimensional character of sooting premixed porous-plug (McKenna) burner flames has been examined, motivated by recent investigations where the one-dimensionality has been questioned. The examination employs laser diagnostic techniques to measure different characteristics: temperature using rotational coherent anti-Stokes Raman spectroscopy (CARS) and soot properties using laser-induced incandescence and elastic light scattering. Special attention has been paid to the influence of an outer shroud gas flow of either nitrogen or air. The nitrogen shroud gas leads to flame cooling at the outer edge, whereas the air shroud results in heating through the oxidation of CO/H-2/soot. This generally results in a more inhomogeneous spatial particle size profile for the nitrogen shroud flame, with smaller particle sizes at the flame edge. The present results emphasize the need to characterize burner and operating conditions accurately, and also, regarding parameters that at first glance seem less relevant, such as the shroud gas, to provide useful data for comparison between laboratories.
|
|
| 6. |
- Olofsson, Nils-Erik, et al.
(author)
-
Soot sublimation studies in a premixed flat flame using laser-induced incandescence (LII) and elastic light scattering (ELS)
- 2013
-
In: Applied Physics B. - : Springer Science and Business Media LLC. - 0946-2171 .- 1432-0649. ; 112:3, s. 333-342
-
Journal article (peer-reviewed)abstract
- Laser-induced incandescence (LII) as a diagnostic technique is based on rapid heating of soot particles to temperatures of several thousand Kelvin and subsequent detection of the thermal radiation from the laser-heated particles. At such high temperatures, soot sublimation effects must be considered when estimating uncertainties in LII measurements. In this work we have investigated the use of various laser fluences in LII using a Nd:YAG laser at 1,064 nm. Using another Nd:YAG laser at 532 nm, the elastic light scattering (ELS) signal from soot particles heated by the 1,064-nm laser was monitored. This approach makes it possible to determine at which fluence of the LII laser soot sublimation starts to become visible as a decrease in the ELS signal. By performing the measurements at various heights in a premixed sooting flat ethylene/air flame, the fluence threshold above which the ELS signal decreased was found to be higher at the lower flame heights corresponding to younger, smaller and less aggregated particles. The results from this work indicate that the different fluence thresholds for sublimation may be explained by a lower absorption function E(m) for the younger soot particles.
|
|
| 7. |
- Bergquist, Henrik, 1969, et al.
(author)
-
Combined stent insertion and single high-dose brachytherapy in patients with advanced esophageal cancer - results of a prospective safety study.
- 2011
-
In: Diseases of the esophagus. - : Oxford University Press (OUP). - 1442-2050 .- 1120-8694. ; Early View
-
Journal article (peer-reviewed)abstract
- Previous randomized studies comparing the two commonly used palliative treatments for incurable esophageal cancer, i.e. stent insertion and intraluminal brachytherapy, have revealed the pros and cons of each therapy. While stent treatment offers a more prompt effect, brachytherapy results in more long-lasting relief of dysphagia and a better health-related quality of life (HRQL) in those living longer. This prospective pilot study aimed to explore the feasibility and safety of combining these two regimes and incorporating a single high dose of internal radiation. Patients with newly diagnosed, incurable cancer of the esophagus and dysphagia were eligible for inclusion, and stent insertion followed by a single dose (12Gy) of brachytherapy was performed as a two-stage procedure. Clinical parameters including HRQL and adverse events were registered at inclusion, and 1, 2, 3, 6, and 12 months later. Twelve patients (nine males) with a median age of 73 years (range 54-85) were included. Stent insertion followed by a single dose of brachytherapy was successfully performed in all but one patient who was treated with stent only. Relief of dysphagia was achieved in the majority of cases (10/11, P < 0.05), but HRQL did not improve except for dysphagia-related items. Only minor adverse events, including chest pain, reflux, and restenosis, were reported. The median survival time after inclusion was 6.6 months. Our conclusion is that the combination of stent insertion and single high-dose brachytherapy seems to be a feasible and safe palliative regime in patients with advanced esophageal cancer. Randomized trials comparing the efficacy of this strategy to stent insertion or brachytherapy alone are warranted.
|
|
| 8. |
|
|
| 9. |
|
|
| 10. |
- Cromvik, Julia, 1980, et al.
(author)
-
Eosinophils in the blood of hematopoietic stem cell transplanted patients are activated and have different molecular marker profiles in acute and chronic graft-versus-host disease.
- 2014
-
In: Immunity, inflammation and disease. - : Wiley. - 2050-4527. ; 2:2, s. 99-113
-
Journal article (peer-reviewed)abstract
- While increased numbers of eosinophils may be detected in patients with graft-versus-host disease (GVHD) following hematopoietic stem cell transplantation, it is not known if eosinophils play a role in GVHD. The aims of this study were to determine: whether eosinophils are activated during GVHD; whether the patterns of activation are similar in acute and chronic GVHD; and the ways in which systemic corticosteroids affect eosinophils. Transplanted patients (n = 35) were investigated for eosinophil numbers and the expression levels of 16 eosinophilic cell surface markers using flow cytometry; all the eosinophil data were analyzed by the multivariate method OPLS-DA. Different patterns of molecule expression were observed on the eosinophils from patients with acute, chronic, and no GVHD, respectively. The molecules that provided the best discrimination between acute and chronic GVHD were: the activation marker CD9; adhesion molecules CD11c and CD18; chemokine receptor CCR3; and prostaglandin receptor CRTH2. Patients with acute or chronic GVHD who received systemic corticosteroid treatment showed down-regulation of the cell surface markers on their eosinophils, whereas corticosteroid treatment had no effect on the eosinophil phenotype in the patients without GVHD. In summary, eosinophils are activated in GVHD, display different activation profiles in acute and chronic GVHD, and are highly responsive to systemic corticosteroids.
|
|
