SwePub
Sök i SwePub databas

  Utökad sökning

Träfflista för sökning "WFRF:(Leitao M) srt2:(2010-2014)"

Sökning: WFRF:(Leitao M) > (2010-2014)

  • Resultat 1-9 av 9
Sortera/gruppera träfflistan
   
NumreringReferensOmslagsbildHitta
1.
  • Falcao, B. P., et al. (författare)
  • Structural and optical characterization of Mg-doped GaAs nanowires grown on GaAs and Si substrates
  • 2013
  • Ingår i: Applied Physics Reviews. - : AIP Publishing. - 1931-9401. ; 114:18
  • Tidskriftsartikel (refereegranskat)abstract
    • We report an investigation on the morphological, structural, and optical properties of large size wurtzite GaAs nanowires, low doped with Mg, grown on GaAs(111) B and Si(111) substrates. A higher density of vertical nanowires was observed when grown upon GaAs(111) B. Very thin zinc-blende segments are observed along the axis of the nanowires with a slightly higher linear density being found on the nanowires grown on Si(111). Low temperature cathodoluminescence and photoluminescence measurements reveal an emission in the range 1.40-1.52 eV related with the spatial localization of the charge carriers at the interfaces of the two crystalline phases. Mg related emission is evidenced by cathodoluminescence performed on the GaAs epilayer. However, no direct evidence for a Mg related emission is found for the nanowires. The excitation power dependency on both peak energy and intensity of the photoluminescence gives a clear evidence for the type II nature of the radiative transitions. From the temperature dependence on the photoluminescence intensity, non-radiative de-excitation channels with different activation energies were found. The fact that the estimated energies for the escape of the electron are higher in the nanowires grown on Si(111) suggests the presence of wider zinc-blende segments. (C) 2013 AIP Publishing LLC.
  •  
2.
  • Bianchi Piccinini, Giulio, 1982, et al. (författare)
  • Driver's behavioral adaptation to Adaptive Cruise Control (ACC): The case of speed and time headway
  • 2014
  • Ingår i: Journal of Safety Research. - : Elsevier BV. - 0022-4375. ; 49, s. 77-84
  • Tidskriftsartikel (refereegranskat)abstract
    • Problem: The Adaptive Cruise Control is an Advanced Driver Assistance System (ADAS) that allows maintaining given headway and speed, according to settings pre-defined by the users. Despite the potential benefits associated to the utilization of ACC, previous studies warned against negative behavioral adaptations that might occur while driving with the system activated. Unfortunately, up to now, there are no unanimous results about the effects induced by the usage of ACC on speed and time headway to the vehicle in front. Also, few studies were performed including actual users of ACC among the subjects. Objectives: This research aimed to investigate the effect of the experience gained with ACC on speed and time headway for a group of users of the system. In addition, it explored the impact of ACC usage on speed and time headway for ACC users and regular drivers. Method: A matched sample driving simulator study was planned as a two-way (2 x 2) repeated measures mixed design, with the experience with ACC as between-subjects factor and the driving condition (with ACC and manually) as within-subjects factor. Results: The results show that the usage of ACC brought a small but not significant reduction of speed and, especially, the maintenance of safer time headways, being the latter result greater for ACC users, probably as a consequence of their experience in using the system. Summary: The usage of ACC did not cause any negative behavioral adaptations to the system regarding speed and time headway. Practical applications: Based on this research work, the Adaptive Cruise Control showed the potential to improve road safety for what concerns the speed and the time headway maintained by the drivers. The speed of the surrounding traffic and the minimum time headway settable through the ACC seem to have an important effect on the road safety improvement achievable with the system. (C) 2014 National Safety Council and Elsevier Ltd. All rights reserved.
  •  
3.
  • Fernandes, P. A., et al. (författare)
  • Thermodynamic pathway for the formation of SnSe and SnSe2 polycrystalline thin films by selenization of metal precursors
  • 2013
