| 1. |
|
|
| 2. |
|
|
| 3. |
- Bostrom, Cecilia, et al.
(författare)
-
Electric resonance-rectifier circuit for renewable energy conversion
- 2012
-
Ingår i: Applied Physics Letters. - : AIP Publishing. - 0003-6951 .- 1077-3118. ; 100:4, s. 043511-
-
Tidskriftsartikel (refereegranskat)abstract
- Variable speed generators are used more frequently for converting the energy from renewable energy sources to electric energy. The power production form a variable speed generator is dependent on the electrical damping of the generator. In this paper, a resonance circuit connected to a direct driven linear generator used for wave energy utilization is investigated. At resonance, the electrical damping in the generator increases which results in an increased power production. The results show that resonance can be achieved with the suggested circuit.
|
|
| 4. |
- Boström, Cecilia, 1982-
(författare)
-
Electrical Systems for Wave Energy Conversion
- 2011
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- Wave energy is a renewable energy source with a large potential to contribute to the world's electricity production. There exist several technologies on how to convert the energy in the ocean waves into electric energy. The wave energy converter (WEC) presented in this thesis is based on a linear synchronous generator. The generator is placed on the seabed and driven by a point absorbing buoy on the ocean surface. Instead of having one large unit, several smaller units are interconnected to increase the total installed power.To convert and interconnect the power from the generators, marine substations are used. The marine substations are placed on the seabed and convert the fluctuating AC from the generators into an AC suitable for grid connection.The work presented in the thesis focuses on the first steps in the electric energy conversion, converting the voltage out from the generators into DC, which have an impact on the WEC's ability to absorb and produce power. The purpose has been to investigate how the generator will operate when it is subjected to different load cases and to obtain guidelines on how future systems could be improved. Offshore experiments and simulations have been done on full scale generators connected to four different loads, i.e. one linear resistive load and three different non-linear loads representing different cases for grid connected WECs.The results show that the power can be controlled and optimized by choosing a suitable system for the WEC. It is not obvious which kind of system is the most preferable, since there are many different parameters that have an impact on the system performance, such as the size of the buoy, how the generator is designed, the number of WECs, the highest allowed complexity of the system, costs and so on. Therefore, the design of the electrical system should preferably be carried out in parallel with the design of the WEC in order to achieve an efficient system.
|
|
| 5. |
- Boström, Cecilia, et al.
(författare)
-
Experimental Results From an Offshore Wave Energy Converter
- 2010
-
Ingår i: Journal of Offshore Mechanics and Arctic Engineering-Transactions of The Asme. - : ASME International. - 0892-7219 .- 1528-896X. ; 132:4, s. 041103-
-
Tidskriftsartikel (refereegranskat)abstract
- An offshore wave energy converter (WEC) was successfully launched at the Swedish west coast in the middle of March 2006. The WEC is based on a permanent magnet linear generator located on the sea floor driven by a point absorber. A measuring station has been installed on a nearby island where all measurements and experiments on the WEC have been carried out. The output voltage from the generator fluctuates both in amplitude and frequency and must therefore be converted to enable grid connection. In order to study the voltage conversion, the measuring station was fitted with a six pulse diode rectifier and a capacitive filter during the autumn of 2006. The object of this paper is to present a detailed description of the Lysekil research site. Special attention will be given to the power absorption by the generator when it is connected to a nonlinear load.
|
|
| 6. |
- Boström, Cecilia, et al.
(författare)
-
Linear Generator Connected to a Resonance-Rectifier Circuit
- 2013
-
Ingår i: IEEE Journal of Oceanic Engineering. - 0364-9059 .- 1558-1691. ; 38:2, s. 255-262
-
Tidskriftsartikel (refereegranskat)abstract
- This paper describes a linear direct driven generator used for wave energy utilization. The generator is placed on the seabed and connected to a buoy on the ocean surface. Due to the reciprocating motion of the translator, an electrical conversion system is needed between the wave energy converter (WEC) and the grid. Depending on how the conversion system is designed, the generator will be subjected to different loads. A novel conversion system is presented in this paper where the voltage from the WEC is rectified in a resonance circuit. Both simulations and experiments are performed on the circuit. The results from the simulations show that a higher power absorption and power production can be achieved with the resonance circuit compared to a WEC connected to a passive rectifier. A WEC, L9, developed by Uppsala University (Uppsala, Sweden) was used in the experiment. Significantly higher power absorption was obtained for L9 compared to power data from the first installed WEC, L1, at the Lysekil research site.
|
|
| 7. |
- Boström, Cecilia, et al.
