| 1. |
- Lantz, Andreas, et al.
(författare)
-
Investigation of ozone stimulated combustion in the SGT-800 burner at atmospheric conditions
- 2016
-
Ingår i: Combustion, Fuels and Emissions. - 9780791849750 ; 4A-2016
-
Konferensbidrag (refereegranskat)abstract
- The effect of ozone (O3) in a turbulent, swirl-stabilized natural gas/air flame was experimentally investigated at atmospheric pressure conditions using planar laser-induced fluorescence imaging of formaldehyde (CH2O PLIF) and dynamic pressure monitoring. The experiment was performed using a dry low emission (DLE) gas turbine burner used in both SGT-700 and SGT-800 industrial gas turbines from Siemens. The burner was mounted in an atmospheric combustion test rig at Siemens with optical access in the flame region. CH2O PLIF imaging was carried out for four different seeding gas compositions and seeding injection channel configurations. Two seeding injection-channels were located around the burner tip while the other two were located along the center axis of the burner at different distances upstream the burner outlet. Four different seeding gas compositions were used: nitrogen (N2), oxygen (O2) and two ozone/oxygen (O3/O2) mixtures with different O3 concentration. The results show that the O3 clearly affects the combustion chemistry. The natural gas/air mixture is preheated before combustion which is shown to kick-start the cold combustion chemistry where O3 is highly involved. The CH2O PLIF signal increases with O3 seeded into the flame which indicates that the pre-combustion activity increases and that the cold chemistry starts to develop further upstream. The small increase of the pressure drop over the burner shows that the flame moves upstream when O3 is seeded into the flame, which confirms the increase in pre-combustion activity.
|
|
| 2. |
- Larsson, Kajsa, et al.
(författare)
-
Quantitative Imaging of Ozone Vapor Using Photofragmentation Laser-Induced Fluorescence (LIF)
- 2017
-
Ingår i: Applied Spectroscopy. - : SAGE Publications. - 0003-7028 .- 1943-3530. ; 71:7, s. 1578-1585
-
Tidskriftsartikel (refereegranskat)abstract
- In the present work, the spectral properties of gaseous ozone (O3) have been investigated aiming to perform quantitative concentration imaging of ozone by using a single laser pulse at 248 nm from a KrF excimer laser. The O3 molecule is first photodissociated by the laser pulse into two fragments, O and O2. Then the same laser pulse electronically excites the O2 fragment, which is vibrationally hot, whereupon fluorescence is emitted. The fluorescence intensity is found to be proportional to the concentration of ozone. Both emission and absorption characteristics have been investigated, as well as how the laser fluence affects the fluorescence signal. Quantitative ozone imaging data have been achieved based on calibration measurements in known mixtures of O3. In addition, a simultaneous study of the emission intensity captured by an intensified charge-coupled device (ICCD) camera and a spectrograph has been performed. The results show that any signal contribution not stemming from ozone is negligible compared to the strong fluorescence induced by the O2 fragment, thus proving interference-free ozone imaging. The single-shot detection limit has been estimated to ∼400 ppm. The authors believe that the presented technique offers a valuable tool applicable in various research fields, such as plasma sterilization, water and soil remediation, and plasma-assisted combustion.
|
|
| 3. |
|
|
| 4. |
- Abou Nada, Fahd Jouda, et al.
(författare)
-
Remote temperature sensing on and beneath atmospheric plasma sprayed thermal barrier coatings using thermographic phosphors
- 2016
-
Ingår i: Surface & Coatings Technology. - : Elsevier BV. - 0257-8972 .- 1879-3347. ; 302, s. 359-367
-
Tidskriftsartikel (refereegranskat)abstract
- Investigations on remote temperature sensing of yttria stabilized zirconia (YSZ) thermal barrier coatings (TBCs) at the surface and at the bond-coat/top-coat interface were carried out. Using Y2O3:Eu thermographic phosphor as an embedded temperature sensing layer, sub-surface temperature probing through 300 μm of atmospheric plasma sprayed YSZ is demonstrated. The Y2O3:Eu thermographic phosphor displays a temperature sensitivity ranging between 400 °C up to a maximum of 900 °C when utilizing the luminescence originating from the 611 nm emission band. Dysprosium stabilized zirconia (10 wt.% DySZ), a TBC material, is also investigated and established as a temperature sensor from 400 °C up to a temperature of 1000 °C using both the intensity decay time and emission intensity ratio methods. In addition, the luminescence of presumed optically inactive YSZ materials was spectroscopically investigated in terms of optical interferences caused by impurities. A validation temperature probing measurement through 300 μm of YSZ top-coat was successfully performed in a SGT-800 Siemens burner running at six different operating conditions in an atmospheric combustion rig.
|
|
| 5. |
- Ahmed, Niaz, et al.