  • Ingår i: CrystEngComm. - : Royal Society of Chemistry (RSC). - 1466-8033 .- 1466-8033. ; 15:47, s. 10278-10286
  • Tidskriftsartikel (refereegranskat)abstract
    • In this work, tin selenide thin films (SnSex) were grown on soda lime glass substrates by selenization of dc magnetron sputtered Sn metallic precursors. Selenization was performed at maximum temperatures in the range 300 degrees C to 570 degrees C. The thickness and the composition of the films were analysed using step profilometry and energy dispersive spectroscopy, respectively. The films were structurally and optically investigated by X-ray diffraction, Raman spectroscopy and optical transmittance and reflectance measurements. X-Ray diffraction patterns suggest that for temperatures between 300 degrees C and 470 degrees C, the films are composed of the hexagonal-SnSe2 phase. By increasing the temperature, the films selenized at maximum temperatures of 530 degrees C and 570 degrees C show orthorhombic-SnSe as the dominant phase with a preferential crystal orientation along the (400) crystallographic plane. Raman scattering analysis allowed the assignment of peaks at 119 cm(-1) and 185 cm(-1) to the hexagonal-SnSe2 phase and those at 108 cm(-1), 130 cm(-1) and 150 cm(-1) to the orthorhombic-SnSe phase. All samples presented traces of condensed amorphous Se with a characteristic Raman peak located at 255 cm(-1). From optical measurements, the estimated band gap energies for hexagonal-SnSe2 were close to 0.9 eV and 1.7 eV for indirect forbidden and direct transitions, respectively. The samples with the dominant orthorhombic-SnSe phase presented estimated band gap energies of 0.95 eV and 1.15 eV for indirect allowed and direct allowed transitions, respectively.
  •  
4.
  •  
5.
  •  
6.
  • Sousa, M. G., et al. (författare)
  • Cu2ZnSnS4 absorber layers obtained through sulphurization of metallic precursors : Graphite box versus sulphur flux
  • 2013
  • Ingår i: Thin Solid Films. - : Elsevier BV. - 0040-6090 .- 1879-2731. ; 535, s. 27-30
  • Tidskriftsartikel (refereegranskat)abstract
    • In this work we employed a hybrid method, combining RF-magnetron sputtering with evaporation, for the deposition of tailor made metallic precursors, with varying number of Zn/Sn/Cu (ZTC) periods and compared two approaches to sulphurization. Two series of samples with 1x, 2x and 4x ZTC periods have been prepared. One series of precursors was sulphurized in a tubular furnace directly exposed to a sulphur vapour and N-2 + 5% H-2 flux at a pressure of 5.0 x 10(+4) Pa. A second series of identical precursors was sulphurized in the same furnace but inside a graphite box where sulphur pellets have been evaporated again in the presence of N-2 + 5% H-2 and at the same pressure as for the sulphur flux experiments. The morphological and chemical analyses revealed a small grain structure but good average composition for all three films sulphurized in the graphite box. As for the three films sulphurized in sulphur flux grain growth was seen with the increase of the number of ZTC periods whilst, in terms of composition, they were slightly Zn poor. The films' crystal structure showed that Cu2ZnSnS4 is the dominant phase. However, in the case of the sulphur flux films SnS2 was also detected. Photoluminescence spectroscopy studies showed an asymmetric broad band emission which occurs in the range of 1-1.5 eV. Clearly the radiative recombination efficiency is higher in the series of samples sulphurized in sulphur flux. We have found that sulphurization in sulphur flux leads to better film morphology than when the process is carried out in a graphite box in similar thermodynamic conditions. Solar cells have been prepared and characterized showing a correlation between improved film morphology and cell performance. The best cells achieved an efficiency of 2.4%.
  •  
7.
  • Byass, Peter, et al. (författare)
  • Strengthening standardised interpretation of verbal autopsy data : the new InterVA-4 tool
  • 2012
  • Ingår i: Global Health Action. - Järfälla, Sweden : CoAction Publishing. - 1654-9716 .- 1654-9880. ; 5
  • Tidskriftsartikel (refereegranskat)abstract