(författare)
-
Operation analysis of a wave energy converter under different load conditions
- 2011
-
Ingår i: IET Renewable Power Generation. - : Institution of Engineering and Technology (IET). - 1752-1416 .- 1752-1424. ; 5:3, s. 245-250
-
Tidskriftsartikel (refereegranskat)abstract
- This study analyses the electrical behaviour of a direct-driven linear generator under different load conditions. The studied generator is used in a wave energy converter (WEC) that converts the energy in ocean waves into electric energy. To enable a grid connection of a WEC, the voltage must be converted, and thereby, the generator will be subjected to a non-linear damping. Depending on how the conversion system is designed, the damping will be different. In the case studied, the voltage is first rectified, and on the dc-side of the rectifier the voltage is kept constant by controlling the power through a converter. In order to study the electrical behaviour of the generator in this operation mode, a simulation model was made in MATLAB Simulink. The model of the generator was verified with experimental data from an offshore operating WEC. The result of the study shows that the model of the generator agrees with the real generator and can be used for analysing the electrical behaviour of the WEC. Moreover, the results show that the operation with a non-linear load will be different compared to a linear load case.
|
|
| 8. |
- Boström, Cecilia, et al.
(författare)
-
Temperature measurements in a linear generator and marine substation for wave power
- 2010
-
Ingår i: PROCEEDINGS OF THE ASME 29TH INTERNATIONAL CONFERENCE ON OCEAN, OFFSHORE AND ARCTIC ENGINEERING 2010, VOL 3. - 9780791849118 ; , s. 545-552
-
Konferensbidrag (refereegranskat)abstract
- This paper analyzes temperature measurements acquired in offshore operation of a wave energy converter array. The three directly driven wave energy converters have linear generators and are connected to a marine substation placed on the seabed. The highly irregular individual linear generator voltages are rectified and added on a common DC-link and inverted to 50 Hz to facilitate future grid-connection. The electrical power is transmitted to shore and converted to heat in a measuring station. First results of temperature measurements on substation components and on the stator of one of the linear generators are presented from operation in linear and in non-linear damping. Results indicate that there might be some convective heat transport in the substation vessel. If high power levels are extracted from the waves, this has to be considered when placing components in the substation vessel to avoid heating from neighbouring components. The results also indicate that the temperature increase in the linear generator stator is very small. Failure due to excessive heating of the stator winding PVC cable insulation is unlikely to occur even in very energetic sea states. Should this conclusion be incorrect, the thermal conductivity between the stator and the hull of the WEC could be enhanced. Another suggested alteration would be to lower the resistive losses by reducing the linear generator current density.
|
|
| 9. |
- Boström, Cecilia, et al.
(författare)
-
Temperature measurements in a linear generator and marine substation for wave power
- 2012
-
Ingår i: Journal of Offshore Mechanics and Arctic Engineering-Transactions of The Asme. - : ASME International. - 0892-7219 .- 1528-896X. ; 134:2, s. 021901-
-
Tidskriftsartikel (refereegranskat)abstract
- This paper analyzes temperature measurements acquired in the offshore operation of a wave energy converter array. The three directly driven wave energy converters have linear generators and are connected to a marine substation placed on the seabed. The highly irregular individual linear generator voltages are rectified and added on a common dc-link and inverted to 50 Hz to facilitate future grid-connection. The electrical power is transmitted to shore and converted to heat in a measuring station. The first results of temperature measurements on substation components and on the stator of one of the linear generators are presented based on operation in linear and in nonlinear damping. The results indicate that there might be some convective heat transfer in the substation vessel. If high power levels are extracted from the waves, this has to be considered when placing components in the substation vessel in order to avoid heating from neighboring components. The results also indicate that the temperature increase in the linear generator stator is very small. Failure due to excessive heating of the stator winding polyvinyl chloride cable insulation is unlikely to occur even in very energetic sea states. Should this conclusion be incorrect, the thermal conductivity between the stator and the hull of the wave energy converter could be enhanced. Another suggested alteration is to lower the resistive losses by reducing the linear generator current density.
|
|
| 10. |
|
|