(författare)
-
Consensus statements and recommendations from the ESO-Karolinska Stroke Update Conference, Stockholm 11-13 November 2018.
- 2019
-
Ingår i: European Stroke Journal. - : SAGE Publications. - 2396-9873 .- 2396-9881. ; 4:4, s. 307-317
-
Tidskriftsartikel (refereegranskat)abstract
- The purpose of the European Stroke Organisation-Karolinska Stroke Update Conference is to provide updates on recent stroke therapy research and to give an opportunity for the participants to discuss how these results may be implemented into clinical routine. The meeting started 22 years ago as Karolinska Stroke Update, but since 2014 it is a joint conference with European Stroke Organisation. Importantly, it provides a platform for discussion on the European Stroke Organisation guidelines process and on recommendations to the European Stroke Organisation guidelines committee on specific topics. By this, it adds a direct influence from stroke professionals otherwise not involved in committees and work groups on the guideline procedure. The discussions at the conference may also inspire new guidelines when motivated. The topics raised at the meeting are selected by the scientific programme committee mainly based on recent important scientific publications. This year's European Stroke Organisation-Karolinska Stroke Update Meeting was held in Stockholm on 11-13 November 2018. There were 11 scientific sessions discussed in the meeting including two short sessions. Each session except the short sessions produced a consensus statement (Full version with background, issues, conclusions and references are published as web-material and at www.eso-karolinska.org and http://eso-stroke.org) and recommendations which were prepared by a writing committee consisting of session chair(s), scientific secretary and speakers. These statements were presented to the 250 participants of the meeting. In the open meeting, general participants commented on the consensus statement and recommendations and the final document were adjusted based on the discussion from the general participants Recommendations (grade of evidence) were graded according to the 1998 Karolinska Stroke Update meeting with regard to the strength of evidence. Grade A Evidence: Strong support from randomised controlled trials and statistical reviews (at least one randomised controlled trial plus one statistical review). Grade B Evidence: Support from randomised controlled trials and statistical reviews (one randomised controlled trial or one statistical review). Grade C Evidence: No reasonable support from randomised controlled trials, recommendations based on small randomised and/or non-randomised controlled trials evidence.
|
|
| 6. |
- Al-Adili, Ali, et al.
(författare)
-
Analysis of prompt fission neutrons in U-235(nth,f) and fission fragment distributions for the thermal neutron induced fission of U-234
- 2016
-
Ingår i: CNR*15 - 5th International Workshop On Compound-Nuclear Reactions And Related Topics. - : EDP Sciences.
-
Konferensbidrag (refereegranskat)abstract
- This paper presents the ongoing analysis of two fission experiments. Both projects are part of the collaboration between the nuclear reactions group at Uppsala and the JRC-IRMM. The first experiment deals with the prompt fission neutron multiplicity in the thermal neutron induced fission of U-235(n,f). The second, on the fission fragment properties in the thermal fission of U-234(n,f). The prompt fission neutron multiplicity has been measured at the JRC-IRMM using two liquid scintillators in coincidence with an ionization chamber. The first experimental campaign focused on U-235(nth,f) whereas a second experimental campaign is foreseen later for the same reaction at 5.5 MeV. The goal is to investigate how the so-called saw-tooth shape changes as a function of fragment mass and excitation energy. Some harsh experimental conditions were experienced due to the large radiation background. The solution to this will be discussed along with preliminary results. In addition, the analysis of thermal neutron induced fission of U-234(n,f) will be discussed. Currently analysis of data is ongoing, originally taken at the ILL reactor. The experiment is of particular interest since no measurement exist of the mass and energy distributions for this system at thermal energies. One main problem encountered during analysis was the huge background of U-235(nth, f). Despite the negligible isotopic traces in the sample, the cross section difference is enormous. Solution to this parasitic background will be highlighted.
|
|
| 7. |
- Al-Adili, Ali, et al.
(författare)
-
Fission Activities of the Nuclear Reactions Group in Uppsala
- 2015
-
Ingår i: Scientific Workshop on Nuclear Fission Dynamics and the Emission of Prompt Neutrons and Gamma Rays, THEORY-3. - : Elsevier BV. ; , s. 145-149
-
Konferensbidrag (refereegranskat)abstract
- This paper highlights some of the main activities related to fission of the nuclear reactions group at Uppsala University. The group is involved for instance in fission yield experiments at the IGISOL facility, cross-section measurements at the NFS facility, as well as fission dynamics studies at the IRMM JRC-EC. Moreover, work is ongoing on the Total Monte Carlo (TMC) methodology and on including the GEF fission code into the TALYS nuclear reaction code. Selected results from these projects are discussed.
|
|
| 8. |
- Al-Adili, Ali, et al.