    • Background: Verbal autopsy (VA) is the only available approach for determining the cause of many deaths, where routine certification is not in place. Therefore, it is important to use standards and methods for VA that maximise efficiency, consistency and comparability. The World Health Organization (WHO) has led the development of the 2012 WHO VA instrument as a new standard, intended both as a research tool and for routine registration of deaths. Objective: A new public-domain probabilistic model for interpreting VA data, InterVA-4, is described, which builds on previous versions and is aligned with the 2012 WHO VA instrument. Design: The new model has been designed to use the VA input indicators defined in the 2012 WHO VA instrument and to deliver causes of death compatible with the International Classification of Diseases version 10 (ICD-10) categorised into 62 groups as defined in the 2012 WHO VA instrument. In addition, known shortcomings of previous InterVA models have been addressed in this revision, as well as integrating other work on maternal and perinatal deaths. Results: The InterVA-4 model is presented here to facilitate its widespread use and to enable further field evaluation to take place. Results from a demonstration dataset from Agincourt, South Africa, show continuity of interpretation between InterVA-3 and InterVA-4, as well as differences reflecting specific issues addressed in the design and development of InterVA-4. Conclusions: InterVA-4 is made freely available as a new standard model for interpreting VA data into causes of death. It can be used for determining cause of death both in research settings and for routine registration. Further validation opportunities will be explored. These developments in cause of death registration are likely to substantially increase the global coverage of cause-specific mortality data.
  •  
8.
  • Leitao, Mario M, Jr, et al. (författare)
  • Gynecologic Cancer InterGroup (GCIG) consensus review for vulvovaginal melanomas.
  • 2014
  • Ingår i: International Journal of Gynecological Cancer. - : Lippincott Williams & Wilkins. - 1048-891X .- 1525-1438. ; 24:9, s. S117-S122
  • Forskningsöversikt (refereegranskat)abstract
    • Vulvovaginal melanomas are rare tumors that account for a small fraction of all vulvovaginal cancers. Biologically, they seem to be similar to mucosal and acral melanomas of other sites. There are limited data specific to vulvovaginal melanomas, especially regarding systemic therapies. Most treatment decisions are based on extrapolation from data regarding cutaneous melanomas of other sites. It is reasonable to follow already established guidelines from other professional groups and societies. Outcomes tend to be worse compared with cutaneous melanomas likely because of the later presentation and physical biological characteristics of these tumors.
  •  
9.
  • Salomé, Pedro M. P., et al. (författare)
  • Secondary crystalline phases identification in CuZnSnSe thin films : contributions from Raman scattering and photoluminescence
  • 2014
  • Ingår i: Journal of Materials Science. - : Springer Science and Business Media LLC. - 0022-2461 .- 1573-4803. ; 49:21, s. 7425-7436
  • Tidskriftsartikel (refereegranskat)abstract
    • In this work, we present the Raman peak positions of the quaternary pure selenide compound CuZnSnSe (CZTSe) and related secondary phases that were grown and studied under the same conditions. A vast discussion about the position of the X-ray diffraction (XRD) reflections of these compounds is presented. It is known that by using XRD only, CZTSe can be identified but nothing can be said about the presence of some secondary phases. Thin films of CZTSe, CuSnSe, ZnSe, SnSe, SnSe, MoSe and a-Se were grown, which allowed their investigation by Raman spectroscopy (RS). Here we present all the Raman spectra of these phases and discuss the similarities with the spectra of CZTSe. The effective analysis depth for the common back-scattering geometry commonly used in RS measurements, as well as the laser penetration depth for photoluminescence (PL) were estimated for different wavelength values. The observed asymmetric PL band on a CZTSe film is compatible with the presence of CZTSe single-phase and is discussed in the scope of the fluctuating potentials' model. The estimated bandgap energy is close to the values obtained from absorption measurements. In general, the phase identification of CZTSe benefits from the contributions of RS and PL along with the XRD discussion.
  •  
Skapa referenser, mejla, bekava och länka
  • Resultat 1-9 av 9

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy