| 1. |
- Kaushik, K., et al.
(författare)
-
Experimental demonstration of multi-hop RF energy transfer
- 2013
-
Ingår i: 2013 IEEE 24th Annual International Symposium on Personal, Indoor, and Mobile Radio Communications (PIMRC). - : Institute of Electrical and Electronics Engineers (IEEE). - 9781467362351 ; , s. 538-542
-
Konferensbidrag (refereegranskat)abstract
- Batteries of field nodes in a wireless sensor network pose an upper limit on the network lifetime. Energy harvesting and harvesting aware medium access control protocols have the potential to provide uninterrupted network operation, as they aim to replenish the lost energy so that energy neutral operation of the energy harvesting nodes can be achieved. To further improve the energy harvesting process, there is a need for novel schemes so that maximum energy is harvested in a minimum possible time. Multi-hop radio frequency (RF) energy transfer is one such solution that addresses these needs. With the optimal placement of energy relay nodes, multi-hop RF energy transfer can save energy of the source as well as time for the harvesting process. In this work we experimentally demonstrate multi-hop RF energy transfer, wherein two-hop energy transfer is shown to achieve significant energy and time savings with respect to the single-hop case. It is also shown that the gain obtained can be translated to energy transfer range extension.
|
|
| 2. |
- Mishra, Deepak, 1990-, et al.
(författare)
-
Implementation of multi-path energy routing
- 2014
-
Ingår i: 2014 IEEE 25th Annual International Symposium on Personal, Indoor, and Mobile Radio Communication (PIMRC). - : Institute of Electrical and Electronics Engineers (IEEE). - 9781479949120 ; , s. 1834-1839
-
Konferensbidrag (refereegranskat)abstract
- Harvesting energy from radio frequency (RF) waves brings us closer to achieving the goal for perpetual operation of a wireless sensor network (WSN) by replenishing the batteries of the sensor nodes. However, due to restrictions on the maximum transmitted power, path loss, and receiver sensitivity, only a small amount of energy can be harvested. While a dedicated RF source alleviates the problem to some extent, novel techniques are required to boost the energy transfer efficiency of the source. In this paper, we provide the first experimental demonstration of multi-path energy routing (MPER) for the case of a sparsely distributed WSNs and show its improved performance over direct energy transfer (DET). In addition, we extend this concept to the case of densely distributed WSNs and experimentally demonstrate and compare the gains obtained by 2- and 3-path energy routing over DET. Our experimental results show that significant energy gains can be achieved in a dense network deployment even when the node to be charged is partially blocked by the neighboring nodes.
|
|
| 3. |
|
|
| 4. |
|
|
| 5. |
|
|
| 6. |
|
|
| 7. |
|
|
| 8. |
- Aad, G., et al.
(författare)
-
Commissioning of the ATLAS Muon Spectrometer with cosmic rays
- 2010
-
Ingår i: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044 .- 1434-6052. ; 70:3, s. 875-916
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS detector at the Large Hadron Collider has collected several hundred million cosmic ray events during 2008 and 2009. These data were used to commission the Muon Spectrometer and to study the performance of the trigger and tracking chambers, their alignment, the detector control system, the data acquisition and the analysis programs. We present the performance in the relevant parameters that determine the quality of the muon measurement. We discuss the single element efficiency, resolution and noise rates, the calibration method of the detector response and of the alignment system, the track reconstruction efficiency and the momentum measurement. The results show that the detector is close to the design performance and that the Muon Spectrometer is ready to detect muons produced in high energy proton-proton collisions.
|
|
| 9. |
|
|
| 10. |
|
|