(författare)
-
Neutron-multiplicity experiments for enhanced fission modelling
- 2017
-
Ingår i: EPJ Web of Conferences. - : EDP Sciences. - 9782759890200
-
Konferensbidrag (refereegranskat)abstract
- The nuclear de-excitation process of fission fragments (FF) provides fundamental information for the understanding of nuclear fission and nuclear structure in neutron-rich isotopes. The variation of the prompt-neutron multiplicity, ν(A), as a function of the incident neutron energy (En) is one of many open questions. It leads to significantly different treatments in various fission models and implies that experimental data are analyzed based on contradicting assumptions. One critical question is whether the additional excitation energy (Eexc) is manifested through an increase of ν(A) for all fragments or for the heavy ones only. A systematic investigation of ν(A) as a function of En has been initiated. Correlations between prompt-fission neutrons and fission fragments are obtained by using liquid scintillators in conjunction with a Frisch-grid ionization chamber. The proof-of-principle has been achieved on the reaction 235U(nth,f) at the Van De Graff (VdG) accelerator of the JRC-Geel using a fully digital data acquisition system. Neutrons from 252Cf(sf) were measured separately to quantify the neutron-scattering component due to surrounding shielding material and to determine the intrinsic detector efficiency. Prelimenary results on ν(A) and spectrum in correlation with FF properties are presented.
|
|
| 9. |
- Al-Adili, Ali, et al.
(författare)
-
Simulations of the fission-product stopping efficiency in IGISOL
- 2015
-
Ingår i: European Physical Journal A. - : Springer Science and Business Media LLC. - 1434-6001 .- 1434-601X. ; 51:59, s. 1-7
-
Tidskriftsartikel (refereegranskat)abstract
- At the Jyväskylä Ion Guide Isotope Separator On-Line (IGISOL) facility, independent fission yields are measured employing the Penning-trap technique. Fission products are produced, e.g. by impinging protons on a uranium target, and are stopped in a gas-filled chamber. The products are collected by a flow of He gas and guided through a mass separator to a Penning trap, where their masses are identified. This work investigates how fission-product properties, such as mass and energy, affect the ion stopping efficiency in the gas cell. The study was performed using the Geant4 toolkit and the SRIM code. The main results show a nearly mass-independent ion stopping with regard to the wide spread of ion masses and energies, with a proper choice of uranium target thickness. Although small variations were observed, in the order of 5%, the results are within the systematic uncertainties of the simulations. To optimize the stopping efficiency while reducing the systematic errors, different experimental parameters were varied; for instance material thicknesses and He gas pressure. Different parameters influence the mass dependence and could alter the mass dependencies in the ion stopping efficiency.
|
|
| 10. |
- Al-Adili, Ali, et al.
(författare)
-
Studying fission neutrons with 2E-2v and 2E
- 2018
-
Ingår i: SCIENTIFIC WORKSHOP ON NUCLEAR FISSION DYNAMICS AND THE EMISSION OF PROMPT NEUTRONS AND GAMMA RAYS (THEORY-4). - : EDP Sciences. - 9782759890316
-
Konferensbidrag (refereegranskat)abstract
- This work aims at measuring prompt-fission neutrons at different excitation energies of the nucleus. Two independent techniques, the 2E-2v and the 2E techniques, are used to map the characteristics of the mass-dependent prompt fission neutron multiplicity, 7(A), when the excitation energy is increased. The VERDI 2E-2v spectrometer is being developed at JRC-GEEL. The Fission Fragment (FF) energies are measured using two arrays of 16 silicon (Si) detectors each. The FFs velocities are obtained by time-of-flight, measured between micro-channel plates (MCP) and Si detectors. With MCPs placed on both sides of the fission source, VERDI allows for independent timing measurements for both fragments. Cf-252(sf) was measured and the present results revealed particular features of the 2E-2v technique. Dedicated simulations were also performed using the GEF code to study important aspects of the 2E-2v technique. Our simulations show that prompt neutron emission has a non-negligible impact on the deduced fragment data and affects also the shape of 17(A). Geometrical constraints lead to a total-kinetic energy-dependent detection efficiency. The 2E technique utilizes an ionization chamber together with two liquid scintillator detectors. Two measurements have been performed, one of Cf-252(sf) and another one of thermal-neutron induced fission in U-235(n,f). Results from Cf-252(sf) are reported here.
|
|
